Cub Cadet 759-04080 - Manual
Cub Cadet 759-04080 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Use care to avoid damaging the hydrau-
- Page 3 – Figure 6; Because of limited space between the ped-; Figure 7; • Remove the two hex tapp screws securing the; Figure 8; • Pivot the rear of the cruise latch bracket downward; Figure 9
- Page 4 – Setting The Cruise Control; The cruise control feature can only be operat-; Disengaging the Cruise Control; Regardless of the method used, the indicator
1
759-04080 CRUISE CONTROL KIT
Introduction
The cruise control kit is designed to allow the tractor op-
erator to maintain a desired “foot free”
forward speed
in areas where constant speed changes are not re-
quired.
The cruise control feature can only be operated
in the forward direction.
Installing the Cruise Control Kit
NOTE:
Some installation procedures are more easily
performed from beneath the tractor. If equipped, the
mower deck may be removed from the tractor to im-
prove access.
Wire leads w/connectors needed to power the cruise
control magnet are provided in the tractor wire harness.
To install the cruise control kit, proceed as follows:
• Remove the plug from the right side of the dash
panel by sliding a thin flat edged tool beneath the
plug and prying upward. See Figure 1.
NOTE:
The wire harness connector for the cruise switch
may be connected to the dash panel plug. If so, carefully
pull the wire harness connector up through the dash
panel while removing the plug. If the wire harness leads
are not connected to the plug, it will be necessary to re-
move the dash panel insert.
Figure 1
Remove
Plug
CUB CADET LLC P.O. BOX 361131 CLEVELAND, OHIO 44136-0019
PRINTED IN U.S.A.
FORM NO. 769-01718 (3/05)
Installation Instructions
For Series 6000 Tractor Models
KIT COMPONENTS
1
2
3
5
4
6
1.
2.
3.
4.
5.
6.
Special Screw
Magnet w/Spring Assy.
Cruise Latch Bracket
Hex Jam Nut, 7/16-20
Cable Tie
Cruise Switch
1750736
1768971
703-05791
712-0240
725-0157
725-04246
Ref.
Pt. No.
Description
7
7.
736-0171
Lock Washer, 7/16"
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Other Manuals for Cub Cadet 759-04080
Summary
2 • Remove the dash panel insert by removing the two screws and lifting the insert out (See Figure 2). • Locate the unused dash harness connector (with green(2), green w/white, red w/black, yellow w/black, and violet wires) inside the dash panel. Liftthe connector up through the hole in the dash pan...
3 Figure 6 • Slide the lock washer (Ref.7) onto the special screw, then thread the hex jam nut (Ref.4) onto thescrew. Refer to Figure 6. NOTE: Because of limited space between the ped- al shaft plate and frame, it may be easier to installthe hex jam nut from the underside of the tractor. • Fully tig...
4 Setting The Cruise Control WARNING: Always use extreme cautionwhen operating the tractor with thecruise control engaged. Use good judge-ment and maintain a safe speed for theconditions of operation. NOTE: The cruise control feature can only be operat- ed in the forward direction. • Slowly depress ...
