Chief SL236 - Manual
Chief SL236 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – DISCLAIMER
- Page 3 – REMOVING MOTOR; Figure 1; Do NOT remove set screws yet.; Figure 2
- Page 4 – Wires should be connected in minimum; Figure 4
- Page 5 – Figure 7; REPLACING MOTOR; Do NOT overtighten the locknuts! Stop; Figure 8
- Page 6 – Replace plate removed in Step 5 of; Install middle screw on each side first and set plate on; Removing Motor; Restore power to SL236.
- Page 7 – included with the SL236.
- Page 8 – Europe; Franklinstraat 14, 6003 DK Weert, Netherlands; Asia Pacific; SL236 Motor Replacement; 012 Milestone AV Technologies, a
S E R V I C E M A N U A L
Motor Replacement
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
SL236 Motor Replacement
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
SL236 Motor Replacement Service Manual 2 DISCLAIMER Milestone AV Technologies and its affiliated corporations andsubsidiaries (collectively "Milestone"), intend to make thismanual accurate and complete. However, Milestone makes noclaim that the information contained herein covers all details...
Service Manual SL236 Motor Replacement 3 REMOVING MOTOR 1. Fully lower SL236, if possible. 2. Turn off and remove power from SL236. 3. Remove projector from SL236 following instructionsincluded with the SL236. 4. Remove signal and power cables from projector. 5. Remove projector cradle by removing f...
SL236 Motor Replacement Service Manual 4 10. Attach wire or something of equivalent strength to the joist mounting tabs on the SL236. 11. Connect these wires to the front of hinge assembly. (See Figure 4) IMPORTANT ! : Wires should be connected in minimum of two places to prevent the hinge assembly ...
