Dell PowerVault 650F- Troubleshooting Guide
Dell PowerVault 650F– Troubleshooting Guide, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – SAN Installation and Troubleshooting Guide; Select Host Adapter
- Page 3 – Novell NetWare Support for Dell PowerVault 65xF Storage Systems; LUNs per Target
- Page 4 – GULYH; sys
- Page 5 – Netwareser vername; load
- Page 6 – unload omagent
- Page 7 – Dell PowerVault Fibre Channel Utilities CD
- Page 8 – Specify server boot path; Dell
- Page 10 – 2-10 SAN Installation and Troubleshooting Guide
support.dell.com
Novell NetWare Support for Dell PowerVault 65xF Storage Systems
12-1
This chapter provides instructions for connecting Dell PowerVault 650F and 651F stor-
age systems to a Dell PowerEdge or Compaq ser ver system running the Novell
NetWare operating system. All procedures in this document require administrator
access permissions.
This chapter describes a NetWare configuration that requires that Managed Node for
NetWare be installed on at least one of the NetWare ser vers (see Figure 2-2).
This chapter describes the following procedures:
Cabling the NetWare system to the storage area network (SAN)
Updating the QLogic host bus adapter (HBA) basic input/output system (BIOS)
and nonvolatile random-access memor y (NVRAM)
Installing the QLogic drivers on the NetWare system
Installing, Configuring, and Uninstalling Data Managed Node for NetWare
Dell OpenManage ATF for NetWare
Creating partitions and volumes on the NetWare hard-disk drives
NOTE: To install the Windows NT or Windows 2000-based Data Management soft-
ware, see Chapter 11, “Installing, Configuring, and Removing Microsoft Windows
SAN Software Components.”
Perform the following steps to cable NetWare systems to the PowerVault storage
system:
1.
Turn off the PowerEdge server(s) and the PowerVault 65
x
F storage systems.
65
x
F
!" !#
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
12-2 SAN Installation and Troubleshooting Guide 2. To connect an interface between the 5 x F Fibre Channel switch and each of the NetWare servers that you want to install on the SAN (see Figure 12-1), perform the following steps: a. Connect the high-speed serial data connector (HSSDC) of the interfa...
support.dell.com Novell NetWare Support for Dell PowerVault 65xF Storage Systems 12-3 3. If the Select Host Adapter screen is displayed, press the up- or down-arrow key to highlight the controller you want and press <Enter>. The Controller screen is displayed with a list of options for the sel...
12-4 SAN Installation and Troubleshooting Guide NOTE: The NetWare configuration specified in Figure 2-2 requires that a LUN is bound on an SP in order for the Data Managed Node for Netware to communicate with the SP. If there are no LUNs bound, then a Windows NT or Windows 2000 system attached direc...
