Conair GSC24 - User Manual

Battery-Operated

Fabric Shaver

Model CLS1

Steaming Mitt

Model GPP1

Door Press Pad

Model GDPP1

DUAL VOLTAGE

FABRIC STEAMER

INSTRUCTION BOOKLET

For your safety and continued enjoyment

of this product, always read the instruction

book carefully before using.

MODEL GSC24

SAVE THESE

INSTRUCTIONS

IMPORTANT

FOR HOUSEHOLD USE ONLY

FILLING INSTRUCTIONS

1. Make sure the unit is unplugged.
2. Stand the unit on a table and grasp with

one hand.

3.Pull the water reservoir out, away from the

steamer body.
4. The rubber inlet cover is located on the top

of the water reservoir.
5. Open the inlet cover and fill the reservoir

with water. We recommend that you use only

distilled water (available at grocery stores),

as this will prevent mineral deposits in the

boiler that can reduce performance or clog

the water system.
6. Close the inlet cover and return the

reservoir to its proper position, making sure

that it snaps in place and is secure.

OPERATING

INSTRUCTIONS

1. Fill water reservoir with water (distilled

water is recommended). See directions at left.
2. Confirm the voltage available at each

location before using the appliance. Check that

the dual voltage switch on bottom of unit is in

the correct position for the voltage available.

For use in the U.S.A., the dual voltage switch

should be in the 120 volt position. For use in

several other countries, the voltage selector

switch may need to be slid to the 240 volt

position. An adapter plug may be necessary

when using this appliance in some foreign

countries. If so, plug the steamer into correct

adapter plug for your location and plug

assembly into electrical outlet.
3. Point the steamer head away from you

and anyone else in the room. Press the

Power Button. The Steam Button should light

up red and then turn green when steam is

ready (within approximately 35 seconds). The

garment steamer is now ready to use. Press

the Steam Button to release a continuous

flow of steam from the steam head.
4. Hold steamer by its handle while steaming

garments or while unit is hot.
5. Direct the flow of steam toward garment to

remove wrinkles.
6. To stop the flow of steam, press the Steam

Button again.
7. Press the round Steam Head Adjustment

Button on the hinge to unlock the steam head

for angle adjustment.

8. Press the Power Button to turn off.
9. Unplug the device when it is not in use.

STEAMING TIPS

1. Hang your garment or fabric.

NOTE:

Avoid

using metal clothes hangers, if possible.
2. Pass the steam jets about an inch above

the fabric where the wrinkles are. It may

take a few passes to remove the wrinkles

completely.
3.

CAUTION: When hanging garment on a

door while steaming, be careful not to

damage the door with steam.

4. First test unit on an inconspicuous area of

the item to be steamed, to ensure fabric can

tolerate the effects of steam. If there is no

evidence of damage, you can proceed to use

the steamer on that item.
5. When steaming, always keep the unit in

motion and about one inch from the surface

of the item being steamed to avoid potential

damage. Do not continuously hold steamer

over an area or let steamer jets directly touch

the fabric, as this as this can cause damage,

including shrinkage, melting, or color shift on

certain types of material.
6. In the case of heavier, durable fabrics,

such as wool coats or bedding, slower

passes with the steamer may be necessary

to achieve desired results.
7. After use, unplug steamer and empty

any remaining water from the tank to avoid

leakage.

KILLS 99.9% OF BACTERIA*

1. Position the garment steamer’s nozzle at a

minimum distance of 0.5 inch (1.3 cm) from

material to be treated.
2. Remain steaming in this position for 2

minutes, then move to the next area to be

treated and repeat.

* Bacteria reduction rate was measured after

exposing the tested samples to steam for 2

minutes at a ½-inch distance from the garment

steamer head. Testing was performed on E. coli.

CONAIR GARMENT

STEAMING ACCESSORIES

(sold separately)

LIMITED ONE-YEAR WARRANTY

(U.S. AND CANADA ONLY)

Conair will repair or replace (at our option)

your unit free of charge for 12 months from

the date of purchase if the appliance is

defective in workmanship or materials.
To obtain service under this warranty, return

the defective product to the service center

listed, together with your purchase receipt.
California residents need only provide proof of

purchase and should call 1-800-3-CONAIR

for shipping instructions. In the absence of a

purchase receipt, the warranty period shall be

12 months from the date of manufacture.

ANY IMPLIED WARRANTIES, OBLIGATIONS,

OR LIABILITIES, INCLUDING BUT NOT

LIMITED TO THE IMPLIED WARRANTY OF

MERCHANTABILITY AND FITNESS FOR A

PARTICULAR PURPOSE, SHALL BE LIMITED

IN DURATION TO THE 12-MONTH DURATION

OF THIS WRITTEN, LIMITED WARRANTY.

Some states do not allow limitations on how

long an implied warranty lasts, so the above

limitations may not apply to you.

IN NO EVENT SHALL CONAIR BE LIABLE

FOR ANY SPECIAL, INCIDENTAL, OR

CONSEQUENTIAL DAMAGES FOR BREACH OF

THIS OR ANY OTHER WARRANTY, EXPRESS

OR IMPLIED, WHATSOEVER.

Some states do not allow the exclusion

or limitation of special, incidental, or

consequential damages, so the above

limitation may not apply to you.
This warranty gives you specific legal rights,

and you may also have other rights, which

vary from state to state.

Service Center

Conair LLC

Service Department

7475 N. Glen Harbor Blvd.

Glendale, AZ 85307

For information on any Conair

®

product, call

1-800-3-CONAIR

or visit us on the web at

www.conair.com

Please register this product at

register.conair.com

©2022 Conair LLC

7475 N. Glen Harbor Blvd.

Glendale, AZ 85307

Made in China

22PA084143

IB-17710

IMPORTANT SAFETY

INSTRUCTIONS

When using electrical appliances, especially

when children are present, basic safety

precautions should always be taken,

including the following:

READ ALL

INSTRUCTIONS

BEFORE USING

DANGER –

Any appliance is

electrically live even when the switch is off.
To reduce the risk of death by electric shock:
1.

Always unplug this appliance from the

electrical outlet immediately after using

and before cleaning.

2. Do not place or store appliance where it

can fall or be pulled into a tub or sink.
3. Do not place in or drop into water or

other liquids.
4. If an appliance falls into water, unplug it

immediately.

Do not reach into the water.

WARNING –

To reduce the risk of

burns, electrocution, fire, or injury to persons:
1.

This appliance should never be left

unattended when plugged in.

2. This appliance is not a toy! Keep away

from children.
3. Close supervision is necessary when

this appliance is used by or near children

or individuals with certain disabilities.

Unsupervised use could result in fire or

personal injury.
4. Use this appliance only for its intended

use as described in this manual. Do not

use attachments not recommended by the

manufacturer. Attachments sold separately.
5.

Never operate this appliance if it has a

damaged cord or plug, if it is not working

properly, or if it has been dropped,

damaged, or dropped into water. Do not

attempt to repair the appliance. Incorrect

reassembly or repair could cause a risk

of fire, electric shock, or injury to persons

when the appliance is used. Return the

appliance to an authorized service center

for examination and repair.

6. Keep the cord away from heated surfaces.

Do not allow cord to contact heated surfaces.

Do not pull or twist cord. Let appliance cool

completely before putting away. Loop cord

loosely around appliance when storing.
7. To reduce the risk of electric shock, this

appliance has a polarized plug (one blade

is wider than the other). As a safety feature,

this plug will fit in a polarized outlet only one

way. If the plug does not fit fully in the outlet,

reverse the plug. If it still does not fit, contact

a qualified electrician. Do not attempt to

defeat this safety feature.
8. Never drop or insert any object into

any opening.
9. Do not use outdoors or operate where

aerosol (spray) products are being used or

where oxygen is being administered.
10. Do not handle plug with wet hands.
11. Surfaces of this appliance may be hot

when in use. Do not let heated surfaces

touch eyes or skin.
12. Do not place the steam nozzle directly on

any surface or on the appliance power cord

while it is hot or plugged in.
13. Unplug this appliance before filling

or emptying.
14. Do not operate steamer without properly

filling the water container with distilled water.
15. Never yank cord to disconnect from

outlet; instead, grasp plug and pull to

disconnect.
16. Burns could occur from touching hot

surfaces, hot water, or steam. Use care when

removing water reservoir or when you turn

a steam appliance upside down – there may

be hot water in reservoir. Always position

steamer with head away from you and any

other person when turning on.
17. To reduce likelihood of circuit overload,

do not operate another high-wattage

appliance on the same circuit.
18. Never steam clothes you, or someone

else, are wearing.

19. Do not hold hand in front of steam.
20. When emitting steam, appliance may

cause burns if it is used too close to the skin

or eyes, or if it is used incorrectly. To reduce

the risk of contact with hot water emitting

from the steam vents, test appliance before

use by holding it away from the body.
21. We recommend you do not use an

extension cord to operate this appliance. If

an extension cord is absolutely necessary, a

15 ampere-rated cord should be used. Cords

rated for less amperage may overheat. Care

should be taken to arrange the cord so that

the cord cannot be pulled or tripped over.

DUAL VOLTAGE

Be sure dual voltage selector is in correct

voltage position before operating. Before

plugging in, read the information about dual

voltage operation contained in this manual.

This appliance was set at the factory to

operate at 120 volts. Refer to the instructions

below for conversion to 240 volt operation
This is a 120/240V dual voltage appliance

and may be used in the U.S.A. and abroad

without an electricity converter. For use

in the U.S.A., the voltage selector switch

should be in the 120 volt position. For use in

several other countries, the voltage selector

switch may need to be placed in the 240

volt position. Confirm the voltage available at

each location before using the appliance. An

adapter plug may be necessary when using

this appliance in some foreign countries. If

so, plug the steamer into correct adapter

plug for your location and plug assembly into

electrical outlet.

FEDERAL COMMUNICATIONS

COMMISSION NOTICE

WARNING:

Changes or modifications to this

unit not expressly approved by the party

responsible for compliance could void the

user’s authority to operate the equipment.

This device complies with Part 15 of the FCC

Rules. Operation is subject to the following

two conditions: (1) This device may not cause

harmful interference, and (2) This device must

accept any interference received, including

interference that may cause undesired

operation.

NOTE:

This equipment has been tested and

found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to

provide reasonable protection against harmful

interference in a residential installation.

This equipment generates, uses and can

radiate radio frequency energy and, if not

installed and used in accordance with the

instructions, may cause harmful interference

to radio communications. However, there is

no guarantee that interference will not occur

in a particular installation. If this equipment

does cause harmful interference to radio or

television reception, which can be determined

by turning the equipment off and on, the user is

encouraged to try to correct the interference by

one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the

equipment and receiver.

• Connect the equipment into an outlet on a

circuit different from that to which the receiver

is connected.

• Consult the dealer or an experienced radio/TV

technician for help.

SUPPLIER’S DECLARATION

OF CONFORMITY

Brand:

Conair

®

Model No.:

GSC24

Description:

Handheld Steamer

Responsible Party:

Conair LLC,

1 Cummings Point Road, Stamford, CT 06902

(203) 351-9000

Standards:

FCC Part 15 Subpart B, ANSI

C63.4-2014

This device complies with Part 15 of the FCC

Rules. Operation is subject to the following

two conditions:

(1) This device may not cause harmful

interference, and (2) This device must

accept any interference received, including

interference that may cause

undesired

operation.

DATE OF ISSUE: 05/26/2022

Power Button

Steam Button

Steam Head
Adjustment
Button to
adjust head
position

Power Cord

Steam Head

Removable
Water Reservoir

Dual Voltage switch under

bottom of steamer

GETTING TO KNOW YOUR STEAMER