Crown 16-325 500506 - Manual

Table of Contents:

• Page 3 – Table of Contents; Knockdown Boiler Assembly Instructions 6; I Product Description
• Page 4 – II Specifications
• Page 5 – III Before Installing; National Fuel Gas Code; IV Locating the Boiler; WARNING
• Page 6 – Figure 2: Minimum Clearances to Combustibles; Boiler Model
• Page 8 – V Knockdown Boiler Assembly Instructions; punctures due to mishandling.; DO NOT EXCEED THE 50 PSI; pressure gauge and related piping used in the leak test.
• Page 9 – ) Slide or walk the assembly into its permanent position.; DO NOT DROP; near boiler supply piping.; Figure 4: Boiler Shipping Arrangement With Tapping Locations; Table 4: Tapping Purpose Chart
• Page 11 – instructions on leak testing the gas piping.; E. Ignition Control & Gas Valve Installation; the other half of the union located on the gas manifold. See Figure 8.
• Page 12 – Figure 6: Jacket Assembly
• Page 14 – shown in Figure 4. Control and trim components are as follows:; Figure 9: Temperature-Pressure Gauge Installation
• Page 15 – VI Air For Combustion and Ventilation; Warning; to assure proper combustion.
• Page 16 – Figure 10: Boiler Installed In Confined Space, All Air From Inside
• Page 20 – without; chimney sealed tight.; Do not
• Page 21 – metal screws and support as required.; Figure 17: Vent Damper Installation Details
• Page 22 – Removing An Existing Boiler From A Common Chimney; appliance will operate continuously.
• Page 23 – VIII System Piping; A. Standard Heating System Piping; Installation of Residential Hydronic Systems; CAUTION
• Page 24 – to drain and refill the entire system.; B. Piping for Special Situations; Radiant systems that employ tubing without an oxygen barrier.
• Page 27 – IX Gas Piping; Figure 20: Gas Main Piping And Branch Connections To Boiler
• Page 28 – X Control System Wiring; boiler. Do not install these devices in the 24 volt factory wiring.; Sequence of Operation – Vent Damper (If Used); ) The vent damper is continuously powered at terminal 1.; DANGER
• Page 30 – Figure 21: Series 16 Standard Boiler Wiring
• Page 32 – Safety Control Operation
• Page 33 – XI Start-up and Checkout; ) Make sure that the boiler is filled with water.
• Page 35 – Figure 25: Gas Valve Detail - Robertshaw 7000DERHC; Repair any leaks found at once.
• Page 36 – LIGHTING INSTRUCTIONS FOR BASE MODULES EQUIPPED WITH
• Page 37 – XII Service and Maintenance; The following routine maintenance should be performed:; flow of combustion and ventilation air.
• Page 39 – XIII PARTS
• Page 40 – Figur
• Page 45 – JACKET PANEL CARTON
• Page 47 – OPTIONAL AUTOMATIC VENT DAMPER KIT
• Page 48 – Manufacturer of Hydronic Heating Products