Cisco VIP-4R/4T - Manual

Cisco VIP-4R/4T

Cisco VIP-4R/4T – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
49 Page 49
50 Page 50
51 Page 51
52 Page 52
53 Page 53
54 Page 54
55 Page 55
56 Page 56
57 Page 57
58 Page 58
59 Page 59
60 Page 60
61 Page 61
62 Page 62
63 Page 63
64 Page 64
65 Page 65
66 Page 66
67 Page 67
68 Page 68
69 Page 69
70 Page 70
71 Page 71
72 Page 72
73 Page 73
74 Page 74
Page: / 74

Table of Contents:

  • Page 2 – Table of Contents; This configuration note includes the following sections:; Note; VIP Port Adapter Functions, page 29; If You Need More Configuration Information
  • Page 3 – UniverCD; Versatile Interface Processor Functions; Caution
  • Page 5 – VIP Software Prerequisites; . Detailed information about the latest Cisco IOS release can be; VIP Hardware Prerequisites
  • Page 10 – VIP Port Adapter Hardware Configuration Overview; Figure 7; Following are the VIP port adapters by interface type:
  • Page 11 – attempt to install other port adapters on the VIP motherboard.; VIP Microcode Overview; List of Parts and Tools
  • Page 12 – Safety Guidelines; Electrical Equipment Guidelines; Disconnect all power and external cables before moving a chassis.; Telephone Wiring Guidelines; Never install telephone wiring during a lightning storm.; Preventing Electrostatic Discharge Damage; Following are guidelines for preventing ESD damage:
  • Page 13 – measurement should be between 1 and 10 megohms.
  • Page 16 – VIP Installation; module. Port adapters are not available as FRUs.; Removing an Interface Processor Filler
  • Page 17 – erroneous system error messages indicating a board failure.
  • Page 19 – Checking the Installation and Verifying VIP Status; Checking the VIP Installation
  • Page 20 – Verify that the VIP is installed correctly as follows:
  • Page 21 – Verifying VIP Status Using show Commands
  • Page 23 – Upgrading VIP Microcode; Flash memory for the new image.
  • Page 24 – An example of the copy tftp:filename command follows:
  • Page 25 – Router# show controllers cbus
  • Page 26 – Upgrading and Replacing DRAM SIMMs; provider. Both DRAM SIMMs are replaced for all upgrades.
  • Page 27 – Following is the procedure for replacing or upgrading DRAM SIMMs.; Orientation of DRAM SIMMs (U1 and U2) on VIP Motherboard
  • Page 28 – on the center of the SIMMs. Handle each SIMM with care.
  • Page 29 – VIP Port Adapter Functions; R Port Adapter; R Port Adapter, Faceplate View
  • Page 30 – Token Ring Overview; Token Ring Specifications and Physical Connections
  • Page 31 – VIP-4R/4T Installation and Configuration 31; Star
  • Page 32 – Token Ring Connection Equipment
  • Page 33 – Token Ring Distance Limitations; R Port Adapter LEDs
  • Page 34 – R Port Adapter Receptacles, Cables, and Pinouts; R Port Adapter Receptacles and Cables; Token Ring Type 1 Lobe Cable Connectors, DB-9 and MAU Types
  • Page 35 – VIP-4R/4T Installation and Configuration 35; R Port Adapter Receptacle Pinout; Attaching 4R Port Adapter Interface Cables; Ground
  • Page 36 – on each port adapter’s faceplate.; Token Ring Interface Cable Connections; Configuring the 4R Interfaces; setup
  • Page 37 – Using the EXEC Command Interpreter; At the EXEC prompt for a router, enter the enable command:; The EXEC prompts you for a privileged level password:
  • Page 39 – Using the Configure EXEC Command
  • Page 40 – and dual 4R configurations are currently not available.
  • Page 43 – Basic Configuration Guidelines
  • Page 44 – Write the new configuration to memory by entering the following:; Enter quit to exit Configuration mode:; Checking the Configuration; Router# show configuration; To display and check all interfaces, enter the following command:; Router# show interfaces
  • Page 45 – T Port Adapter; T Port Adapter, Faceplate View; Synchronous Serial Overview
  • Page 47 – T Port Adapter Specifications
  • Page 50 – T Port Adapter LEDs; LEDs on the 4T Port Adapter (Horizontal Orientation Shown)
  • Page 51 – VIP-4R/4T Installation and Configuration 51; Table 9 lists the 4T port adapter LEDs and their indications.; Serial Port Adapter Receptacles and Cables; to which it is connected.
  • Page 53 – Serial Port Adapter Cable Pinouts
  • Page 55 – VIP-4R/4T Installation and Configuration 55
  • Page 57 – VIP-4R/4T Installation and Configuration 57
  • Page 59 – Attaching 4T Port Adapter Interface Cables; Correct
  • Page 60 – Configuring the 4T Interfaces
  • Page 63 – VIP-4R/4T Installation and Configuration 63
  • Page 65 – Setting the Clock Rate
  • Page 66 – Following are the acceptable clockrate settings:; Inverting the Clock Signal; Router# configure terminal
  • Page 67 – Configuring CRCs; Replacing Port Adapter Cables; Router# show controller cbus
  • Page 68 – Locate and remove the adapter cable to be replaced.; Enter Configuration mode again and bring the port back up.
  • Page 70 – Write the new configuration to memory, as follows:; Configuring Interfaces
  • Page 71 – Write the new configuration to memory as follows:
  • Page 72 – Using Show Commands to Verify the VIP Status
  • Page 74 – Cisco Information Online; You can access CIO in the following ways:; To obtain general
Loading the manual

1

Customer Order Number:

Copyright © 1995

Cisco Systems, Inc.

All rights reserved.

Documentation Part Number:

VIP-4R/4T Installation and Configuration

Product Number VIP-4R/4T(=)

This configuration note is a standalone publication that provides instructions for installing,
configuring, and maintaining the Versatile Interface Processor (VIP) in your Cisco 7000 series and
Cisco 7500 series routers.

The VIP operates with the CxBus in the Cisco 7000 series and CyBus in the Cisco 7500 series, and
requires that the host Cisco 7000 series and Cisco 7500 series router is running Cisco Internetwork
Operating System (Cisco IOS) Release 11.1(1) or later, or a Cisco-approved beta version of
Cisco IOS Release 11.1.

Note

The entire VIP card, with port adapters installed, is a field-replaceable unit (FRU). Individual

port adapters are not available as spare parts.

Included are steps for VIP hardware installation and basic VIP configuration steps and examples for
configuring the individual interfaces on a new VIP. Also included are maintenance procedures for
upgrading user-configurable VIP components.

This publication has two main sections:

•

Versatile Interface Processor Functions, page 3—this section discusses general VIP features,
maintenance considerations, and overall functions

•

VIP Port Adapter Functions, page 29—this section contains subsections that discuss each port
adapter and its specific features, configuration and connection requirements, and functions

You need only refer to the information that is specific to your VIP port adapter configuration or that
applies to specific VIP functionality. A table of contents is included on page 2 so you can more easily
find what you need.

Note

For complete descriptions of interface subcommands and the configuration options available

for VIP-related interfaces, and which support VIP functionality, refer to the section “If You Need
More Configuration Information.”

DOC-782881=
78-2881-01

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Table of Contents; This configuration note includes the following sections:; Note; VIP Port Adapter Functions, page 29; If You Need More Configuration Information

2 VIP-4R/4T Installation and Configuration Table of Contents Table of Contents This configuration note includes the following sections: • If You Need More Configuration Information • Versatile Interface Processor Functions, page 3 — What is the VIP?, page 3 Note The following section contains import...

Page 3 - UniverCD; Versatile Interface Processor Functions; Caution

VIP-4R/4T Installation and Configuration 3 Versatile Interface Processor Functions For additional information on configuring the Cisco 7000 series or Cisco 7500 series router, thefollowing documentation resources are available to you: • UniverCD This publication and all other Cisco Systems publicati...

Page 5 - VIP Software Prerequisites; . Detailed information about the latest Cisco IOS release can be; VIP Hardware Prerequisites

VIP-4R/4T Installation and Configuration 5 Versatile Interface Processor Functions VIP Software Prerequisites The VIP requires that the host Cisco 7000 series and Cisco 7500 series router is running CiscoInternetwork Operating System (Cisco IOS) Release 11.1(1) or later, or a Cisco-approved betavers...

Other Cisco Models

All Cisco Other