Page 3 - CONTENTS
D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch CONTENTS P REFACE ................................................................................... I N OTES , N OTICES , AND C AUTIONS ........................................... I S AFETY I NSTRUCTIONS ....................................
Page 4 - Preface; Intended Readers; A NOTE indicates important information
D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch Preface The DGS-1016D/DGS-1024D Manual is divided into sections that describe the system installation and operating instructions with examples. Section 1, Introduction - A description of the physical features of the Switch, including LED i...
Page 5 - Safety Instructions; ii; Safety Cautions
D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch Safety Instructions Use the following safety guidelines to ensure your own personal safety and to help protect your system from potential damage. Throughout this safety section, the caution icon ( ) is used to indicate cautions and precaut...
Page 6 - iii; or local power company.
D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch iii consult your service provider or local power company. • To help avoid damaging your system, be sure the voltage selection Switch (if provided) on the power supply is set to match the power available at your location: – 115 volts (V)/60...
Page 7 - iv
D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch • Move products with care; ensure that all casters and/or stabilizers are firmly connected to the system. Avoid sudden stops and uneven surfaces. General Precautions for Rack-Mountable Products Observe the following precautions for rack st...
Page 9 - Protecting Against Electrostatic Discharge
D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch vi Protecting Against Electrostatic Discharge Static electricity can harm delicate components inside your system. To prevent static damage, discharge static electricity from your body before you touch any of the electronic components, such...
Page 10 - SECTION 1; Introduction; Ethernet Technology; Fast Ethernet Technology
D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch 1 SECTION 1 Introduction Ethernet Technology Switch Description Features Ports Front-Panel Components Ethernet Technology Fast Ethernet Technology The growing importance of LANs and the increasing complexity of desktop computing applicatio...
Page 11 - Switching Technology; segments
D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch 2 and 100Mbps Ethernet environments, Gigabit Ethernet provides a straightforward upgrade without wasting a company’s existing investment in hardware, software, and trained personnel. The increased speed and extra bandwidth offered by Gigab...
Page 12 - Switch Description; Features; Cable Diagnostic function at Switch boot up
D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch 3 For Fast Ethernet or Gigabit Ethernet networks, a switch is an effective way of eliminating problems of chaining hubs beyond the “two-repeater limit.” A switch can be used to split parts of the network into different collision domains, f...
Page 14 - Front-Panel Components; Figure 1-1. Front Panel View of the Switch; LED Indicators
D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch 5 Note: For illustration purposes, the DGS-1016D is used. Front-Panel Components The front panel of the Switch consists of LED indicators, 16 or 24 (10/100/1000 Mbps) Ethernet ports. Figure 1-1. Front Panel View of the Switch Comprehensive...
Page 15 - Amber
D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch 6 Comprehensive LED indicators display the conditions of the Switch and status of the network. A description of these LED indicators follows (see LED Indicators). The LED indicators of the Switch include Power, Link/Act, 1000Mbps and 100Mb...
Page 16 - Rear Panel Description; Figure 1-3. Rear panel view of the Switch
D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch 7 Cable connection good − Speed LED: Green − Link/Act LED: Off The Cable Diagnostic function operates only during the Switch boot up (when the Switch is first powered on). The Cable Diagnostic first scans the 16 or 24 Ethernet ports to det...
Page 17 - SECTION 2; Installation; Package Contents; Four rubber feet with adhesive backing; Before You Connect to the Network
D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch 8 SECTION 2 Installation Package Contents Before You Connect to the Network Installing the Switch Power On Package Contents Open the shipping carton of the Switch and carefully unpack its contents. The carton should contain the following i...
Page 18 - Mounting the Switch on a Rack; Figure 2-1. Mounting the Switch to a Rack
D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch 9 • • • • • • The power outlet should be within 1.82 meters (6 feet) of the Switch. Visually inspect the power cord and see that it is fully secured to the AC power port. Make sure that there is adequate space for proper heat dissipation f...
Page 20 - Power On; Power Failure
D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch 11 Power On Plug one end of the AC to DC power converter into the power connector of the Switch and the other end into the local power source outlet. After the Switch is powered on, the LED indicators will momentarily blink. This blinking ...
Page 21 - Section 3; Connecting The Switch; All 16/24 high-performance NWay Ethernet ports; Switch To End Node; Figure 3-1. Switch connected to an end node
D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch 12 Section 3 Connecting The Switch Switch To End Node Switch To Hub or Switch Connecting To a Server NOTE: All 16/24 high-performance NWay Ethernet ports can support both MDI-II and MDI-X connections. Switch To End Node End nodes include P...
Page 22 - Switch to Hub or Switch
D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch 13 • • • The Link/Act LEDs for each UTP port light green when the link is valid. The Speed LED over the port label indicates a port speed of either 10/100 Mbps or 1000Mbps. A blinking LED on the top indicates packet activity on that port. ...
Page 24 - Appendix A; Technical Specifications; General
D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch 15 Appendix A Technical Specifications General Standards: IEEE 802.3ab 1000BASE-T IEEE 802.3u 100BASE-TX IEEE 802.3 10BASE-T IEEE 802.3x Flow Control Protocol: CSMA/CD Data Transfer Rate: 10Mbps (Half-duplex) Ethernet: 20Mbps (Full-duplex)...
Page 26 - Glossary
D-Link DGS-1016D/DGS-1024D Unmanaged Gigabit Ethernet Switch 17 Glossary 1000BASE-LX – A short laser wavelength on multimode fiber optic cable for a maximum length of 550 meters. 1000BASE-SX – A long wavelength for a "long haul" fiber optic cable for a maximum length of 10 kilometers. 100BAS...
Page 34 - Warranty and Registration Information (USA Only)
Warranty and Registration Information (USA Only) Subject to the terms and conditions set forth herein, D-Link Systems, Inc. (“D-Link”) provides this Limited warranty for its product only to the person or entity that originally purchased the product from: • D-Link or its authorized reseller or distri...
Page 39 - International Offices
30 International Offices D-Link U.S.A 17595 Mt. Herrmann Street Fountain Valley, CA. 92708 TEL: 714-885-6000 Fax 866-743-4905 URL: www.dlink.com Canada 2180 Winston Park Drive Oakville, Ontario, L6H 5W1 Canada TEL: 1-905-8295033 FAX: 1-905-8295223 URL: www.dlink.ca Europe (U. K.) 4th Floor, Merit Ho...
Page 41 - Registration Card
32 Registration Card Print, type or use block letters. Your name: Mr./Ms _____________________________________________________________________________ Organization: ________________________________________________ Dept. ____________________________ Your title at organization: _______________________...
