Dimplex Unvented Water Heater - Manual

Dimplex Unvented Water Heater

Dimplex Unvented Water Heater – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
Page: / 6

Table of Contents:

  • Page 2 – CONTENTS; DIMPLEX WATER HEATER SPECIFIERS GUIDE; Direct Heat Exterior Reference Dimensions
  • Page 3 – Cold water inlet valve assembly; SCx UNVENTED INSTALLATION INSTRUCTIONS; DO NOT ATTEMPT TO VENT THE PRIMARY CIRCUIT THROUGH THE; SCx Performance
  • Page 4 – E N L
  • Page 6 – PROBLEM SOLVING; No water in tap from the; SCx; Unit; Important. In the event of an over heat situation reset all; SPARES; MAINTENANCE; GUIDANCE IN THE EVENT OF A PROBLEM
Loading the manual

DIMPLEX

UNVENTED WATER HEATERS

INSTALLATION MANUAL

Marketing Department, Millbrook House, Grange Drive, Hedge End, Southampton, SO30 2DF. Telephone: 0870 077 7117 Fax: 0870 727 0109

Dimp-15278-SCx_Instructions 31/3/06 9:32 am Page 1

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - CONTENTS; DIMPLEX WATER HEATER SPECIFIERS GUIDE; Direct Heat Exterior Reference Dimensions

2 3 TECHNICAL DATA & INSTALLATION INSTRUCTIONS FOR SCx DIRECT & INDIRECT UNVENTED WATER HEATERS Your water heater is made from Duplex Stainless Steel, which is one of the toughest and best grades of steel currently available. Each unit has been individually tested and inspected to industr y ...

Page 3 - Cold water inlet valve assembly; SCx UNVENTED INSTALLATION INSTRUCTIONS; DO NOT ATTEMPT TO VENT THE PRIMARY CIRCUIT THROUGH THE; SCx Performance

4 5 CONNECTING THE WATER SUPPLY ● Pipework is not supplied ● All pipework should be installed using good plumbing practice. We recommend 22mm mains cold water supply is used. ● Install a Stop Cock Valve before the cold water inlet assembly on the incoming mains water supply so the unit can be isolat...

Page 4 - E N L

6 7 WIRING All electrical wiring should be carried out by a registered electrical contractor and must conform to the latest IEE wiring regulations Do not switch the power on until the unit has been filled with water and all wiring has been earthed, see Fig. 4 and 5. FITTING IMMERSION HEATERS These a...

Other Dimplex Models

All Dimplex Other