Chromalox UB-502D - Manual
Chromalox UB-502D – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – WIRING; Hazard of Electric Shock. Any installation; OPERATION; Do not restrict air-flow through the heater by; MAINTENANCE; Turn off all power to service heater. Do not; WIRING DIAGRAMS; Figure 3
- Page 3 – Figure 5; Figure 6; Figure 7
- Page 4 – RENEWAL PARTS IDENTIFICATION; Part Number; Fuse Block Barrier; PARTS COMMON TO ALL HEATERS
- Page 5 – Model
DIVISION
4
SECTION
UB
SALES
REFERENCE
DATE
SERVICE REFERENCE
Installation, Operation
and
RENEWAL PARTS IDENTIFICATION
PF416-13
JULY, 2002
(Supersedes PF416-12)
161-048444-001
MOUNTING
© 2010 Chromalox
®
, Inc.
UB-502D and UB-752D
Forced-Air Heaters
WARNING:
Hazard of Electric Shock. Disconnect all
power before installing heater.
Note:
These heaters are designed for wall or ceiling mounting
only. Other modes of mounting voids factory warranty.
1.
Height above floor
A.
In areas where ceiling height is more than 12 feet, recom-
mended mounting height is approximately 10 feet to under-
side of heater.
B.
For ceiling heights of 12 feet or less, maximum mounting
height is determined by use of ceiling mounting brackets
offered for these heaters. Minimum spacing to ceiling is 3”
(see Figure 2).
C.
In either case, minimum mounting height is 7 feet from
floor to bottom of heater. (See Figures 1 and 2.)
2.
Spacing to adjacent walls
A.
Rear of case to back wall 4-7/8” minimum (see Figure 2).
B.
Side of case to side wall 6” minimum (see Figure 2).
3.
If two or more units are operated in the same enclosed space,
their discharges should be directed to aid in development of
mass air movement for uniform heat dispersal.
4.
Controlling thermostats to individual heaters should be
mounted at shoulder height on inside walls or columns.
‡ Model Numbers with suffix “T” added (480 volts only) are equipped with a transformer, 480V Primary — 120/240V Secondary.
‡ Model Numbers with suffix “R” added are equipped with a relay.
Horizontal
Model
Voltage and Phase
kW
Air Discharge
(Ft.)
UB-502D
120 (1ø); 208, 240 or 480 (1ø or 3ø)
5
12.5
UB-502D-R
208, 240 or 480 (1ø or 3ø)
5
12.5
UB-752D
120 (1ø); 208, 240 or 480 (1ø or 3ø)
7.5
13
UB-752D-R
208, 240 (3ø); 480 (1ø or 3ø)
7.5
13
Specifications —
Dimensions —
Rubber Feet Provided for
Wall Mount Units Only.
7/8” and 1-13/32”
Dia. Holes in Rear
11-5/8”
13-5/8”
17-3/16”
8-7/8”
7-9/16”
For Lower Height
from Ceiling:
Customer to add
Extension Strap.
11-7/8”
8”
6”
7’-0” Min. Height
Above Floor
Figure 1
Mounting UB using ceiling
mounting brackets*
Ceiling Line
Wall
Back
Wall
6” Min. Spacing to
Adjacent Wall
3”
4-7/8”
8-7/8”
15-9/16”
7’-0” Min. Height
Above Floor
Mounting
Holes
Center
8”
6”
Figure 2
Mounting UB using wall
mounting brackets*
*Wall and/or Ceiling Mounting Brackets are
available as an accessory option — Contact
local sales representative.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
WIRING Note: All wiring should be done in accordance with local codes and the National Electrical Code by a qualified person. WARNING: Hazard of Electric Shock. Any installation involving electric heaters must be effectivelygrounded in accordance with the National ElectricalCode to eliminate shock h...
WIRING DIAGRAMS } C1T1T2 F1F2 L1 L2L3 Alternate 240V Wiring Integral 480V/240V or 120V Transformer Thermal Cutout Ground Heater Bank 1Ø Motor Heater Wiring Comp't Baffle For 3 Phase Only 120V Wiring X1 X3 X2 X4 X1 X3 X2 X4 H1 H2 This Wiring by Customer Control Switch Optional ThermostatWhen Used Con...
RENEWAL PARTS IDENTIFICATION ‡ Note: Only one thermal cutout is used if a Transformer and/or Relay is used. Note: Part numbers suffixed by a number in ( ) indicates quantity of same part number used. * Fusing Parts Part Number Fuse 3 Amp 600V KTK-3 128-047763-007 (2) Fuse Block Barrier 129-048475-00...
