COBY DP740 IB - Manual

20

12

13

16

17

19

14

GETTING STARTED

15

GETTING STARTED

COBY Electronics Corp.

56-65 Rust Street

Maspeth, NY 11378

www.cobyusa.com

www.ecoby.com

INSTRUCTION MANUAL

Please read this manual carefully before operation

DP740

WARNING:

To prevent

fi

re or shock hazard, do not expose this device to rain or moisture. Dangerous high

voltage is present inside the enclosure. Do not open the cabinet.

CAUTION:

To prevent electric shock, match wide blade of plug to wide slot of outlet and fully

inser t.

Protect your hearing:

Hearing experts advise against the constant use of personal stereos

played at high volume. Constant exposure to high volumes can lead to hearing loss. If you should
experience ringing in the ears or hearing loss, discontinue use and seek medical advice.

FCC Statement:
t

his device complies with Par t 15 of the FCC Rules. Operation is subject to the following

two conditions:
(1) This device may not cause harmful inter ference, and
(2) This device must accept any inter ference received, including inter ference that may
cause undesired operation.

Note:

This equipment has been tested and found to comply with the limits for Class B digital
devices, pursuant to Par t 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful inter ference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful inter ference to radio
communications. However, there is no guarantee that inter ference will not occur in a par-
ticular installation. If this equipment does cause harmful inter ference to radio or televi -
sion reception, which can be determined by turning the equipment of f and on, the user is
encouraged to tr y to correct the inter ference by one or more of the following measures:

- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dif ferent from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/ T V technician for help

Use of shielded cable is required to comply with Class B limits in Subpar t B of Par t 15 of
the FCC rules.

Do not make any changes or modi

fi

cations to the equipment unless other wise speci

fi

ed

in the manual. If such changes or modi

fi

cations should be made, you could be required

to stop operation of the equipment.

Please make sure that the items shown below are included in the package. Should
an item be missing, please contact the local retailer from which you purchased this
product.

4

2

1

1.

3.

AC Adapter x 1

Manual x 1

2.

Kickstand and Screw x 1

4.

•
•
•
•
•
•
•

3

7

″

Widescreen Digital Photo Frame

7" widescreen TFT LCD color display

Displays JPEG, JPG photo files

Photo slideshow mode

Calendar and clock with alarm timer

SD, MMC, MS, XD card slot

Full-size USB port for use with flash memory drives

Wall-mountable design with detachable stand

DP Frame x 1

180

2

3

4 5

1

7
8
9

6

10

4

DP740

11

1.

-/+

Button

Press to move the cursor left/right in
menu setting and also can be used to
turn pages in the full screen display.

2. Enter/Slidshow

Press for enter during menu selection.
In photo (full-screen) display mode,
press and hold this button to start / stop
photo slideshow.

3. Change View

Press this button to shift between the
view modes Crop to Fill, Full Screen
and Fit to Screen in photo (full-screen)
display mode.
In Calendar Mode: press this button
to change the calendar mode.

4. Menu

Press for exit.
On the Main Menu Screen, press this button to
move the cursor to the memory device list.

5. Down/Up button

Press to move the cursor down/up during
menu selection.
On the Main Menu Screen, select the desired
memory device, and then press Enter button to
confirm.

6. Card slot

Connect the SD/MMC/MS/XD card.

7. Power switch

To turn the photo frame on/off.

8. Full-size USB port

To connect with USB flash drives..

9. Mini-size USB port

To connect with computer.

10. Power Jack

Connect with the power source.

11. TFT Display.

Function Buttons

GETTING STARTED

Installing a Memor y Card

Your picture frame suppor ts the following types of memory cards:

Simply inser t the memory card of your choice into its corresponding card slot lo -
cated on the left panel of the photo frame. Take care to orient the card in the proper
direction.

Getting photos and

fi

les onto your picture frame for viewing couldn’t be easier!

Powering your Digital Picture Frame

Your Picture Frame should be connected to
an AC 100-240V wall outlet.

Using the supplied power adapter,
plug one end of the adapter into
your photo frame’s Power In jack
and plug the other end into an AC
100 -240V wall outlet.

Do not connect the power plug to a power outlet other than that
which is indicated here or on the label as this may result in the risk
of

fi

re or electric shock.

Do not handle the power plug with wet hands. Doing so may cause
electric shock.

Use only AC adapters of the type speci

fi

ed here. Failure to do so

may cause a

fi

re or damage the player.

•

•
•
•
•
•

XD -Picture (XD)

Secure Digital (SD)

Multi Media Card (MMC)

Memory Stick (MS)

USB Flash Storage Drive

DC OUT: 5V 1A

Turning Your Photo Frame On/Of f

To turn your photo frame on, set the Power Switch to the “On” position.

To turn your photo frame of f, set the Power Switch to the “Of f ” position.

•
•

USB Port

(computer)

USB Port (mini)

Connecting to a Computer

Connect the photo frame to your computer with

USB cable. Upon connection:

•

Your computer will automatically recognize

installed in

your photo frame.

representing your installed memory cards will appear

as “Removable Disk ” when you open “My Computer”.

Icons

a

the memory cards

Make sure that there’s no USB flash drive connecting to the DP frame
before connecting the DP frame to a computer.

Main Menu Screen

The demo slideshow will automatically start in approximately 8 seconds if you don’t press
any button.

Photo

Select the Photo icon on the main menu screen and press Enter button to enter the Photo mode.

If your photo frame is set to slideshow in photo setup, it will display the photo in slideshow
mode.You can press Menu button to enter thumbnail mode, and press Menu button again to exit.
If your photo frame is set to thumbnail in photo setup, it will display in thumbnail mode. In this
mode, to display a photo(full screen), use the direction button to select a thumbnail and press
enter button to confirm.

The Photo List will display suppor ted Photo

fi

les, only.

Your photo frame can display baseline JPEG / JPG

fi

les.

CALENDAR

To view time and data, select Calendar on the main menu screen and press Enter button to
confirm. Then the calendar will shown as below.

1. You can adjust the time and data in Calendar setup menu, please refer to Calendar setup in
the Setup menu.
2. There are three display mods available, you can press Change View button to select the
desired mode.
3. Press “-/+” button to view the previous/next month.
4. If there are available pictures, it will be displayed on the right of the window in slideshow mode,
press Up/Down button to turn the pictures.
5. Press Menu button to exit.

SETUP

Photo Setup

Calendar

Display Mode

Display Ratio

Slideshow Duration

Transition Effect

Slideshow Repeat

Sets the photo display mode for
entering the Photo Mode from the
Main Menu.

Slideshow

Fit to Screen

5Sec.

Random

On

Sets the photo display ratio.

Sets the time interval of slideshow
photos.

Sets the photo slideshow effect.

Sets the photo slideshow repeat
function on/off

Calendar Setup

Display Mode

Sets the Calendar display mode

Sets the Clock Mode

To set the Clock Time:

Press the UP / DOWN

button to select the the time, and press the
LEFT/RIGHT button to select the desired time.

To set an Alarm Time:

Press the UP / DOWN

button to select the Off/On and time and press the
LEFT/RIGHT button to select the desired time and
On.

To delay the alarm timer,

when the alarm timer

sounds, press the ENTER button to turn it off
completely, press any other buttons to delay it. The
alarm timer will sound again 9 minutes, 18 mintues
and 27 minutes later. The alarm will then turn off
automatically.

24-Hour

Mon to Fri.

On

Repeat

Calendar+

Time+Slideshow

Set Date

Clock Mode

Set Time

Alarm Time

Alarm Frequency

Alarm Set

Snooze

Sets the Alarm Frequency

Sets the Alarm

Sets Snooze Mode

To set Date:

Press the UP / DOWN button to select

the number of the date and year, and press the
LEFT/RIGHT button to adjust.

System Setup

Resets all settings to their factory default state.

Sets the menu language of the photo frame.
Sets the brightness of the screen.
Sets the Contrast of the screen.
Sets the Saturation of the screen.

Sets the Hue of the screen.
Sets the power on

Sets the power off
Sets the auto boot/shut time for the photo frame.
1. Make sure the Power switch on the DP frame is set to ON.
2. Press the UP/DOWN button to select On / Off and time.
3. Press the LEFT/RIGHT button to select the desired time..

Sets the Auto-Power On / Off Frequency.

SETUP

language
Brightness

Conrast

Saturation

Hue

Power On

Reset

Power Off

Auto boot time

Auto Shut time

Auto-power
frequency

7

7

7

50
Off

Off

Mon. to Fri.

Changing View

Press the CHANGE VIEW button to change between the screen ratio modes Full Screen, Fit to Screen and Crop
to Fill.
To view the previous/next photo, press Down/Up button.

Zoom

To zoom in the pictures, press “+” button.

Each successive press of “+” button will change the level of magni

fi

cation as shown below:

125%

150%

175%

200%

225%

250%

ZOOM OFF

KICKSTAND

Turn the screw to the right to tighten the kickstand.

Attach the kickstand to the DP frame.

1

2

Using the Kickstand

The player does not turn on.

Make sure the unit has been powered on manually (i.e., the Power Switch has
been physically set to the ON position).

Ensure that the power cord has been properly connected to the power outlet.

•

•

If you have a problem with this device, please read the troubleshooting guide
below and check our website at www.cobyusa.com for Frequently Asked
Questions (FAQs) and firmware updates. If these resources do not resolve the
problem, please contact Technical Support.

ADDRESS

COBY Electronics Technical Support
150 Knowlton Way
Savannah, GA 31407

EMAIL

[email protected]

WEB

www.cobyusa.com

PHONE

800-727-3592: Weekdays 8:30AM–9:00PM EST
Saturdays 9:00AM–5:30PM EST
718-416-3197: Weekdays 8:00AM–5:30PM EST

I cannot select a memor y card.

Ensure that a memory card has been installed.

Ensure that the memory card is properly installed.

Ensure that the memory card is not defective.

•
•
•

•

The alarm does not work.

Make sure the Alarm Setting is set properly in Calendar Setup in Setup Menu.

TROUBLESHOOTING

UNIT VIEW

Note: You can only press the “-” button to zoom out the amplified pictures, but can’t zoom out the
original pictures.

PACKAGE CONTENTS......................................................................................................................

............................9

UNIT VIEW....................................................................................................................................................................11

Function Buttons.....................................................................................................................................................11

KICKSTAND..................................................................................................................................................................18
Using the Kickstand................................................................................................................................................18

GETTING STARTED.....................................................................................................................................................12
Installing a Memory Card.........................................................................................................................................12
Powering your Digital Picture Frame........................................................................................................................12
Turning Your Photo Frame ON/OFF..................................................................................................................... ..13
Connecting to a computer........................................................................................................................................13
Photo...........................................................................................................................................................................14
Change View............................................................................................................................................................14
Zoom........................................................................................................................................................................14

CALENDAR...................................................................................................................................................................15

PRECAUTIONS..............................................................................................................................................................2

IMPORTANT SAFETY INSTRUCTION......................................................................................................................... 4

SETUP ..........................................................................................................................................................................16
Photo Setup.................................................................................................................................................................................................................................16
Calendar Setup...........................................................................................................................................................................................................................16
System Setup...............................................................................................................................................................................................................................17

TROUBLE SHOOTING...................................................................................................................................................19

SPECIFICATION..........................................................................................................................................................20

TABLE OF CONTENTS..................................................................................................................................................8

FEATURES...................................................................................................................................................................10

..

P/N: 907-DP74-0S01-00R

Speci

fi

cations and manual are subject to change without prior notice.

Display Type

7″ Full-Color

TFT LCD

Display Resolution

800×480

Memory

MS Card

SD/MMC/XD Card

Full-size USB

Photo Format

JPEG

USB Host

USB 2.0 High-Speed

Power Supply

DC 5V, 1A,

100-240V AC Adapter

JPG

SPECIFICATION

Inserted: A card icon that is in-color indicates that a memory card has been
inserted(installed) in the corresponding slot.
No card: A card icon that is grayed-out indicates that a memory card has not been
installed in the corresponding slot and is not available for use.
Selected: A higlighted frame indicates that the card slot is selected. Only card slots with
an installed memory card may be selected.

Upon turning on the power, your photo frame will display the “Main menu” screen shown below:

Press the MENU button and then press the UP/DOWN button to select an available card.

To the amplified picture(only), press Up/Down button to move it up/down;
press and hold “-/+” button to move it left/right.

English