Cooper Lighting CPP/CPS - Manual
Cooper Lighting CPP/CPS – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Mounting non power side pendant; Installation Instructions; PS Exploded assembly
- Page 3 – PS (Pendant Swivel) mounting plate dimensions; ft fixture
- Page 4 – Wiring fixtures to J-box; Securing first fixture to wired center yoke
- Page 5 – Continuous Pendant Row Layouts
Installation Instructions
Vault w/ visor
C-Scroll w/ visor
Roundel w/ visor
These installation instructions are valid with the above Ametrix styles
Warning
: Before starting any work ensure
that all sources of power are turned off. All
work must meet local/national codes and be
performed by a certified electrician.
Do not
mount fixtures vertically.
Small, INDOOR
CPP/CPS
(C
ontinuous
P
endant
)
Visor and Non-Visor
Sheet 1 of 5
ADY071477 REV A (ECN080352)
Pendant tube
Yoke arm
10-32 x5/8"
End screw
Pendant nut
(x2)
End pendant
assembly
Center pendant
assembly
Pendant tube
Power wire
from J-box
#10-32 x 5/8"
End screw
(2x)
Fixture wire
Center cover plate
#10-32 x 3/8"
Pan head screws
(2x)
Swivel pendant shown
Exploded view and part call-out
J-box
(by others)
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
These instructions are valid for both PP and PS mounting assemblies. Secure both pendant assemblies to ceiling before attaching fixture head. 1. Remove canopy and allow it to slide down pendant. 2. Refer to power orientation supplementary sheet for power location. 3. Run wiring from j-box down penda...
2 3 32" 52.84 Installation Instructions Vault w/ visor C-Scroll w/ visor Roundel w/ visor These installation instructions are valid with the above Ametrix styles Warning : Before starting any work ensure that all sources of power are turned off. All work must meet local/national codes and be per...
Wiring fixtures to J-box 1. Remove both #6-32 x3/8" Pan head screws and slide center cover plate down. 2. Run power wire from fixture through hub and into center yoke bracket. 3. Secure first fixture to center yoke bracket using #10-32 x5/8" end screw. 1. Mount next center or end pendant dep...
