D-Link DVG-2101S - Manual

DVG-2101S User Manual Introduction 4 Front Panel Register LED This LED will light solid if the phone account registers successfully. This LED will flash during registering and light off if registering fails. Power LED This LED will light solid when the device finishes a self-test and booting up. Thi...

Introduction DVG-2101S User Manual 5 Rear Panel Phone Port Connects to your phone using a standard phone cable (RJ-11). WAN Port Connects to your broadband modem using an Ethernet cable. Reset Button Use a paper clip to: 1. Press 1-2 seconds to enable IVR. 2. Press 4-6 seconds to reset this unit. 3....

DVG-2101S User Manual Hardware Installation 6 Hardware Installation Connecting the DVG-2101S Directly to a Modem If your computer connects directly to a DSL or Cable modem and does not connect to a router, follow the steps below to install your DVG-2101S. Note: This is the most common setup configur...

Configuration DVG-2101S User Manual 9 Configuration Prior to using your web browser for accessing the web-based configuration utility, if DHCP is not enabled on your computer, be sure to assign a static IP address to the VoIP Telephone Adapter. Use the computer that was last connected directly to yo...

Configuration DVG-2101S User Manual 11 Step 3-1 If you selected Static IP, enter the IP address, subnet mask and gateway supplied by your ISP. Step 3-1 If you selected Dynamic IP, you may enter the host name in the field. Step 3-1-1 Static IP users have to set the DNS address. Click Next . Click Nex...

Setup DVG-2101S User Manual 13 Setup Internet Setup Connection Type The WAN connection type setting allows you to configure this device to establish your broadband Internet connection. Your Internet Service Provider (ISP) should provide the necessary information to you when you subscribe to the Inte...

DVG-2101S User Manual Setup 14 Static IP Choose Static IP Address if the WAN IP information is provided to you by your ISP. You will need to enter in the IP address, subnet mask, gateway address, and DNS addresses provided to you by your ISP. You should enter the IP address, subnet mask, and gateway...

Setup DVG-2101S User Manual 15 PPPoE Choose PPPoE (Point-to-Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a username and password. Most DSL users will select this option. PPPoE User Name Enter the PPPoE user name supplied by your ISP. PPPoE Passwor...

DVG-2101S User Manual Setup 16 MAC Address Clone Basically, every Ethernet interface (also called a NIC - Network Interface Card) has a MAC address. If the administrator assigns IP addresses to devices according to the authorized MAC address, or only allows devices with authorized MAC addresses to a...

Setup DVG-2101S User Manual 17 Static Routing You can specify additional information according to the network topology the VoIP Adapter is attached to in order to establish an efficient networking environment. Click Add button to configure static routing settings. Network Destination Enter in the IP...

DVG-2101S User Manual Setup 18 VoIP Setup The VoIP (Voice over Internet Protocol) Adapter can be configured to handle voice communication over the Internet. The screen shown below, along with the SIP account list and phone book pages are used to configure the basic settings to allow you to communica...

Setup DVG-2101S User Manual 19 Phone Book This page allows you to add and edit your frequently used VoIP phone numbers in the phone book. It is also required if you want to make peer-to-peer calls. In peer-to-peer calls, you call another VoIP device directly without going through a SIP server. Click...

DVG-2101S User Manual Setup 20 Time and Date The VoIP Adapter allows you to maintain the system clock via the Internet. You must first select your time zone from the drop-down list, then select a pre-defined NTP (Network Time Protocol) time server from the drop-down list, or specify the IP address o...

Advanced DVG-2101S User Manual 21 Advanced VoIP Settings This VoIP section allows you to configure advanced settings for your VoIP connections. Call Feature This page allows you to configure advanced features for your SIP account. Forward Always Check the checkbox and enter the phone number to forwa...

DVG-2101S User Manual Advanced 22 Warm Line* Check the checkbox and enter a specific number to be dialed automatically by the VoIP Adapter when the user goes off-hook on the line and does not input any digits after a configurable timeout has elapsed. For example, this feature can be used for emergen...

Advanced DVG-2101S User Manual 23 SIP Setting This page allows you to configure the settings related to the SIP service provider. You need to configure your VoIP Adapter to communicate with the devices that will send and receive telephone calls over the Internet. If you are behind a NAT modem or rou...

DVG-2101S User Manual Advanced 24 P_Assert Check the checkbox to enable P_Assert to hide the client name when sending messages to the SIP proxy server. E.164 ENUM Check the checkbox to enable E.164 ENUM (Number Mapping)feature. E.164 is a mechanism to transform an E.164 number into a list of URIs (U...

DVG-2101S User Manual Advanced 26 * The “*” represents the * (star key) on your telephone keypad. For example, *xx means press * key followed by any two digits from 0-9, such as *69 or *55. . The “.” (dot) means repeat the previously listed digit zero or more times. For example, x. means zero or mor...

Advanced DVG-2101S User Manual 27 When you dial *666: Scenario Rule Combination The VoIP Adapter will do… 1 Rule1 + Rule2 + Rule3 + Rule4 = Enter the VoIP Adapter’s IVR mode 2 Rule2 + Rule3 + Rule4 = Address a call to [email protected] 3 Rule3 + Rule4 = Replace the input with 911, but this number will ...

DVG-2101S User Manual Advanced 28 Prefix The prefix specifies a series of digit sequences. When you dial a series of digits, each sequence in the prefix is tested as a possible match. The matching sequences form a set of candidate digit sequences. The phone number set here is used to add, strip, or ...

Advanced DVG-2101S User Manual 29 Dial Prefix This page allows you to configure your dialing policy. You can change the default dial prefix settings to fit you dialing behavior.

DVG-2101S User Manual Advanced 30 Codec The codec used for each call will be negotiated with the peer party before each session, and therefore many codecs will not be included in your default configuration. The default codec is G.729A, it occupies little bandwidth while maintaining good voice qualit...

Advanced DVG-2101S User Manual 31 Phone Setting This page allows you to enable VAD (Voice Activity Detection), CNG (Comfortable Noise Generation), and Echo Cancellation. You can also specify the Receive/Send Gain as well as select the Telephony Tone and Caller ID type. The VoIP Telephone Adapter pro...

DVG-2101S User Manual Advanced 32 DNS The DNS (Domain Name System) feature allows you to set the configuration of the DNS proxy. DNS Server Configuration Select to obtain DNS server address automatically or specify the DNS server(s) if you are provided DNS information by your ISP. Primary DNS Addres...

Advanced DVG-2101S User Manual 33 Dynamic DNS The Dynamic DNS service allows you to bind the device's public IP address to a static hostname, allowing your computer to be more easily accessed from various locations on the Internet. Most broadband Internet Service Providers assign dynamic (changing) ...

DVG-2101S User Manual Advanced 34 QoS The QoS (Quality of Service) feature allows you to classify traffic by its priority and mark it with a Differentiated Services (DiffServ) flag. VLAN ID Specify the VLAN ID from 0 to 4095. Priority (Voice/Data) Indicate the priority of voice and data separately. ...

Advanced DVG-2101S User Manual 35 VPN A Virtual Private Network (VPN) is the extension of a private network that encompasses links across shared or public networks like the Internet. In short, using VPN technology, you can send data between two computers across a shared or public network in a manner...

DVG-2101S User Manual Advanced 36 Account Name Enter an account name for the connection. You can configure up to four accounts for this device. Type Select the VPN type to be IPSec, PPTP, or L2TP from the drop-down list. User Name Enter the user name for VPN connection. Password Enter the password f...

Maintenance DVG-2101S User Manual 37 Maintenance System Configuration These configuration tools help you reboot, backup, restore settings, or reset the VoIP Adapter to its factory default settings. Reboot This feature allows you to reboot the device while still keeping its current settings. Backup S...

DVG-2101S User Manual Maintenance 38 Auto Provision This page allows you to automatically update your VoIP Adapter’s configuration by using a TFTP, FTP, HTTP, or HTTPS server located on the Internet. If you have to access such services, you will need to know the IP address of the provisioning server...

DVG-2101S User Manual Maintenance 40 Log Setting This page allows you to configure settings to upload logs to a TFTP server and/or download logs to your local drive. TFTP Server IP Enter the IP address of a TFTP server. Update Interval Enter the update interval in day(s). Max File Size Enter the max...

Maintenance DVG-2101S User Manual 41 Firmware Update This tool allows you to upgrade this device's firmware locally. This device is also capable of being managed remotely by the service provider. Note: Please contact your Internet Service Provider prior to upgrading your firmware. The update process...

DVG-2101S User Manual Maintenance 42 Access Control Access to your VoIP Adapter is controlled through two user accounts: admin and user. The username “admin” has unrestricted access to change and view the settings of the VoIP Adapter. The username “user” can access the VoIP Adapter, view configurati...

Maintenance DVG-2101S User Manual 43 Ping Test The VoIP Adapter allows you to perform a ping test. This feature helps you to diagnose connection problems. If you can ping an IP on the WAN side successfully, you should be able to access the Internet. IP/Domain Enter the IP/Domain you want to ping in ...

DVG-2101S User Manual Status 44 Status Device Information You can use the Device Info screen to view the connection status for the VoIP Adapter's WAN/LAN interfaces, current firmware, and other related information.

Status DVG-2101S User Manual 45 VoIP Status You can use the VoIP Status screen to view the phone port status.

DVG-2101S User Manual Status 46 CDR Status You can use the CDR (Call Detail Record) Status screen to view the call history records of incoming and outgoing calls. It stores up to 100 records.

Status DVG-2101S User Manual 47 VPN Status You can use the VPN Status screen to view the VPN connection status.

DVG-2101S User Manual Status 48 Network Status You can use the Network Status screen to view the routing table, VoIP and network statistics to observe the current network conditions.

Status DVG-2101S User Manual 49 System Log You can view all the records of events that have occurred on the VoIP Adapter.

DVG-2101S User Manual Help 50 Help Help Menu This help menu provides some information to help you know more details about the VoIP Adapter. Select the item which you want to view to display the description.

Configuration through IVR DVG-2101S User Manual 51 Configuration through IVR The VoIP Adapter provides a convenient IVR (Interactive Voice Response) function to help you query and configure the basic settings of the VoIP Adapter with a phone and without turning on a PC. To access IVR mode, plug a ph...

DVG-2101S User Manual Frequently Asked Questions 52 Frequently Asked Questions Q: Why can’t I access the web-based configuration utility? A: When entering the IP address of the VoIP Adapter (192.168.1.150), you are not connecting to a website on the Internet and don’t have to be connected to the Int...

Registration DVG-2101S User Manual 55 Technical Specifications Call Control Protocols Compliance SIP2 (RFC3261) SIP1 (RFC2543) Voice Compression G.711 a/u-law, G.726, G.729A/B, G.723.1 Analog Voice Ports Loop-Start FXS interface DTMF tone detection/generation V.21/V.25 Modem/Fax tone detection Echo ...