Page 2 - For residential use only. Do not use for commercial; DANGER; TABLE OF CONTENTS; DANGER; THIS GRILL IS FOR OUTDOOR USE ONLY.; CAUTION
1. Do not store or use gasoline or other flammable liquids or vapors in the vicinity of this or any other appliance. 2. An LP cylinder not connected for use shall not be stored in the vicinity of this or any other appliance. WARNING For residential use only. Do not use for commercial cooking. DANGER...
Page 3 - Wash your hands after handling this product.; National Fuel Gas; over tighten screws and
WARNING CALIFORNIA PROPOSITION 651. Combustion by-products produced when using this product contain chemicals known to the State of California to cause cancer, birth defects, and other reproductive harm. 2. This product contains chemicals, including lead and lead compounds, known to the State of Cal...
Page 4 - USE AND CARE; OPD Hand Wheel; LP Cylinder Filling; LP Cylinder Valve
• NEVER store a spare LP cylinder under or near the appliance or in an enclosed area. • Never fill a cylinder beyond 80% full.• An over filled or improperly stored cylinder is a hazard due to possible gas release from the safety relief valve. This could cause an intense fire with risk of property da...
Page 5 - Connecting Regulator to the LP Cylinder; full stop; Safety Relief Valve; ck; Strap and Cap; LP Cylinder Exchange; Exchange your cylinder only; LP Cylinder Leak Test; Do not use household cleaning agents.
WARNING If “growing” bubbles appear do not use or move the LP cylinder. Contact an LP gas supplier or your fire department! Connecting Regulator to the LP Cylinder 1. LP cylinder must be properly secured onto grill. (Refer to assembly section.) 2. Turn all control knobs to the OFF position. 3. Turn ...
Page 6 - Leak Testing Valves, Hose and Regulator; rushing sound; immediately
6. Turn the coupling nut clockwise and tighten to a full stop. The regulator will seal on the back-check feature in the LP cylinder valve, resulting in some resistance. An additional one-half to three-quarters turn is required to complete the connection. Tighten by hand only – do not use tools. NOTE...
Page 7 - Lighting instructions continued on next page.; Do not let children operate or play near grill.
7 Safety Tips Before opening LP cylinder valve, check the coupling nut for tightness. When grill is not in use, turn off all control knobs and LP cylinder valve. Never move grill while in operation or still hot. Use long-handled barbecue utensils and oven mitts to avoid burns and splatters. ...
Page 8 - Troubleshooting Section
8 Ignitor Check •Turn gas off at LP cylinder. Press and hold electronic ignitor button. "Click" should be heard and spark seen each time between each collector box or burner and electrode. See "Troubleshooting" if no click or spark. Valve Check •Important: Make sure gas is off at LP ...
Page 9 - Cleaning the Burner; Cleaning the Burner Assembly; VERY IMPORTANT: Burner tubes must reengage valve; Turn gas OFF at control knobs and LP cylinder.; Carryover tube; Firebox burner; Storing Your Grill
9 CAUTION •Clean cooking grates.•Store in dry location.•When LP cylinder is connected to grill, store outdoors in a well- ventilated space and out of reach of children. •Cover grill if stored outdoors. Choose from a variety of grill covers offered by manufacturer. •Store grill indoors ONLY if LP cyl...
Page 10 - ITEMS MANUFACTURER WILL NOT PAY FOR:; of products not approved by the manufacturer.; DISCLAIMER OF IMPLIED WARRANTIES and LIMITATION OF REMEDIES; LIMITED WARRANTY; SCOPE OF COVERAGE
This warranty only applies to units purchased from an authorized retailer. Manufacturer warrants to the original consumer-purchaser only that this product shall be free from defects in workmanship and materials after correct assembly and under normal and reasonable home use for the periods indicated...
Page 11 - PARTS LIST; Key Qty
PARTS LIST NOTE: Some grill parts shown in the assembly steps may differ slightly in appearance from those on your particular grill model. However, the method of assembly remains the same. 11 Key Qty Description A 1 TOP LID B 1 LOGO PLATE, W / TEMP GAUGE C 2 HANDLE END, TOP LID D 1 HANDLE, TOP LID E...
Page 12 - PARTS DIAGRAM
PARTS DIAGRAM 12 A C PP D C M MM Z X U V Y II ZZ AAA E R QQ SS TT UU RR H P OO L L AA NN I J N WW XX YY FF KK LL S HH II II II HH BB EE EE CC DD DD T GG O Q Q VV W JJ J K K G BBB B F
Page 13 - ASSEMBLY; Attach side panels to bottom shelf using three; IMPORTANT: Panel with large hole must; Front; Caster pin
ASSEMBLY 2 1/4-20x1/2” screw 1 Attach side panels to bottom shelf using three 1/4-20x1/2” screws per panel. IMPORTANT: Panel with large hole must Be on Right side of bottom shelf. Locking caster Bottom shelf Rear Front Fixed caster 13 Left side panel (with large hole) Make sure side panels are pushe...
Page 14 - Lower back panel
3 Place lower back panel between side panels at rear of bottom shelf, oriented as shown. Secure lower back panel to sidepanels using two 1/4-20x1/2” screws on each side. Secure lower back panel to bottom shelf using one 1/4-20x1/2” screw. Lower back panel Recess for tank heat shield tabs 1/4-20x1/2”...
Page 15 - mm lock washer; Center cart divider
4 5 Attach center cart divider to bottom shelf using three #10-24x3/8” screws, 5mm lock washers and 5mm flat washers. 15 On back of grill, attach center cart divider to lower back panel using two #8x3/8” self-tapping screws. #10-24x3/8” screw 5mm lock washer Bottom shelf Center cart divider Center c...
Page 16 - screw; Upper back panel
6 7 Attach cabinet shelf to center cart divider using two #10-24x3/8” screws, 5mm lock washers and 5mm flat washers. Attach cabinet shelf to cart left side panel using two #10-24x3/8” screws, 5mm lock washers and 5mm flat washers. 16 Cabinet shelf Cart left side panel #10-24x3/8” screw #10-24x3/8” s...
Page 17 - Front brace; Tank heat shield; Attach middle of front brace to center cart divider using one
8 9 A B Insert front brace between cart side panels. Orient the front brace with the door hinge pin on the top right side. Secure using one 1/4-20x1½” screw on each side. 17 Front brace Front brace Front brace Tank heat shield Tank heat shield (concave side up) Upper back panel 1/4-20x1½” screw Hing...
Page 18 - Carefully lower the grill; Make sure the; Grill head; Secure front brace in upper hole with one; Secure upper back panel in lower hole with one; fiber
10 This step requires two people to lift and position grill head onto cart. Carefully lower the grill head onto the cart, aligning slots at bottom of grill head with posts on cart side panels. Make sure the regulator hose is hanging outside the cart. Grill head must face open side of cart. 18 Grill ...
Page 19 - Electronic ignition module; Cap; AA battery; Insert AA battery into ignition module, negative (
12 19 13 Inside of the cart, connect the wires from burner electrodes into the back of Electronic Ignition module. Total (5) connections. Note: Switch terminals are larger than electrode terminals and should only be installed in location shown as (a),(b). Connect the two wires [(a) and (b)] from swi...
Page 21 - Left side shelf; Attach left side control panel to left side shelf using four
15 21 A C D Left side control panel Left side shelf Left side shelf Left side shelf Side burner lid Attach left side control panel to left side shelf using four #10-24x3/8” screws, 5mm lock washers, 5mm flat washers, shown A . Attach side burner lid handle to side burner lid using two # 10-24x3/8” s...
Page 22 - Large flat washer
16 A 22 1/4-20x1½” 1/4-20x3/4” screw 1/4” nut Attach front of shelf using two #8x3/8” self-tapping screws and large flat washers, shown B . Attach rear of shelf using one 1/4-20x1½” screw, shown C . Attach left side shelf to firebox using two 1/4-20x3/4” screws and 1/4” nuts, shown A . #8x3/8” self-...
Page 23 - burner tube; Position sideburner valve
8a 18 23 Insert sideburner into left shelf. The stud on bottom of burner fits into rear small hole in sideburner drip pan on shelf, shown A . Make sure burner tube engages sideburner valve, shown C . Secure burner to siderburner drip pan with one Wing nut, shown B . Under sideburner shelf, attach si...
Page 24 - Right door; Place side burner cooking grate onto side burner shelf.; sideburner cooking grate
20 24 pin on bottom of door Top of door PRESS Right door Insert the pin on bottom of door into hole in bottom shelf. Press upper hinge pin in front brace, align hinge hole on top of door, and release hinge pin into door. 19 Place side burner cooking grate onto side burner shelf. sideburner cooking g...
Page 25 - Attach left small doors to left side panel using eight; Troughs; Place trough middle bracket into fire box.
22 Attach left small doors to left side panel using eight #8-32x1/4” screws. 25 21 #8-32x1/4” screw Troughs Trough middle bracket Put trough middle bracket on the brackets at front and rear of firebox. Trough pin Place troughs into fire box. Align pins at front of troughs with the holes at front of ...
Page 26 - Place cooking grates onto firebox as shown.; LP CYLINDER IS SOLD SEPARATELY.; Cylinder screw at rear of cart; Regulator
24 26 Place cooking grates onto firebox as shown. Insert the four wire ends at rear of warming rack into holes in back of fire box. Front wires of warming rack rest on sides of firebox. Assembled warming rack 23 LP CYLINDER IS SOLD SEPARATELY. Fill and leak check the cylinder before attaching to gri...
Page 27 - Main Burner Conversion; reference only. Not all steps will apply to your grill conversion.
1 Main Burner Conversion Your grill may differ from illustration shown. This portion of the manual covers a variety of grill styles. Use pictures as reference only. Not all steps will apply to your grill conversion. Make sure all Control Knobs are in the OFF position, LP Tank Valve is closed, Tank i...
Page 28 - Pull the Burner Control Knobs off of Valve Stems.; Tube Burner
4 Bezels Valve Stem Screws Main Burner Control Knobs Natural Gas Bezel 80007893 Pull the Burner Control Knobs off of Valve Stems. Remove Screws and Washers that secure each Bezel to the Control Panel. Save removed Bezels for converting back to LP Tank Gas. Install new Natural Gas Bezels provided wit...
Page 29 - Sideburner Conversion
6 7 Open Sideburner lid and remove the Sideburner Grate. Beneath Sideburner shelf, remove Wingnut. Remove Sideburner from shelf. Wingnut Sideburner Grate Orifice Removal Tool Using the provided Orifice Removal Tool, unscrew the Orifice from the end of the Sideburner Valve. Save removed Orifice and O...
Page 30 - Secure Burner to shelf with Wingnut. Reference illustration 6.; Valve
8 9 Pull the Sideburner Control Knob off of Valve Stem. Remove the existing Bezel by removing the two Screws and Washers securing Bezel to shelf control panel. Save removed Bezel for converting back to LP Tank Gas. Install new natural gas Bezel (see illustration below) and press Control Knob back on...
Page 31 - Outdoor Stove & Griddle Conversion
11 Using the provided Orifice Removal Tool, unscrew the Orifice from the end of the Sideburner Valve. Save removed Orifice and Orifice Removal Tool for converting back to LP Tank Gas. No replacement Orifice is required. 10 Open Sideburner lid and remove the Sideburner Gate. Beneath Sideburner shelf,...
Page 32 - Natural Gas Bezel
12 13 Pull the Sideburner Control Knob off of Valve Stem. Remove the existing Bezel by removing the two Screws and Washers securing Bezel to shelf control panel. Save removed Bezel for converting back to LP Tank Gas. Install new natural gas Bezel (see illustration below) and press Control Knob back ...
Page 33 - Natural Gas Hose Conversion; Connection for converting back to LP Tank Gas.; Your Grill may differ from illustration shown.
14 Natural Gas Hose Conversion Using a wrench, not provided, remove LP Regulator Hose Assembly from Manifold Connection. Save removed LP Manifold Connection for converting back to LP Tank Gas. Your Grill may differ from illustration shown. LP Regulator Hose Assembly Manifold Connection Natural Gas H...
Page 34 - Connecting Your Grill to the Natural Gas Source.; Figure A; connected hose and socket.
Connecting Your Grill to the Natural Gas Source. 1. A professionally-installed shut-off valve between the supply piping and the socket is recommended, but not required, by the National Fuel Gas Code. Socket connection must be made outdoors. 2. Coat the gas supply pipe nipple with gas resistant pipe ...
Page 35 - Troubleshooting
DANGER: If a gas leak cannot be stopped, or a fire occurs due to gas leakage, call the fire department. Emergencies Problem Gas leaking from cracked/cut/burned hose. Gas leaking from LP cylinder. Gas leaking from LP cylinder valve. Gas leaking between LP cylinder and regulator connection. Fire comin...
Page 36 - continued; Problem
Troubleshooting ( continued ) Problem Burner(s) will not light using ignitor.(See Electronic Ignition Troubleshooting also) Burner(s) will notmatch light. Sudden drop in gasflow or low flame. Flames blow out. Flare-up. Persistent grease fire. Flashback...(fire in burner tube(s)). Unable to fill LP c...
Page 37 - Troubleshooting - Electronic Ignition; SECTION I
Troubleshooting - Electronic Ignition Problem (Ignition) SECTION I No sparks appear at any electrodes when Electronic Ignition Button is pressed; no noise can be heard from spark module. SECTION II SECTION III Sparks are present but not at all electrodes and/or not at full strength Possible Cause • ...
Page 38 - NOTES
Page 39 - Attach copy of your; STICKER ON PRODUCT; Please register your product online at:
39 First Name | Nombre | Prénom Initial | Inicial | Initiale Last Name | Apellido | Nom de Famillie Address (number & street) | Dirección (número y calle) | Adresse (numéro et rue) Apt Number | Nº de apart | Nº d’appt. City | Cludad | Ville State | Estado | Province Zip Code | Código Zip | Code ...
