Delta 23-640 - Manual - manualsarea.com

Page 2 - SAFETY RULES; SAVE THESE INSTRUCTIONS

2 SAFETY RULES Woodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain hazards involved with the operation of the product. Using the machine with respect and caution willconsiderably lessen the possibility of personal injury. How...

Page 3 - ADDITIONAL SAFETY RULES FOR GRINDERS

3 ADDITIONAL SAFETY RULES FOR GRINDERS 1. DO NOT OPERATE your tool until it is completely assembled and installed according to the instructions. 2. IF YOU ARE NOT thoroughly familiar with the oper- ation of grinders, obtain advice from your supervisor,instructor or other qualified person. 3. USE onl...

Page 4 - UNPACKING AND CLEANING

4 UNPACKING AND CLEANING Carefully unpack the tool and all loose items from the carton. Remove the protective coating from all unpainted parts.This coating may be removed with a soft cloth moistened with kerosene (do not use acetone, gasoline, or lacquerthinner for this purpose). WARNING: FOR YOUR O...

Page 5 - HARDWARE ILLUSTRATION; Hardware Illustrated in actual size

5 HARDWARE ILLUSTRATION Hardware Illustrated in actual size Fig. 2 11/16" Flat Washer (2) 3/4" Flat Washer (4) 5/16 - 18 x 1/2" Hex Head Screw (2) 5/16 - 18 x 5/8" Hex Head Screw (2) 3/8" Lock Washer (2) #10 - 24 x 1/2" Round Head Screw(4) 1/4 - 20 Hex Nut (2) #10 - 24 Hex Nu...

Page 6 - ASSEMBLY; ASSEMBLING TOOL RESTS; ASSEMBLING EYE SHIELDS

6 Fig. 3 ASSEMBLY ASSEMBLING TOOL RESTS 1. Assemble the v-grooved tool rest (A) Fig. 3, to the inside of the right wheel guard using two 5/16-18x5/8"hex head screws (B), and 3/4" flat washers (C). 2. Assemble the remaining flat surfaced tool rest (D) Fig. 4, to the inside of the left wheel g...

Page 7 - CONNECTING TOOL TO POWER SOURCE; POWER CONNECTIONS

7 Fig. 7 2. Insert the short end of mounting rod (F) Fig. 7, into hole of frame (B) and fasten in place with 1/4-20x3/4"carriage head screw (G), 5/16” lock washer (H), and 1/4-20 hex nut (I). Fig. 8 3. Assemble long end of eye shield mounting rod (F) Fig. 8, to the side of each wheel guard using...

Page 8 - EXTENSION CORDS; MINIMUM GAUGE EXTENSION CORD

8 EXTENSION CORDS Use proper extension cords. Make sure your extensioncord is in good condition and is a 3-wire extension cordwhich has a 3-prong grounding type plug and a 3-polereceptacle which will accept the tool’s plug. When usingan extension cord, be sure to use one heavy enough tocarry the cur...

Page 10 - PARTS, SERVICE OR WARRANTY ASSISTANCE; Delta Building Trades and Home Shop Machinery

10 PARTS, SERVICE OR WARRANTY ASSISTANCE All Delta Machines and accessories are manufactured to high quality standards and are serviced by a network of Porter-Cable•Delta Factory Service Centers and Delta Authorized Service Stations. To obtain additional information regardingyour Delta quality produ...

Delta 23-640 - Manual

Table of Contents:

Summary

Other Delta Models