Page 2 - ITEMS SUPPLIED; INTRODUCTION; ITEMS REQUIRED
ITEMS SUPPLIED 2-Channel, surface radio with 2 high torque servos Glow Fuel, Methanol10% to 20% Nitro5% to 18% Caster / Synthetic Oil INTRODUCTION Thank you for the purchase of this Thunder Tiger product. You should enjoy many hours of trouble free usefrom this advanced R/C product. Thunder Tiger st...
Page 3 - INSTALLING THE RADIO GEAR
1 INSTALLING THE RADIO GEAR skip if already assembled 2 a e b1 c h g i g b2 a. Disassemble the roll bar. b. Remove the 8 screws on the radio plate and two 3*10mm countersunk screws on the chassis. c. Install the steering / throttle servos onto the mounts with four tap screws. Notice the orientation ...
Page 4 - INSTALLING THROTTLE LINKAGE; INSTALLING STEERING SERVO LINKAGE; CHARGING THE GLOW PLUG IGNITER
3 3 a. Build the throttle/brake linkages as shown on the diagram. b. Secure the brake cam lever onto brake cam with set screw. c. Install the servo horn onto throttle sero output shaft. INSTALLING THROTTLE LINKAGE skip if already assembled c b a 2 INSTALLING STEERING SERVO LINKAGE skip if already as...
Page 5 - PREPARING THE RADIO; RADIO BATTERY INSTALLATION; RADIO OPERATION
5 a. Install the antenna into transmitter. b. Check the frequency printed on the transmitter crystal. c. Check the frequency printed on the receiver crystal, and make sure it matches with the transmittercrystal. Make sure no one will operate on the same frequency when you are. When there is a radiog...
Page 8 - FUELLING; PREPARING THE ENGINE
12 a b c a. Remove the cap from fuel bottle nozzle. b. Squeeze the fuel bottle, insert into fuel, and draw fuel into the fuel bottle. The fuel used should bemethanol based model engine glow fuel (available at hobby shops) with 10% to 20% nitro contentand 5% to 18% caster/synthetic oil content for lu...
Page 9 - STARTING THE ENGINE
a. Turn on the radio (transmitter first, then receiver). b. Clip the glow plug igniter onto engine's glow plug. c. Pull on the engine starter, release, repeat until the engine starts. Throttle maybe required to be openedmomentarily, but release throttle back to neutral immediately after the engine s...
Page 10 - WARNING; ENGINE SETTING
9 WARNING Thank you for purchasing a Thunder Tiger Product. Please read all instructions thoroughly before operation. 1. This product is not a toy. It is a high performance model product. It is important to familiarize yourself with the model, its manual, and its construction before assembly or oper...
Page 11 - -SPEED SHIFT POINT ADJUSTMENT
10 SET-UP FRONT REAR CAMBER -2˚More -, more steeringMore +, less steering CASTER 16˚ (max caster, all clips forward)More +, slow steering / fast exitMore -, quick steering / slow exit TOE -1˚Toe-in, ,more straightToe-out, quick steering RIDE HEIGHT 5mm (floor to chassis) Lower on smooth track surfac...