Delta 11-950 - Manual - manualsarea.com

Page 2 - SAFETY RULES; SAVE THESE INSTRUCTIONS

2 SAFETY RULES Woodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain hazards involved with the operation of the product. Using the machine with respect and caution willconsiderably lessen the possibility of personal injury. How...

Page 4 - UNPACKING

4 UNPACKING Your drill press is shipped complete in one container. Carefully unpack the drill press and all looseitems from the container. Figure 2 illustrates the drill press and all loose items supplied with themachine. WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE DRILL PRESS TO THE POWER SOUR...

Page 5 - CLEANING; ASSEMBLING THE DRILL PRESS

5 CLEANING Remove the protective coating from the machined surfaces of the drill press and all loose items.This coating may be removed with a soft cloth moistened with kerosene. DO NOT use acetone, gasoline, or lacquer thinner for this purpose. ASSEMBLING THE DRILL PRESS Fig. 4 Fig. 5 Fig. 3 1. Asse...

Page 7 - POWER CONNECTIONS; EXTENSION CORDS; MINIMUM GAUGE EXTENSION CORD

7 Fig. 10 FASTENING DRILL PRESS TO SUPPORTING SURFACE If during operation there is any tendency for the drill press to tip over, slide or walk on the supporting surface, the drillpress base must be secured to the supporting surface with fasteners through the two holes (A) Fig. 10, located in thedril...

Page 8 - MOTOR SPECIFICATIONS; GROUNDING INSTRUCTIONS

8 MOTOR SPECIFICATIONS Your drill press is wired for 110-120 volt, 60 HZ alternating current. Before connecting the machine to the power source,make sure the switch is in the “OFF” position. The motor provides a no-load speed of 1725 RPM. Fig. 13 GROUNDED OUTLET BOX GROUNDING MEANS ADAPTER Fig. 12 G...

Page 10 - TABLE ADJUSTMENTS

10 Fig. 18 Fig. 19 Fig. 20 Fig. 21 LOCKING SWITCH INTHE “OFF” POSITION When the tool is not in use, the switch should be lockedin the “OFF” position to prevent unauthorized use of the tool. To lock the switch in the “OFF” position, grasp the switch toggle (B) and pull it out of the switch, as showni...

Page 11 - ADJUSTING SPINDLE RETURN SPRING

11 Fig. 22 The spindle is automatically returned to its upper mostposition upon release of the handle. It is recommendedthat the handle be allowed to slowly return to the topposition after all holes have been bored in the material.This spring has been properly adjusted at the factory andshould not b...

Page 12 - OPERATION

12 Fig. 25 Fig. 26 DRILLING HOLESTO DEPTH Where a number of holes are to be drilled to exactly thesame depth, the stop nuts on the threaded stop rod areused as follows: 1. Lower the spindle until the pointer (A) Fig. 25, lines up with the mark on the scale (B) you wish the depth tobe. Then thread th...

Delta 11-950 - Manual

Table of Contents:

Summary

Other Delta Models