Cooper Lighting Indoor Lighting - Manual
Cooper Lighting Indoor Lighting – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Warning
: Before starting any work ensure
that all sources of power are turned off. All
work must meet local/national codes and be
performed by a certified electrician.
Do not
mount fixtures vertically.
Installation Instructions
Vault
C-Scroll
Roundel
These installation instructions are valid with the above Ametrix styles.
1
3
2
Sheet 1 of 3
Large, INDOOR
P1R
(P
endant
, 1
-way
, R
emote ballast
)
Visor and Non-Visor
ADY071470 REV A(ECN070347)
Securing fixture to pendant
1.
Loosen #6-32x 3/8" Pan head screws and allow canopy to slide
down pendant.
2.
Feed wires from J-box through wire ways in mounting plate
and secure fixture to bracing around J-box.
3.
Attach appropriate wires and ensure all connections are
properly matched.
4.
Replace canopy and secure with both #6-32 x3/8" Pan head
screws.
#6-32 x 3/8"
Pan head screws
(2x)
Appropriate
fasteners
(by others)
(4x)
Canopy
J-box
(by others)
Use additional bracing
around J-box to support
fixture.
1/4-20 x 3/4"
Hex cap screw
(2x)
End screw
(2x)
#6-32 x 1/4"
Flat head screw
End cap
1.
Begin by removing end screw, #6-32 x 1/4" Flat head screw
and end cap from one side of Yoke and remove fixture head.
2.
Mount yoke to pendant with both 1/4-20 Hex cap screws.
3.
Feed fixture wire through connector in pendant up through
mounting plate and reattach fixture head to yoke.
Wire connector
Yoke
Mounting plate
Fixture wire
#10-32
End screw
(2x)
#10-32 x3/8"
Pan head screw
(2x)
Canopy
Mounting plate
1/4-20 x3/4"
Hex cap screw
(2x)
Appropriate fasteners
(by others)
(2x)
Exploded view and part call-out
Mounting and wiring fixture
Aiming the fixture
Attention:
Large fixtures require additional bracing/structure
around J-box to support fixture..
Wire ways
#10-32
End Screw
Fixture head
indicator
Yoke arm
indicator
1.
To aim fixtures, loosen both #10-32 end screws on
fixture. When both indicators are lined up, the slope of the
lens face is 40-degrees. Each subsequent notch is an
additional +/- 10-degrees.
2.
When fixture head is rotated to the desired angle, retighten
end screws to secure the position.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
