Dell E5530- User Manual

2 Removing and Installing Components This section provides detailed information on how to remove or install the components from your computer. Recommended Tools The procedures in this document may require the following tools: • Small flat-blade screwdriver• #0 Phillips screwdriver• #1 Phillips screw...

Removing the Battery 1. Follow the procedures in Before Working Inside Your Computer . 2. Slide the battery release latches into the unlock position. 3. Remove the battery from the computer. Installing the Battery 1. Slide the battery into its slot until it clicks into place. 2. Follow the procedure...

Removing the Subscriber Identity Module (SIM) Card 1. Follow the procedures in Before Working Inside Your Computer . 2. Remove the battery. 3. Press and release the SIM card located on the battery wall. 4. Slide the SIM card from the computer. Installing the Subscriber Identity Module (SIM) Card 1. ...

4. Work your way around the sides and top edge of the display bezel. . 5. Remove the display bezel from the computer . Installing the Display Bezel 1. Place the display bezel onto the display assembly. 2. Starting from the top corner, press on the display bezel and work around the entire bezel until...

Installing the Camera 1. Place the camera and microphone module on its place. 2. Connect the camera cable. 3. Tighten the screw to secure the camera and microphone module. 4. Install:a) display bezelb) battery 5. Follow the procedures in After Working Inside Your Computer . Removing the Display Pane...

6. Remove the display panel from the display assembly. Installing the Display Panel 1. Install the screws that secure the display brackets to the display panel. 2. Attach the display panel to the display assembly. 3. Align the display panel in its original position in the computer. 4. Connect the lo...

6. Lift upwards and remove the keyboard trim from the computer. Installing the Keyboard Trim 1. Align the keyboard trim to its place. 2. Press along the sides of the keyboard trim until it snaps in place. 3. Install the battery. 4. Follow the procedures in After Working Inside Your Computer . 19

Removing the Keyboard 1. Follow the procedures in Before Working Inside Your Computer . 2. Remove:a) batteryb) keyboard trim 3. Remove the screw at the back of the computer. 4. Lift the clip to release the keyboard trim from the computer . 20

7. Flip the keyboard over. 8. Peel off the adhesive tape securing the keyboard flat flex cable to the back of the keyboard. 9. Disconnect the keyboard flat flex cable. 10. Peel away the keyboard flat flex cable from the keyboard and remove it from the computer. Installing the Keyboard 1. Attach the ...

7. Install the screw at the back of the computer. 8. Install :a) keyboard trimb) battery 9. Follow the procedures in After Working Inside Your Computer . Removing the Access Panel 1. Follow the procedures in Before Working Inside Your Computer . 2. Remove the battery. 3. Remove the screws that secur...

Installing the Access Panel 1. Slide the access panel into its slot until it clicks into place. 2. Install the screws that secure the access panel to the computer. 3. Install the battery. 4. Follow the procedures in After Working Inside Your Computer . Removing the Optical Drive 1. Follow the proced...

Installing the Optical Drive 1. Engage the optical drive bezel tabs to attach the optical drive bezel to the optical drive. 2. Install the optical drive bracket. 3. Install the screws that secure the optical drive bracket. 4. Insert the optical drive into the computer. 5. Install the screw that secu...

6. Remove the screws that secure the hard drive bracket. 7. Remove the hard drive bracket from the hard drive. Installing the Hard Drive 1. Engage the hard drive bracket to the hard drive. 2. Install the screws that secure the hard drive bracket. 3. Install the hard drive into the computer. 4. Insta...

Installing the WLAN Card 1. Insert the WLAN card into its connector on the system board. 2. Connect the antenna cables to the respective connectors marked on the WLAN card. 3. Tighten the screw to secure the WLAN card to the computer. 4. Install:a) base coverb) battery 5. Follow the procedures in Af...

3. Remove the screws that secure the right base panel in place. 4. Remove the right base panel from the computer. Installing the Right Base Panel 1. Place the right base panel in its location at the bottom of the computer. 2. Install the screws that secure the right base panel to the bottom of the c...

3. Remove the screws that secure the thermal module in place. 4. Lift up the thermal module and remove it from the computer. Installing the Thermal Module 1. Place the thermal module in its compartment. 2. Install the screws that secure the thermal module to the computer. 3. Install :a) right base p...

Removing the Processor 1. Follow the procedures in Before Working Inside Your Computer . 2. Remove:a) SD memory cardb) batteryc) access paneld) right base panele) thermal module 3. Rotate the processor cam lock in a counter clockwise direction to the unlock position. Lift up the processor and remove...

5. Remove the screws that secure the palmrest on the computer. 6. Lift up the right edge of palmrest assembly. 7. Release the tabs on the left edge of the palmrest assembly and remove the palmrest from the computer. Installing the Palmrest 1. Align the palmrest assembly to its original position in t...

4. Install the screws at the bottom of the computer. 5. Install :a) right base panelb) optical drivec) keyboardd) keyboard trime) access panelf) batteryg) SD memory card 6. Follow the procedures in After Working Inside Your Computer . Removing the ExpressCard Reader Cage 1. Follow the procedures in ...

Removing the Bluetooth Module 1. Follow the procedures in Before Working Inside Your Computer . 2. Remove:a) SD memory cardb) batteryc) access paneld) keyboard trime) keyboardf) optical driveg) right base panelh) palm rest 3. Disconnect the Bluetooth cable from the system board and remove the screw ...

Removing the Audio Board 1. Follow the procedures in Before Working Inside Your Computer . 2. Remove:a) SD memory cardb) batteryc) access paneld) keyboard trime) keyboardf) optical driveg) right base panelh) palmresti) bluetooth module 3. Disconnect the audio board flat flex cable from the system bo...

Removing the Display Assembly 1. Follow the procedures in Before Working Inside Your Computer . 2. Remove:a) SD memory cardb) batteryc) access paneld) keyboard trime) keyboardf) optical driveg) hard driveh) right base paneli) palmrest 3. Disconnect and remove any antennas from the routing channels. ...

7. Remove the screws that secure the display assembly in place. 8. Remove the display assembly from the computer. Installing the Display Assembly 1. Install the screws that secure the display assembly in place. 2. Insert the low-voltage differential signaling (LVDS) cable and wireless antenna cables...

Removing the Right Support Frame 1. Follow the procedures in Before Working Inside Your Computer . 2. Remove:a) SD memory cardb) batteryc) access paneld) keyboard trime) optical drivef) hard driveg) right base panelh) palmresti) display assembly 3. Remove the screws that secure the right support fra...

Removing the Modem Card 1. Follow the procedures in Before Working Inside Your Computer . 2. Remove:a) SD memory cardb) batteryc) access paneld) keyboard trime) keyboardf) optical driveg) hard driveh) right base paneli) palmrestj) display assemblyk) right support frame 3. Remove the screw that secur...

6. Follow the procedures in After Working Inside Your Computer . Removing the Left Support Frame 1. Follow the procedures in Before Working Inside Your Computer . 2. Remove:a) SD memory cardb) batteryc) access paneld) keyboard trime) keyboardf) optical driveg) hard driveh) right base paneli) palmres...

3. Install:a) display assemblyb) palmrestc) right base paneld) hard drivee) optical drivef) keyboardg) keyboard trimh) access paneli) batteryj) SD memory card 4. Follow the procedures in After Working Inside Your Computer . Removing the System Board 1. Follow the procedures in Before Working Inside ...

7. Release the system board from the port connectors on the left and remove the system board. Installing the System Board 1. Align the system board into its original position on the computer. 2. Replace and tighten the screws to secure the system board to the computer. 3. Route and connect the follo...

Removing the Coin-Cell Battery 1. Follow the procedures in Before Working Inside Your Computer . 2. Remove:a) SD memory cardb) ExpressCardc) batteryd) access panele) keyboard trimf) optical driveg) hard driveh) WLAN cardi) right base panelj) thermal modulek) palmrestl) ExpressCard reader cagem) disp...

Removing the Power Connector 1. Follow the procedures in Before Working Inside Your Computer . 2. Remove:a) SD memory cardb) batteryc) access paneld) keyboard trime) keyboardf) optical driveg) hard driveh) WLAN cardi) right base panelj) thermal modulek) palmrestl) ExpressCard reader cagem) display a...

4. Remove the power connector. Installing the Power Connector 1. Install the power connector in the computer. 2. Thread the power connector cable in the routing channel. 3. Install:a) system boardb) left support bracketc) display assemblyd) ExpressCard reader cagee) palmrestf) thermal moduleg) right...

Removing the System Fan 1. Follow the procedures in Before Working Inside Your Computer . 2. Remove:a) SD memory cardb) batteryc) access paneld) keyboard trime) keyboardf) optical driveg) hard driveh) WLAN cardi) right base panelj) thermal modulek) palmrestl) ExpressCard reader cagem) display assemb...

4. Remove the screw that secures the system fan and lift it to remove from the computer. Installing the System Fan 1. Place the system fan in the computer. 2. Tighten the screws to secure the fan to the computer. 3. Install:a) power connectorb) system boardc) network connectord) modem carde) left su...

Removing the Network Connector 1. Follow the procedures in Before Working Inside Your Computer . 2. Remove:a) SD memory cardb) batteryc) access paneld) keyboard trime) keyboardf) optical driveg) hard driveh) right base paneli) palmrestj) display assemblyk) right support framel) left support framem) ...

3. Install:a) modem cardb) left support framec) right support framed) display assemblye) palmrestf) right base panelg) hard driveh) optical drivei) keyboardj) keyboard trimk) access panell) batterym) SD memory card 4. Follow the procedures in After Working Inside Your Computer . Removing the Speaker...

3. Remove the screws that secure the speakers. 4. Remove the speaker cables from the routing channels. 5. Lift the speaker out from the computer. Installing the Speakers 1. Place the speakers in the computer. 2. Tighten the screws to secure the speakers to the computer. 3. Connect the speaker cables...

3 Specifications Specifications NOTE: Offerings may vary by region. For more information regarding the configuration of your computer, click Start (Start icon) → Help and Support , and then select the option to view information about your computer. Table 1. System Information Feature Specification C...

4 Docking Port Information The docking port is used for connecting the laptop to a docking station (optional). 1. SIM card slot 2. Docking Port 65

5 Additional Information This section provides information for the additional features that are part of your computer. 67

6 System Setup Overview System Setup allows you to: • change the system configuration information after you add, change, or remove any hardware in your computer. • set or change a user-selectable option such as the user password.• read the current amount of memory or set the type of hard drive insta...