Delta 28-195 - Manual

8 ASSEMBLINGSTAND AND FEET 1. Assemble the stand, as shown in Fig. 4, using the 32 M8x20mm Carriage head screws, 3/8" flat washersand M8 hex nuts supplied. The two 10-3/4 long upper braces (A); 13-9/16 long upper braces (B); 15-3/4 longlower braces (C); and 18-5/16 long lower braces (D)should be...

11 STARTING ANDSTOPPING SAW The switch (A) Fig. 17, is located on the front side of theband saw. To turn the saw “ON” move the switch (A) to the up position.To turn the saw “OFF” move the switch (A) to the down position. Fig. 17 Fig. 18 Fig. 19 OPERATING CONTROLS AND ADJUSTMENTS LOCKING SWITCHIN THE...

12 TRACKING THE BLADE For accurate work and maximum blade life, it is important that the blade (A) Fig. 20, be centered on the upper bandsaw wheel. When this adjustment is properly made, the blade will “track” – that is, it will run steady in the same line.To “track” the blade, proceed as follows: 1...

15 Fig. 27 Fig. 28 Fig. 29 Fig. 30 TILTING THE TABLE The table can be tilted 48 degrees to the right andapproximately 3 degrees to the left. To tilt the table,loosen lock handle (A) Fig. 27, tilt the table to the desiredangle and tighten lock handle (A). NOTE: The table lock handle (A) can be reposi...

Fig. 31 Fig. 32 Fig. 33 Fig. 34 ADJUSTING UPPERBLADE GUIDE ASSEMBLY The upper blade guide assembly (A) Fig. 31, shouldalways be set about 1/8 above or as close as possibleto the top surface of the workpiece being cut. Loosenlock knob (B) and rotate adjusting knob (C) to positionthe guide assembly (A...

17 Fig. 35 Fig. 36 Fig. 37 Fig. 38 MINIMUM CUTTING RADIUS Turning radius may vary depending on the type of bladeand amount of set. Each blade, however, depending onits width, can cut continuously without backtracking anycurve having a radius as much or more than the specifiedminimum turning radius o...

19 Fig. 43 An ideal accessory for use with your band saw is the28-196 Rip Fence, shown in Fig. 43. It can be movedalong the table surface by loosening lock lever (A),moving the fence (B) to the desired location andtightening lock lever (A). ACCESSORY 28-196 RIP FENCE OPERATING THE BAND SAW Before st...

20 Two Year Limited Warranty Delta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory whichin normal use has proven to be defective in workmanship or material, provided that the customer returns the productprepaid to a Delta factory servic...

The following are trademarks of PORTER-CABLE·DELTA (Las siguientes son marcas registradas de PORTER-CABLE S.A.): Auto-Set ® , BAMMER ® , B.O.S.S. ® , Builder’s Saw ® , Contractor’s Saw ® , Contractor’s Saw II™, Delta ® , DELTACRAFT ® , DELTAGRAM™, Delta Series 2000™, DURATRONIC™, Emc²™, FLEX ® , Fly...