Casablanca W-85 - Manual

Casablanca W-85

Casablanca W-85 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
Page: / 14

Table of Contents:

  • Page 3 – Wall Control; SINGLE W-85 INSTALLATION
  • Page 4 – DUAL W-85 INSTALLATION; DIP SWITCHES
  • Page 5 – OPERATION © POWER; OPERATION SPEED CONTROL; To vary the light brightness:; OPERATION LIGHTS; Light Operation
  • Page 6 – CHANGING FREQUENCY SETTING; NOTE: All fans leave the factory set to; AUTOMATIC DEMONSTRATION PROGRAM; To enter the demonstration program:
  • Page 8 – PROGRAM; OFF for at least 5 seconds.
  • Page 9 – IN THE WALL BEZEL REPLACEMENT; W-85 Wall Control Bezel Replacement installation; To avoid possible electrical shock, make cer-
  • Page 10 – CONTINUED
  • Page 12 – TROUBLESHOOTING TIPS
Loading the manual

1

®

3

W-85 WALL CONTROL PREPARATION

WALL CONTROL AND HARDWARE

(not to scale)

Switch Mounting

Screws (2)

Wall Plate Screws

(2) White

(2) Almond

White Wall

Plate(1)

Figure #3

W-85

Wall Control

Prepare for W-85 Wall Control Bezel replacement

as follows:

Before installing the W-85 wall control you will need to

check and see if you will need to change the bezel on

the front of the wall control from WHITE to ALMOND.

If you are going to use white, skip these steps and go

to wall control installation starting on page 3. If you are

going to use the ALMOND bezel and wall plate you

will first need to change the bezel on the front of the

switch before installing the switch in to the wall.

Step 16a.

Locate the four (4) tabs holding the bezel to

the front of the switch, then press in on each tab one at

a time, removing the bezel as shown in Figure #1.

Step 16b.

Locate the rubber key pad attached to

the four (4) locating pins as shown in Figure #2 and

remove rubber key pad from the WHITE bezel, also

as shown in Figure #2.

Step 16c.

Reinstall the rubber key pad on to the

four (4) locating pins located on the almond bezel as

shown in Figure #3.

Switch Bezels

(1) White

(1) Almond

Figure #1

Figure #2

Almond Wall

Plate(1)

BEZEL

BEZEL

TABS

WHITE

BEZEL

ALMOND

BEZEL

RUBBER KEY

PAD

RUBBER KEY

PAD

LOCATING

PINS (4)

LOCATING

PINS

HOLES(4)

W-85 WALL CONTROL INSTALLATION

(4) Wire Cap

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 3 - Wall Control; SINGLE W-85 INSTALLATION

3 ® 3 INSTALLING THE W-85 WALL CONTROL W-85 CONTROL INSTALLATION 1. Use only the Casablanca W-85 wall control. 2. Do not use any additional control with your Inteli- Touch 3 fan (for example, dimmer, or fan speed control). 3. Do not use more than one fan per wall control. 4. No other light fixtures ...

Page 4 - DUAL W-85 INSTALLATION; DIP SWITCHES

4 ® 3 T o c o n t r o l t h e f a n a n d l i g h t s f r o m t w o l o c a t i o n s ( a t h r e e - w a y c i r c u i t ) , u s e t w o W-85 wall controls.1. Remove the screws and switch plate from the existing switch box and the screws holding the switch in the switch box. 2. Pull the existing sw...

Page 5 - OPERATION © POWER; OPERATION SPEED CONTROL; To vary the light brightness:; OPERATION LIGHTS; Light Operation

5 ® 3 OPERATION © POWER The button is normally left in the on position. Always turn the power off during cleaning or servicing the fan and during thunderstorms. It is also used to exit or enter additional programs. The button must be left on to retain a previously set fan speed or light level. OPERA...

Other Casablanca Models

All Casablanca Other