Comfort Glow RFP28TC - Manual
Comfort Glow RFP28TC – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – WARNINGS; DANGER: Carbon monoxide
- Page 3 – OWNER’S MANUAL; PRODUCT IDENTIFICATION; American National Standards Institute, Inc.; UNPACKING; Remove heater from carton.; Operation; CAUTION: Do not remove the
- Page 4 – W A R N I N G : A l w a y s h a v e; Figure 4 - Assembling Heater; ASSEMBLY; ASSEMBLING HEATER; Removing Front Panel Of Heater; Figure 2 - Removing Front Panel of Heater; Installing Log; For easier installation, lay heater on
- Page 5 – Repeat steps 1 through 6 for other side.; Figure 6 - Assembling Brass Trim; Continued; Figure 7 - Attaching Brass Trim to Heater
- Page 6 – Confined and Unconfined Space; per; Unusually Tight Construction
- Page 7 – Determining if You Have a Confined or Unconfined Space
- Page 8 – Figure 8 - Ventilation Air from Inside Building; VENTILATION AIR; W A R N I N G : R e w o r k w o r k -; Ventilation Air From Outdoors; Do not provide openings for; Figure 9 - Ventilation Air from Outdoors
- Page 9 – For convenience and efficiency, install heater; INSTALLATION; CHECK GAS TYPE; Only use optional mantel; LOCATING HEATER
- Page 10 – Mounting Bracket; Figure 12 - Mounting Bracket Location; Attaching To Wall Stud; Marking Screw Locations; WARNING: Maintain minimum; Figure 13 - Mounting Bracket Clearances; Attaching To Wall Stud Method
- Page 11 – Mark screw locations on wall.; Fold wall anchor as shown in Figure 14.; Figure 14 - Folding Anchor
- Page 12 – Securing Hearth Base to Floor; If securing to a concrete floor, drill a 1; Figure 18 - Attaching Heater to Hearth Base; Stand heater up on base.; WITH; Assembling Mantel; Only use the optional man-; WARNING: If installing the
- Page 13 – CAUTION: Avoid damage to; Figure 21 - Gas Connection; Burner bracket; CAUTION: Never connect; Installing Mantel to Heater
- Page 14 – Test Pressures In Excess Of 1/2 PSIG; WARNING: Never use an open; Figure 23 - Checking Gas Joints; Correct all leaks at once.
- Page 15 – Shutting Off Heater; If pilot does not stay lit, refer; CAUTION: Do not try to adjust
- Page 16 – Turn control knob counterclockwise; Figure 26 - Correct Pilot Flame Pattern; Figure 27 - Incorrect Pilot Flame Pattern; WARNING: If yellow tipping; • turn heater off (see To Turn Off Gas to
- Page 17 – TROUBLESHOOTING; OBSERVED PROBLEM
- Page 18 – REMEDY; nance, page 20) or replace burner orifice
- Page 19 – POSSIBLE CAUSE; IMPORTANT
- Page 20 – SPECIFICATIONS; When Gas Pressure Is Too Low; CABINET; Air Passageways; WARNING: Turn off heater
- Page 21 – PARTS UNDER WARRANTY; PARTS CENTRALS
- Page 23 – PARTS LIST; PART NUMBER
- Page 24 – PRESTIGE MANTEL; ACCESSORIES; FAN KIT
- Page 25 – NOTES
- Page 26 – KEEP THIS WARRANTY; WARRANTY INFORMATION; INTERNATIONAL; LIMITED WARRANTY
Save this manual for future reference.
VENT-FREE PROPANE/LP
GAS RADIANT FLAME
®
HEATER
OWNER’S OPERATION AND INSTALLATION MANUAL
®
RFP28TC
14,000 to 28,000 Btu/Hr
with Thermostat
"C" Model
Shown with Optional
Mantel featuring
Built-in Base
WARNING: If the information in this manual is
not followed exactly, a fire or explosion may
result causing property damage, personal in-
jury, or loss of life.
— Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
— WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not
use any phone in your building.
• Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
• If you cannot reach your gas supplier, call
the fire department.
— Installation and service must be performed by
a qualified installer, service agency, or the gas
supplier.
This appliance may be installed in an aftermarket* manufactured (mobile) home, where not prohibited
by state or local codes.
* Aftermarket: Completion of sale, not for purpose of resale, from the manufacturer
W A R N I N G : T h i s i s a n
unvented gas-fired heater. It
uses air (oxygen) from the
room in which it is installed.
Provisions for adequate com-
bustion must be provided. Re-
fer to page 2 of this manual.
WARNING: Improper instal-
lation, adjustment, alteration,
service, or maintenance can
cause injury or property dam-
age. Refer to this manual for
correct installation and op-
erational procedures. For as-
sistance or additional infor-
mation consult a qualified in-
staller, service agency, or the
gas supplier.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 103509 VENT-FREE RADIANT FLAME ® HEATER 1. This appliance is only for use with thetype of gas indicated on the rating plate.This appliance is not convertible for usewith other gases. 2. Do not place propane/LP supply tank(s)inside any structure. Locate propane/LP supply tank(s) outdoors. 3. If you...
3 103509 OWNER’S MANUAL ASDFKIGLFJI alskdidkoemkgo dkirlnfgpd'fASDFKIGLFJI alskdidkoemkgo dkirlnfgpd'f ASDFKIGLFJI alskdidkoemkgo dkirlnfgpd'fASDFKIGLFJI alskdidkoemkgo dkirlnfgpd'f ASDFKIGLFJI alskdidkoemkgo dkirlnfgpd'fASDFKIGLFJI alskdidkoemkgo dkirlnfgpd'f ASDFKIGLFJI alskdidkoemkgo dkirlnfgpd'f...
4 103509 VENT-FREE RADIANT FLAME ® HEATER W A R N I N G : A l w a y s h a v e burner shield and screen in placebefore operating heater. This pre-vents excessive temperatures onheater surfaces. Failure to position the parts inaccordance with these diagramsor failure to use only parts spe-cifically ap...
