Cooper Lighting ADY071447 - Manual
Cooper Lighting ADY071447 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
40
1.
To secure yoke to outdoor surface, the fixture head must be
removed. First, remove both #10-32 x 5/8 end screws.
2.
Remove
one
#6-32 x 1/4 screw to remove yoke end cap and
fixture head. Place both fixture head and yoke end cap in a
safe place.
3.
With fixture head and yoke end cap safely stored, secure
yoke to outdoor surface using four(4) appropriate 1/4"
fasteners (by others).
Mounting yoke to outdoor surface
#10-32 x 5/8
End screw (x2)
Yoke end cap
Yoke end cap
1/4 Fasteners
(by others) (x4)
#6-32 x 1/4
screw(x2)
Aiming the fixture
1.
To aim fixture, loosen both #10-32 x.625 end screws. When
the PointGrab
TM
system indicators are lined up, the slope
of the lens face is 40-degrees. Each subsequent notch is
an additional 10-degrees.
2.
When the fixture head is adjusted to the desired angle, re-
tighten end screws to secure the position.
Fixture head
indicator
Yoke arm indicator
#10-32 x 5/8
end screws
#6-32 x 5/8
Socket cap screw
(x3)
#6-32 x 1/2
Socket cap screw
(x2)
1/2" Compression
fitting
1.
To seal fixture head, after installing lamp, all screws and
latches must be secured on door face. Holes above latches
receive the #6-32 x 1/2 socket cap screws. The center hole(s)
receive the longer #6-32 x 5/8 socket cap screw.
2.
Slide 1/2" compression fitting down fixture head wire and
splice wit power feed, ensuring all connections are properly
matched. Seal 1/2" compression fitting to outdoor surface and
ensure a watertight seal.
#10-32 x1
End screw
Fixture head
#6-32 x 5/8
Socket cap screw
(x3)
#6-32 x 1/2
Socket cap screw
(x2)
Yoke
Outdoor J-box
(by others)
1/2" Compression
fitting
Yoke end cap
1/4" Fasteners
(by others)
#6-32 x 1/4
Screw (x2)
Exploded view and part call-out
Wiring and sealing outdoor fixture
Warning
: Before starting any work ensure
that all sources of power are turned off. All
work must meet local/national codes and be
performed by a certified electrician.
Do not
mount fixtures vertically.
Installation Instructions
Vault
C-Scroll
Roundel
These installation instructions are valid with the above Ametrix styles.
1
3
2
Sheet 1 of 2
Large, OUTDOOR
YR (16.5")
(Y
oke mount
, R
emote ballast
)
Visor and Non-Visor
ADY071447 Rev A (ECN070295)
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
