Cornelius ICE FROST - Manual

Ice Frost Operator’s Manual Publication Number: M620919596OPR - 2 - © 2004-2006, IMI Cornelius Inc. INSTALLATION 1. Remove the equipment from the packing, then slide it off upwards (see FIGURE 1). 2. Checking the machine identification after removing the packing, you must check that the equipment yo...

Ice Frost Operator’s Manual © 2004-2006, IMI Cornelius Inc. - 3 - Publication Number: M620919596OPR C ONNECTION D IAGRAMS Ice Frost Generic (Pre-mix) The diagram shows the sequence for the connection between the ICE FROST GENERIC PRE to an existing pre-mix system. FIGURE 3 Description: 1. Pre-mix pr...

Ice Frost Operator’s Manual © 2004-2006, IMI Cornelius Inc. - 5 - Publication Number: M620919596OPR Alarms Safety Probe Alarms (only for I CE F ROST G ENERIC Pre-mix) You will remember that the monitoring of the safety probes’ conditions (satisfied/ not satisfied) is only active during the bowl load...

Ice Frost Operator’s Manual © 2004-2006, IMI Cornelius Inc. - 9 - Publication Number: M620919596OPR P ROGRAMMING E LECTRONIC T OUCH P AD To Enter Time Programming on Initial Installation or in the Event of Service 1. Turn the power switch OFF. 2. Press and hold the left “PRESS TO SELECT FUNCTION” bu...

Ice Frost Operator’s Manual © 2004-2006, IMI Cornelius Inc. - 11 - Publication Number: M620919596OPR Viewing the Bowl Temperature 1. Turn ON the auger on the side that you want to display the bowl temperature (press the “AGER ON/ OFF” button). 2. Press the “PRESS TO SELECT FUNCTION” button until the...

Ice Frost Operator’s Manual Publication Number: M620919596OPR - 12 - © 2004-2006, IMI Cornelius Inc. QUARTERLY CLEANING AND SANITATION P OST M IX S YSTEMS O PERATIONS ATTENTION: The cleaning operations must be performed with the machine disconnected from the power supply. 1. Empty the bowl of any re...

Ice Frost Operator’s Manual Publication Number: M620919596OPR - 16 - © 2004-2006, IMI Cornelius Inc. SPECIAL MAINTENANCE ATTENTION: To guarantee peak cooling system performance level, the routine cleaning of the condenser filter is essential. As explained earlier, an audible signal accompanied by th...

Ice Frost Operator’s Manual © 2004-2006, IMI Cornelius Inc. - 17 - Publication Number: M620919596OPR ELECTRONIC MONITORING E LECTRONIC B OWL M ONITORING AND S AFETY S YSTEM P RESSURE AND L EVEL C ONTROL C ARD G ENERAL F EATURES The diagram shows the electronic pressures and levels management system:...

Ice Frost Operator’s Manual Publication Number: M620919596OPR - 18 - © 2004-2006, IMI Cornelius Inc. OFF C ONDITION In this condition, the electronic control is not connected to the power supply. To connect the ECB to the power supply, the main system switch must be put in the ON position. 1st Filli...

Ice Frost Operator’s Manual © 2004-2006, IMI Cornelius Inc. - 19 - Publication Number: M620919596OPR Managing the Bowl Levels When one of the two level probes fails to detect the presence of liquid in the bowl, the Fill solenoid valve is activated to refill the correct level. The probes relating to ...

Ice Frost Operator’s Manual Publication Number: M620919596OPR - 20 - © 2004-2006, IMI Cornelius Inc. NOTE 1: the same intervention methods are applied when the safety probe is uncovered after the solenoid valve has been activated. NOTE 2: the 3-second software filter activated when it detects the sa...

Ice Frost Operator’s Manual © 2004-2006, IMI Cornelius Inc. - 21 - Publication Number: M620919596OPR WIRING DIAGRAM VFCB (P RE -M IX ) 115V/60H Z FIGURE 36

Ice Frost Operator’s Manual © 2004-2006, IMI Cornelius Inc. - 25 - Publication Number: M620919596OPR TROUBLESHOOTING NOTE: The following procedures must be performed by a qualified service technician. Problem Possible Cause Solution “Filt” or “Err” message appears on the touchpad LED readout • The f...