Champion Power Equipment 2010004 - Manual
Champion Power Equipment 2010004 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Page 1
Number: 2010004
Starting Generator Without Keys
(338cc Engines or Larger)
Issue Date: 08/26/2011
1) Standing on the panel side (outlet side) of the generator,
locate the group of wires directly under the Ignition switch.
You will see Black, Yellow, Green and Brown wires.
This bulletin covers the following Champion Power Equipment models (
Note
: Read instructions completely before performing service):
–
All Champion Power Equipment products equipped with electric key start.
2) Locate the Black wire with a soft Black rubber covering on
the connection point. This is for the Ignition system and is
a grounding function wire. Unplug this connection.
3) Next you will locate a single black harness that has two
Green wires inside the loom. Each green wire will have
either a black or white stripe on the green insulation
covering the wire. Unplug either green wire.
Only one of
them is necessary.
If you have any questions, please contact us at:
Champion Power Equipment, Inc.
Customer Service
1
2039 Smith Ave
.
Santa Fe Springs, CA 90670
www.championpowerequipment.com
Technical Service
Mon – Fri 8:30 AM – 5:00 PM (PST/PDT)
Toll Free: 1-877-338-0999
tech@ championpowerequipment.com
4) At this point you will be able to manually start the
generator with the recoil starter. One choke pull of the rope
and then up to 3 pulls without any choke before choking
again. Repeated choking is counter productive to an
effective starting of the engine.
5) When you need to shut the engine down, you can plug
either of the previously unplugged wires, or you can Choke
the engine off with the choke lever.
6) For additional help or
TO ObTain a new Key
call the
Customer Service phone number listed below.
7) Once you obtain a new key, then re-connect the two wires
disconnected in steps 2 and 3, and the generator will start
normally.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
