Cecilware NO.6167-F - Manual
Cecilware NO.6167-F – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – ITEMS SUPPLIED; INTRODUCTION; ITEMS REQUIRED
- Page 3 – INSTALLING THE RADIO GEAR
- Page 4 – INSTALLING THROTTLE LINKAGE; INSTALLING STEERING SERVO LINKAGE; CHARGING THE GLOW PLUG IGNITER
- Page 5 – PREPARING THE RADIO; RADIO BATTERY INSTALLATION; RADIO OPERATION
- Page 8 – FUELLING; PREPARING THE ENGINE
- Page 9 – STARTING THE ENGINE
- Page 10 – WARNING; ENGINE SETTING
- Page 11 – -SPEED SHIFT POINT ADJUSTMENT
Thunder Tiger Corporation guarantees this model kit to be free from defects in both material and workmanship.
The total monetary value under warranty will in no case exceed the cost of the original kit purchased. This warranty
does not cover any components damaged by use or modification. Part or parts missing from this kit must be
reported within 60 days of purchase. No part or parts will be sent under warranty without proof of purchase.
To receive part or parts under warranty, the service center must receive a proof of purchase and/or the defective
part or parts. Should you find a defective or missing part, contact the authorized Thunder Tiger Service/Distributor
nearest you. Under no circumstances can a dealer or distributor accept return of a kit if assembly has started.
JD6221
No.6167-F
1/10 NITRO POWERED 4WD TOURING CAR
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
ITEMS SUPPLIED 2-Channel, surface radio with 2 high torque servos Glow Fuel, Methanol10% to 20% Nitro5% to 18% Caster / Synthetic Oil INTRODUCTION Thank you for the purchase of this Thunder Tiger product. You should enjoy many hours of trouble free usefrom this advanced R/C product. Thunder Tiger st...
1 INSTALLING THE RADIO GEAR skip if already assembled 2 a e b1 c h g i g b2 a. Disassemble the roll bar. b. Remove the 8 screws on the radio plate and two 3*10mm countersunk screws on the chassis. c. Install the steering / throttle servos onto the mounts with four tap screws. Notice the orientation ...
3 3 a. Build the throttle/brake linkages as shown on the diagram. b. Secure the brake cam lever onto brake cam with set screw. c. Install the servo horn onto throttle sero output shaft. INSTALLING THROTTLE LINKAGE skip if already assembled c b a 2 INSTALLING STEERING SERVO LINKAGE skip if already as...
