Cooper Lighting ADY071478 - Manual
Cooper Lighting ADY071478 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
1. To aim fixture, loosen both #10-32 x5/8" end screws. When
both indicators are lined up, the slope of the lens face is 40-
degrees. Each subsequent notch is an additional +/- 10-
degrees
2. When fixture head is rotated to desired angle, retighten end
screws to secure the position.
#10-32 x5/8"
End screw
Fixture head
indicator
Yoke arm
indicator
Warning
: Before starting any work ensure
that all sources of power are turned off. All
work must meet local/national codes and be
performed by a certified electrician.
Do not
mount fixtures vertically.
Installation Instructions
Vault
C-Scroll
Roundel
These installation instructions are valid with the above Ametrix styles.
1
3
2
Sheet 1 of 2
Small, INDOOR
CR
(C
antilever
, R
emote ballast
)
Visor and Non-Visor
ADY071478 REV B (ECN80481)
Exploded View and part call-out
#8-32 x3/8"
Set screw
(2x)
Mounting
plate
Wiring the fixture
#10-32 x5/8"
End screw
(2x)
Fixture head
Attention:
All cantilever fixture assemblies require additional
bracing/structure around J-box to support fixture.
J-box
(by others)
Fasteners
(by others)
(4x)
#8-32 x3/8"
Set screw
(2x)
Securing the fixture to structure
1.
Secure fixture head to pendant yoke using both #10-32 x5/8"
end screws.
2.
Feed fixture wire through pendant tube.
3.
Remove both #8-32 x3/8" set screws and slide canopy down
pendant.
4.
Run wires from pendant and j-box through wiring holes in
mounting plate.
5.
Use appropriate fasteners, secure mounting plate to structure
around J-box.
Use additional bracing around J-box to
support fixture.
Aiming the fixture
Use additional bracing around
J-box to support fixture
Fixture
wire
Wiring holes
1.
After securing fixture to structure, attach appropriate wires
and ensure connections are properly matched.
2.
Push wire connections into J-box and cover mounting plate
with canopy.
3.
Secure canopy with both #8-32-3/8" set screws.
#8-32-3/8"
Set screws
(2x)
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
