Cooper Lighting ADY071480 - Manual
Cooper Lighting ADY071480 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Warning
: Before starting any work ensure
that all sources of power are turned off. All
work must meet local/national codes and be
performed by a certified electrician.
Do not
mount fixtures vertically.
Installation Instructions
Vault
C-Scroll
Roundel
These installation instructions are valid with the above Ametrix styles.
1
3
2
Sheet 1 of 3
Large, INDOOR
CR
(C
antilever
, R
emote ballast
)
Visor and Non-Visor
ADY071480 REVA(ECN080352)
Mounting cantilever to structure
J-box
(by others)
#8-32 x3/8"
Set screw
Canopy
Mounting plate
1/4" fastener
(by others)
(4x)
Wiring the fixture
Use additional bracing around
J-box to support J-box.
Exploded view and part call-out
Canopy
#8-32 x3/8"
Set screw
(2x)
Fixture head
#10-32 x1
End screw
(2x)
Yoke end cap
Yoke assembly
1/4-20 x3/4"
Hex bolts
(2x)
1.
Prior to attaching fixture head to cantilever, remove both
#8-32 x3/8" set screws and allow canopy to slide down
pendant.
2.
Feed power wire through wiring holes and using appropriate
fasteners, secure mounting plate to structure.
Use additional
bracing around J-box to support J-box.
Attention:
All large fixtures require additional bracing/structure
around J-box to support fixture.
1.
After pulling wires through wiring holes in mounting plate,
attach appropriate wires and ensure all connections are
properly matched.
2.
Push connections into J-box and secure canopy using both
#8-32 x3/8" set screws.
3.
Refer to supplementary sheet for instructions on aiming and
sealing the fixture.
#8-32 x 3/8"
Set screws
(2x)
Wiring holes
Canopy
Securing fixture to cantilever
1.
To remove fixture head from yoke assembly, remove #10-32
x1 end screw from
one
side.
2.
Remove the #6-32 x 1/4" Flat head screw from the inside of the
yoke arm and remove the yoke end cap.
3.
With fixture head removed, secure yoke to cantilever using
1/4-20 x 3/4" hex bolts.
4.
Run wiring from fixture head, into pendant and out holes in
mounting plate.
#10-32 x1
End screw
Yoke arm
end cap
Fixture head
#6-32 x1/4
Flat head screw
1/4-20 x3/4"
Hex bolts
(2x)
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
