Page 2 - PRODUCT LABEL
2 Dear Customer, Thank you for having purchased and given your preference to our product. The safety precautions and recommendations reported below are for your own safety and that of others. Theywill also provide a means by which to make full use ofthe features offered by your appliance. Please kee...
Page 3 - FIRST TIME USE THE OVEN
3 FIRST TIME USE THE OVEN It is advised to follow these instructions: ■ Clean the interior of the oven with cloth soaked in water and detergent (neutral) then dry carefully. ■ Fit the wire racks as described at chapter “Use and care”. ■ Insert shelves and tray. ■ Switch on the empty oven on max to e...
Page 4 - IMPORTANT PRECAUTIONS AND RECOMMENDATIONS
4 IMPORTANT PRECAUTIONS AND RECOMMENDATIONS After having unpacked the appliance, check to ensure that it is not damaged.In case of doubt, do not use it and consult your supplier or a professionally qualified techni-cian.Packing elements (i.e. plastic bags, polystyrene foam, nails, packing straps, et...
Page 5 - INSTALLATION; This appliance shall only be serviced by authorized personnel.; ELECTRICAL REQUIREMENTS
5 INSTALLATION CAUTION: ■ This appliance must be installed in accordance with these installationinstructions. ■ This appliance shall only be serviced by authorized personnel. ■ This appliance is to be installed only by an authorised person. ■ Incorrect installation, for which the manufacturer accept...
Page 6 - CLEARANCES; Overhead Clearances; Figure 1
CLEARANCES Installation clearances and protection of combustible surfaces shall comply withthe current local regulations eg. AG 601 (AS 5601) Gas Installations code.Installation shall comply with the dimension in Fig 1 bearing in mind that Overhead Clearances In no case shall the clearances between ...
Page 7 - LEVELLING THE COOKER; Figure 4; FITTING THE ADJUSTABLE FEET; Figure 3
LEVELLING THE COOKER The cooker may be levelled by screwing the lower ends of the feet IN or OUT (fig. 4). Figure 4 Figure 2 FITTING THE ADJUSTABLE FEET The adjustable feet must be fitted to the base of the cooker before use. Rest the rear of the cooker an a piece of the polystyrene packaging exposi...
Page 8 - Figure 6; MOVING THE COOKER
WARNING When moving cooker to its final posi-tion DO NOT DRAG (fig. 7). Lift feet clear of floor (fig. 5). Figure 6 Figure 7 Figure 5 WARNINGWhen raising cooker to upright position always ensure two people carry outthis manoeuvre to prevent damage to the adjustable feet (fig. 5). MOVING THE COOKER W...
Page 9 - Figure 8
Figure 8 ANTI-TILT BRACKET Fixing the anti-tilt bracket: ■ After you have located where the cooker is to be positioned mark, on the wall, the place where the 2 screws of the anti-tilt bracket have to be fitted. Please fol-low the indications given in the drawing below. ■ Make two holes of diameter 8...
Page 10 - Figure 9; BACKGUARD
Figure 9 A C B BACKGUARD Before installing the cooker, assemble the backguard “C” (fig. 9). ■ The backguard “C” can be found packed at the rear of the cooker. ■ Before assembling remove any protective film/adhesive tape. ■ Remove the two spacers “A” and the screw “B” from the rear of the cooktop. ■ ...
Page 11 - Gas connection for
GAS SUPPLY: ■ The connection must be executed by an authorised person according to the rele- vant standards. ■ Before connecting the appliance to the gas main, mount the brass conical adaptor onto the gas inlet pipe, upon which the gasket has been placed (figures 10-11). Conical adaptor and gasket a...
Page 12 - IS NOT SUITABLE
12 1. After connecting the gas supply, check the piping and connections for leaks using a soap and water solution. The presence of bubbles indicates a leak, tighten orreplace connections as appropriate. Warning: Do not use any naked flame to check for leaks. 2. Adjust the test point pressure or supp...
Page 13 - CONVERSION PROCEDURE (to convert to LPG Propane); REPLACING THE INJECTORS; IMPORTANT
13 CONVERSION PROCEDURE (to convert to LPG Propane) REPLACING THE INJECTORS This appliance is suitable for use with Natural gas or Propane gas (check the “gas type” sticker attached to the appliance). A label stating the type of gas used after replacingthe injectors must be attached at the rear of t...
Page 14 - MINIMUM BURNER SETTING ADJUSTMENT
14 MINIMUM BURNER SETTING ADJUSTMENT Check whether the flame spreads to all burner ports when the burner is lit with the gastap set to the minimum position. If some ports do not light, increase the minimum gasrate setting. Check whether the burner remains lit even when the gas tap is turned quickly ...
Page 15 - Natural gas
15 LUBRICATION OF THE GAS TAPS If the gas tap becomes stiff, it is necessary to dismantle it carefully and clean it with petroleumspirit. Specialist high temperature resistant grease should be used to lubricate the tap beforereplacing.The operations must be carried out by an authorised person/servic...
Page 16 - USE and CARE; USING THE OVEN FOR THE FIRST TIME
USE and CARE CAUTION: ■ This appliance must be used only for the task it has explicitly been designed for, that is for domestic cooking of foodstuffs. Any other form of usage is to be con-sidered as inappropriate and therefore dangerous. ■ Do NOT place combustible materials or products on this appli...
Page 17 - GREASE FILTER
Figure 19 Figure 18 GREASE FILTER ■ A special screen is provided at the back of the oven to catch grease particles, mainly when meat is being roasted (fig. 18). ■ When backing pastry etc. this filter should be removed. ■ Always clean the filter after cooking as any solid residues on it might adverse...
Page 18 - GAS HOB; GAS BURNERS
Figure 20 GAS HOB 2 3 2 1 4 18 GAS BURNERS Natural Gas Propane gas MJ/h MJ/h 1. Auxiliary burner (A) 3.6 3.6 2. Semi-rapid burner (SR) 6.3 6.3 3. Fish burner (FB) 10.6 10.6 4. Triple ring burner (TC) 13.3 11.9
Page 19 - LIGHTING GAS BURNERS; FITTED WITH SAFETY VALVE DEVICE AND ELECTRONIC IGNITION
19 Figure 21 LIGHTING GAS BURNERS FITTED WITH SAFETY VALVE DEVICE AND ELECTRONIC IGNITION ■ Check that the electricity is switched on to allow spark igni-tion. ■ Make sure that all controls are turned to zero. ■ The gas flow to the burners is controlled by taps with a safetycutout device. If the bur...
Page 20 - DO NOT
20 CHOICE OF BURNER Burners Pan diameter Auxiliary 12 - 14 cm Semi-rapid 16 - 24 cm Triple ring 26 - 28 cm Fish-burner from 12x30 to 18x40 cm Wok max 36 cm The burner must be chosen according to the diameter of the pans and energyrequired. For optimum efficiency uso a wok or pan no smaller than 230m...
Page 21 - CORRECT USE OF TRIPLE-RING BURNER; WRONG
21 Figure 23 Figure 24 CORRECT USE OF TRIPLE-RING BURNER ■ The flat-bottomed pans are to be placed directly onto the pan-support. ■ To use the WOK, you must place the wok stand in the CORRECT position as shown in Fig. 23-24. WRONG CORRECT
Page 22 - CONTROL PANEL - Controls description; MULTIFUNCTION OVEN; GENERAL FEATURES; Please note
CONTROL PANEL - Controls description 1. Oven switch knob2. Oven thermostat knob3. Front left burner control knob4. Rear left burner control knob5. Fish burner control knob6. Rear right burner control knob7. Front right burner control knob8. Rotisserie control knob9. Electronic programmer Pilot lamp:...
Page 23 - OPERATING PRINCIPLES
FUNCTION SELECTOR KNOB Rotate the knob clockwise to set theoven for one of the following functions. THERMOSTAT KNOB This only sets the cooking temperatureand does not switch the oven on.Rotate clockwise until the requiredtemperature is reached (from 50 to250°C). OPERATING PRINCIPLES Heating and cook...
Page 24 - oven door closed; TRADITIONAL BAKE
DEFROST Only the oven fan comes on. Use with the thermostat knob set to “ ● ” - other tempera- ture have no effect. The food is thawed by ventilation without heating. Ideal for: Quick thawing of frozen foods; one kg requires approximately 1 hour. Thawing times vary according to the quantity and type...
Page 25 - FAN GRILL; closed; MAINTAINING TEMPERATURE AFTER COOKING OR
FAN GRILL Both the grill and the fan come on. Most of the cooking is done by grilling and thenthe hot air circulated around the oven. The oven door should be kept closed . The temperature can be set between 50°C and 175°C maximum. The oven should be preheated for 5 minutes before cooking. For furthe...
Page 26 - GRILLING AND “AU GRATIN”; COOKING ADVICE; STERILIZATION; SIMULTANEOUS COOKING OF DIFFERENT FOODS; ROASTING; Do not grill for longer than 30 minutes at any one time.
GRILLING AND “AU GRATIN” As the hot air completely covers the food to be cooked, grilling may be done withthe food on rack in the oven. The knob should be switched to position . The thermostat should be set to 175 °C and the oven pre-heated. The food should be placed on a rack in the oven for the re...
Page 28 - RECOMMENDED COOKING TEMPERATURE
N.B. For fan ovens reduce the temperature by 10-20°C. For any dish taking one hour orover to cook, reduce the cooking time by 10minutes per hour. * Shelf positions have been counted from the top of the oven to the base.A fan oven creates more even temperaturethroughout, therefore the shelf positions...
Page 29 - Description of the buttons:; Description of the illuminated symbols:; ELECTRONIC PROGRAMMER
29 A U T O Description of the buttons: Timer Cooking time End of cooking time Manual position and cancellation of the inserted cooking program Plus function to increase the number shown on the display Minus function to decrease the number shown on the display or to change thebuzzer frequency Descrip...
Page 30 - AUTO
30 ELECTRONIC CLOCK (fig. 30) The illuminated figures on the clock represent hours and minutes on 24 hour clock.When first connected, or after a power failure, three zeros will flash on the display.To set the time press the button and then the or Please note that changing the hour button deletes any...
Page 31 - ELECTRONIC TIMER; SETTING THE FREQUENCY OF THE AUDIBLE SIGNAL
31 A U T O ELECTRONIC TIMER The timer program consists only of a buzzer which may be set for a maximum periodof 23 hours and 59 minutes. If AUTO is flashing on the panel, push the button. To set the time, push the button and the or until you obtain the desired time in the panel (fig. 32). Having fin...
Page 32 - AUTOMATIC OVEN COOKING
32 AUTOMATIC OVEN COOKING To cook food automatically in the oven, it is necessary to:1. Set the length of the cooking time 2. Set the end of the cooking time 3. Set the temperature and the oven cooking program. These operations are performed as follows: 1. Set the length of the cooking time by pushi...
Page 33 - SEMI - AUTOMATIC COOKING; or
33 SEMI - AUTOMATIC COOKING This function is only used to set the END of the cooking time of the oven. There aretwo ways of setting this function. 1. Set the length of the cooking time by pushing the button and the button to advance, or to go backwards (Fig. 35). This sets the desired “stop” time. o...
Page 34 - Cleaning and Maintenance
GENERAL ADVICE ■ Before you begin cleaning, you must ensure that the appliance is switched off. ■ It is advisable to clean when the appliance is cold and especially when cleaning the enamelled parts. ■ Avoid leaving alkaline or acidic substances (lemon juice, vinegar, etc.) on the surfaces. ■ Avoid ...
Page 36 - BURNERS; CORRECTLY; TRIPLE RING BURNER
BURNERS They can be removed and washed only with soapywater. Detergents can be used but must not beabrasive or corrosive.Do not use abrasive sponges or pads.Do not put in dishwasher.After each cleaning, make sure that theburner-caps, as well as the burners, havebeen well wiped off and CORRECTLY POSI...
Page 37 - not over tighten the screws.
STORAGE COMPARTMENT ■ The storage compartment is accessible through the pivoting panel. Attention: Do not store flammable material in the oven, or the storage com-partment. REMOVAL OF THE INNER GLASS DOOR PANEL ■ The inner glass door panel can easily be removed for cleaning by unscrew- ing the four ...
Page 38 - GRILL HEATING ELEMENT
OVEN TRAY The oven tray must be correctly plac-ing on its wire shelf support (fig. 42)then insert into the side runners (fig.43) Figure 43 Figure 42 REPLACING THE OVEN LIGHT Before any maintenance is started involving electrical parts of theappliance, it must be disconnected from the power supply. T...
Page 40 - Service and Maintenance
If the ignition spark fails to ignite or does not light the gas, check the followingitems before calling our Customer Service Centre to obtain the nearest AuthorisedService Agent: ■ Burner is reassembled and located correctly. ■ Spark electrode and white ceramic are clean and dry. ■ 240 VAC power su...
Page 41 - WIRING DIAGRAM; ELECTRIC DIAGRAM KEY
WIRING DIAGRAM ELECTRIC DIAGRAM KEY F1 Oven switch F2 Rotisserie switch TM Thermostat LF Oven lamp PR Oven programmer C Top element G Grill element V Fan S Bottom element CIR Circular element PA Ignition switches group TM C G S V CIR S1 S2 LF F1 N/7 1 1 a L/8 PR TL M N L PA A T 1 6 1a 6a 4 9 4a 9a 3...
