Directed Electronics 28623T - Manual

Directed Electronics 28623T

Directed Electronics 28623T – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
Page: / 20

Table of Contents:

  • Page 2 – PINK; CONTROL HARNESS; ALL WIRES ARE THE SMALLER 18 AWG SIZE; Purple Wire – Hood Pin Switch – Control Harness; WARNING; AVERTISSEMENT
  • Page 3 – OPTIONAL STEPS
  • Page 4 – REQUIRED FINAL STEPS; Trying the Unit Out
  • Page 5 – SPECIAL CASES; How to Use a Relay; PROGRAMMING AN OPTION; To supply +12 volt output
  • Page 6 – System
  • Page 7 – NOTICE to Installers of Remote Vehicle Starters; All vehicles; completely removed from the ignition switch.
  • Page 8 – The company behind this system is Directed Electronics, Inc.; Call; and services that excite and delight our customers.
  • Page 9 – USER TIPS AND NOTES; The Quick Stop Option; limited lifetime consumer warranty; IMPOR
  • Page 10 – Daily Start
  • Page 11 – Trouble-Shooting Guide; Unit won’t respond; on; Initialize
  • Page 12 – Trouble Shooting v4-1
  • Page 14 – Program extended crank, or use tach mode.; Some General Comments:
Loading the manual

v5.3 S28623

1

© 2005 Directed Electronics, Inc.

OEM S

ERIES

Remote Control Car Starter Installation Manual for Model # 28623T

PLEASE READ COMPLETELY BEFORE BEGINNING

Congratulations on your purchase of the AutoCommand

®

OEM Series Remote Car Starter. The AutoCommand

®

OEM Series Remote Car Starter system allows you to start the car

by remote control from the comfort of your home or office in order to cool it down in the summer or heat it up in the winter.

AutoCommand

®

OEM Series is for

automatic transmission/fuel injected vehicles only

. It is an extremely sophisticated system with multiple built-in safety and security

features.

AutoCommand

®

OEM Series Car Starter:

• Will start your car by remote control, and run the heater, defroster, or air

conditioner to warm up or cool down the car.

• Is designed to start the car if it is in park, and only if the hood is closed.

• Will attempt to start the car for up to six seconds, but no longer (to avoid

damage to the starter motor). Should the car not start, or if it stalls after
starting, the remote starter will make two further attempts to start it.

• Will not let the car be driven without the key in the ignition.

• Shuts itself off automatically after 10 or 15 minutes (programmable) if

you forget to come out to your car.

• Will shut off if the brake pedal is pushed, the hood is opened, or the

transmission is shifted out of park - unless the key is in the ignition and
in the “run” position.

• Allows you to remove the key while leaving the car running with the doors

locked for up to 10 or 15 minutes utilizing the Quick Stop™ Option. (See
Separate User Tip Sheet)

• Starts the car automatically whenever the temperature drops below

0

°

F (-18

°

C), or if the battery voltage drops below 11 volts when the

Cold Start™ Option is used. (See Separate User Tip Sheet)

• Has the “Daily Start™” feature which allows the vehicle to be started

at the same time the following day. (See Separate User Tip Sheet)

• Is quality engineered and microprocessor controlled to provide many

years of reliable use.

• Comes with a Limited Lifetime Warranty.

Parts List included with the AutoCommand

®

OEM Series Unit:

6 Power and Ignition wires

Antenna

Remote Starter
Receiver Module

Transmitters

Control Harness
(10 position)

Alchohol

Pad

Ring Terminal

Alcohol Pad

Green 30 A Fuse

On/Off Control Switch

Warning Label

The following parts are included in the plastic bag:

2 Cable Ties

Hood Pin Switch Set

Wiring Diagram

We highly recommend that all connections be soldered for reliability.

Drill with1/4”and 5/16”
drill bits

Electrical Tape

Soldering Iron

Test meter

Pliers

Screwdriver

Wire Cutters/Strippers

Tools required to install the AutoCommand

®

OEM Series Unit:

Yellow Butt Connector

2 Protected by
DesignTech Labels

* For free vehicle specific wire information, consult

our website at www.designtech-intl.com

www.designtech-intl.com • www.directed.com • 800-876-0800

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - PINK; CONTROL HARNESS; ALL WIRES ARE THE SMALLER 18 AWG SIZE; Purple Wire – Hood Pin Switch – Control Harness; WARNING; AVERTISSEMENT

2 v5.3 25523 © 2005 Directed Electronics, Inc. On cars with airbags, you may notice bright yellow tubes or harnessesmarked SRS (Supplemental Restraint System) underneath the steeringcolumn area. DO NOT tamper with these wires in any way, to preventpersonal injury and/or damage to the air bag system....

Page 3 - OPTIONAL STEPS

3 v5.3 25523 © 2005 Directed Electronics, Inc. I. Watch that the LED light remains on as the vehicle is running and turns off whenyou rev the engine RPMs to twice the idle rate. The LED light must go out whenyou rev the engine to about twice the idle rate to confirm correct tach learning. J. Turn th...

Page 4 - REQUIRED FINAL STEPS; Trying the Unit Out

4 v5.3 25523 © 2005 Directed Electronics, Inc. 5 flashes Transmission was shifted into gear. Move the In-Gear switch insidethe receiver module to the OFF position (see diagram below for locationof In-Gear switch inside module case). 6 flashes Low battery voltage, or may be missing an ignition wire w...

Other Directed Electronics Models

All Directed Electronics Other