COZY 90N50A - Manual
COZY 90N50A – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – Provide fresh air for combustion and venting.; SAFETY RULES - Continued
- Page 4 – ” Minimum
- Page 6 – INSTALLING THE DRAFT HOOD; leakage of vent gases; . Never install or operate a floor furnace; vertical height of the vent.; Continued – next page; FU; FIGURE 6
- Page 9 – CONNECTING THE GAS PIPING; SEDIMENT TRAP; CHECKING THE GAS PIPING; from the gas piping system before testing.; Failure to do so may result in damage to the pressure regulator; operation. Verify proper operation after servicing.
- Page 10 – CHECKING THE GAS PIPING - CONTINUED
- Page 11 – FOR YOUR SAFETY READ BEFORE LIGHTING; WHAT TO DO IF YOU SMELL GAS:; TO TURN OFF GAS TO APPLIANCE; PILOT
- Page 12 – VENT SYSTEM; SPECIFIC ELEVATIONS; NATURAL GAS; ADJUSTING THE BURNER; ADJUSTING THE PILOT FLAME; to increase the flame.; BURNER ORIFICE
- Page 13 – LIMIT SWITCH
- Page 14 – MAINTENANCE INSTRUCTIONS; Keep flammable materials away from floor furnace area.; TO CLEAN BURNER; Remove bottom pan from outer casing.; WARNING; SERVICE RECORD
- Page 15 – SYMPTOM
- Page 16 – GAS FLOOR FURNACE LIST PRICES
- Page 19 – TABLE A
Gas-Fired Vented
FLOOR FURNACE
INSTALLATION AND
OPERATING INSTRUCTIONS
P/N 74521
REV. 08/97
MODEL NUMBERS
MILLIVOLT CONTROL SYSTEM
NATURAL GAS
90N30A
90N50A
90N65A
90N75A
WARNING: If the information in this manual is not followed
exactly, a fire or explosion may result causing property
damage, personal injury or loss of life.
- Do not store or use gasoline or other flammable vapors and
liquids in the vicinity of this or any other appliance.
- WHAT TO DO IF YOU SMELL GAS:
•
Do not try to light any appliance.
•
Do not touch any electrical switch; do not use any phone
in your building.
•
Immediately call your gas supplier from a neighbor’s phone.
Follow the gas supplier’s instructions.
•
If you cannot reach your gas supplier, call the fire
department.
- INSTALLATION AND SERVICE MUST BE PERFORMED
BY A QUALIFIED INSTALLER, SERVICE AGENCY OR
THE GAS SUPPLIER.
The coating selected to provide
longer life to the heat exchanger
may smoke slightly upon initial
firing. Please provide adequate
ventilation if this occurs.
WARNING: Operation of this furnace when not connected to a properly installed
and maintained venting system can result in Carbon Monoxide (C.O.) poisoning
and possible death. For your safety, this furnace and the venting system should
be inspected at least annually by a qualified service person.
THIS UNIT IS NOT APPROVED FOR INSTALLATION IN MOBILE HOMES,
GREENHOUSES, OR ENVIRONMENTS INVOLVING DUSTY, WET, CORROSIVE, OR
EXPLOSIVE CONDITIONS. SUCH CONDITIONS WILL INVALIDATE THE WARRANTY
AND MAY CREATE UNSAFE CONDITIONS.
R
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
HELPFUL INSTALLATION INFORMATION Do not attempt to heat through more than one doorway in any direction to adjoining rooms. Always over-estimate the amount of heat required rather than under-estimate it. Always use the next size floor furnace aboveyour actual heating requirements. Seal all cracks aro...
FRESH AIR FOR COMBUSTION AND VENTING Adequate air for combustion and venting must be provided. Any reduction in the necessary amount of fresh air can result in an oxygen starved flame that emits Carbon Monoxide (C.O.) an odorless, colorless gasthat can cause serious injury or death. A ventilated cra...
INSTALLING THE DRAFT HOOD The draft hood must be installed in the same atmospheric pressure zone asthe combustion air inlet. The draft hood is packed in its own carton withinthe master pack. Make sure the draft hood received is the correct one forthe floor furnace being installed. Included in the ca...
