Cooper Lighting P4R - Manual
Cooper Lighting P4R – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Exploded view and part call-out
Canopy
Set screw
1/4-20 x 4 1/2"
Hex cap bolts
(4x)
(by others)
J-box
#8-32 x3/8"
(2x)
(4x)
1/4" Fastener
Cover plate
Wiring the fixture
1.
Remove all 1/4-20 x4 1/2" hex bolts from bottom of pendant.
2.
Remove both #8-32 x 3/8" set screws and allow canopy to
slide down pendant.
3.
Run wires from J-box into pendant, ensure there is enough
wire to reach cover plate.
4.
Using appropriate fasteners, secure fixture to ceiling.
Use
additional bracing around J-box to support fixture.
5
. Replace canopy and secure using both set screws.
Yoke arm
indicator
Aiming the fixture
Fixture head
indicator
1.
To aim fixtures, loosen both #10-32 end screws on
one
fixture. When both indicators are lined up, the slope of the
lens face is 40-degrees. Each subsequent notch is an
additional +/- 10-degrees.
2.
When fixture head is rotated to the desired angle, retighten
end screws to secure the position.
3.
Repeat for remaining fixture heads.
Set screw
Mounting pendant to J-box
(4x)
(by others)
1/4" fasteners
(by others)
J-box
(2x)
(4x)
Hex cap bolts
1/4-20 x4 1/2"
#8-32 x3/8"
Canopy
Cover plate
Use additional bracing
around J-box to support
fixture.
4.
Cover plate
Push connections into pendant and secure cover plate.
properly matched.
1/4-20 x4 1/2"
Fixture wire
Hex cap bolts
(4x)
1.
With pendant secure, slide fixture assembly onto pendant
and secure with four 1/4-20 x4 1/2" hex bolts.
2.
Remove cover plate and insert wires from fixture heads into
pendant and pull through opening.
3.
Attach appropriate wires and ensure all connections are
Attention:
Quad fixture assemblies require additional bracing/structure
around J-box to support fixture.
2
that all sources of power are turned off. All
Sheet 1 of 2
performed by a certified electrician.
ADY071466 REV B(ECN80481)
Warning
: Before starting any work ensure
work must meet local/national codes and be
Do not
mount fixtures vertically.
Installation Instructions
Vault
C-Scroll
Roundel
These installation instructions are valid with the above Ametrix styles.
1
3
Small, INDOOR
P4R
(P
endant,
4
-way,
R
emote ballast
)
Visor and Non-Visor
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
