Chevrolet Power Vision - Manual
Chevrolet Power Vision – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – Repeat this process for the passenger side.; WIRING; TURN SIGNAL WIRING:
- Page 4 – If hole
- Page 5 – (whic h is powered only when the ignition in on); or a 12 volt
POWER VISION
INSTALLATION INSTRUCTIONS
Models:
6405/4410 & 6405/4410TK
GM/Chevrolet 2007 – current (new body style) full size trucks and
SUVs
with manual power mirrors.
THIS SET IS DESIGNED FOR TRUCK WITH STOCK MANUAL MIRRORS. IF YOU
CURRENTLY HAVE POWER MIRRORS, THE WRONG SET HAS BEEN ORDERED
.
Caution! - Do not attempt to manually extend or retract the mirrors. They should be moved under their own
motor power only.
Tools required for the installation are: 7mm and 10mm sockets, trim panel remover, philips screwdriver, small
screwdriver, needle nose pliers, razor knife, and an inch pound torque wrench. If you have any questions after
reading this installation manual, please call our service department at (800) 337-2557.
REMOVAL OF EXISTING MIRRORS
1.
On the inside of the driver’s door, remove the triangular shaped trim piece and insulation foam in the
mirror mounting area.
2.
Remove the door lock by using a small screwdriver to release the tab
while lifting the lock upward.
3.
Remove door trim panel screws located under trim covers.
4.
Remove window handle by releasing the retaining clip.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
6405/4410 Install PAGE 3 4. Insert the studs provided (3 for each side) with the tapered end out (see diagram E). They should screw into the mount up to the stop line – approx. 1cm or 3/8 of an inch. Next, line up the mount with the stock gasket and apply the mount to the door. While supporting the ...
6405/4410 Install PAGE 4 4. Repeat steps 1 through 3 for the passenger side identifying the right side active turn signal wire (recommend trying dark blue w/white tracer wire) and tapping the passenger mirror into it using a scotchlok. 5. Take the black wire from inside the driver side two -strand h...
6405/4410 Install Page 5 2. The next step is to run the main harness. Pop off both ends of the boot located between the door and cab. The main wiring harness has black and red wires attached. Remove the rubber band to uncoil the harness. One end of the main harness has a 12 pin and a 6 pin connector...
