Coleman 9992-449 - Manual
Coleman 9992-449 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Pipe Sealant; Liquid Propane Gas Conversion Instructions
- Page 3 – * socket set with extension can also be used.
- Page 4 – Remove the screws from the bottom of the heat
- Page 5 – Disconnect the right side flexline from the
- Page 6 – You are now ready to install
- Page 7 – Remove the NG regulator from the main gas; Note: For the following steps, the supplied pipe; Attach the main regulator hose assembly to the
- Page 8 – Converting the Rear Infrared Burner to LP
- Page 9 – Label the Grill; Note: At the completion of the; All codes must be followed.
- Page 10 – NOTES
Liquid Propane Conversion Kit
IMPORTANT
Read this document carefully before attempting installation
of this conversion kit. These instructions should be left with
the consumer for future reference.
For the following Coleman® Gas Barbecue Grills:
8350 Series (M/N 9992-648)
WARNING
• This Liquid Propane conversion Kit must be installed only by a quali-
fied service technician.
• Gas supply system must be installed in accordance with the U.S.
National Fuel Gas Code.
• This appliance and its individual shut off valve must be disconnected
from the gas supply piping system during any system pressure test in
excess of 1/2 PSI (3.5 KPA).
• Use a system manual shut off valve to shut off the gas supply to this
gas appliance before continuing with installation procedures.
WARNING
• If the information in this document is not followed exactly, a fire or
explosion may result causing property damage, personal injury or loss
of life. Read the Coleman®
Gas Barbecue Use, Care & Assembly
Manual With Grill Lighting Instructions, before attempting installation
of this conversion kit.
WARNING
• TURN OFF THE GAS SUPPLY!
DO NOT attempt to install this Natural Gas Conversion Kit
while the barbecue is in operation or is hot.
Installation and provision for combustion and ventilation air
must conform with the
National Fuel Gas Code, ANSI Z223.1,
or
CAN/CGA-B149.1, Natural Gas Installation Code, or
CAN/CGA-B149.2, Propane Installation Code.
WARNING
A liquid propane tank, not connected for use with this gas barbecue,
shall not be stored in the vicinity of this or any other appliance.
Note: These instructions apply to
grill Model 8350 Series. The parts
included are designed for your
specific grill. The illustrations may
differ slightly from model to
model.
Turn off and disconnect from Natural Gas
service line prior to servicing grill.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Item No. Qty Description 1 9992-4421 1 Main Burner Valve & Manifold Assembly (L.P.) 8350 2 47310103 1 Main Regulator Hose Assembly (L.P.) 3 08006001 1 Rear IR L.P. Orifice (8350) 4 08138381 1 Connector 3/8" FNPT x 3/8" MFLR 5 49900004 1 Pipe Sealant 6 9992-462 1 LP Conversion Sticker Liq...
Tools Needed: Phillips head screwdriver1/4" nut driver *9/16" wrenchAdjustable wrench Fig 4 Fig 1 Fig 2 Fig 3 Rear Heat Shield Screws Heat Tents Screws * socket set with extension can also be used. Be sure gas supply is off, the knobs are in the offposition and the grill is cool. 1. Remove c...
Fig 5 Fig 6 Side Screws (Repeat on left side) Screws under lip Fig 8 Fig 7 Tabs 5. Remove the screws from the bottom of the heat shield, holding the front heat shield in place. Thescrews are located under the bottom lip of theshield (Fig. 5). 6. Remove the side heat shield screws located under the b...
