Cambridge Audio KP10 - Manual

8 Incognito KP10 The KP10 is fitted on the wall by fixing it into a standard UK 47mm depth single-gangelectrician’s back-box (pattress). All knock-outs in the back-box should be removed to providemaximum ventilation. Where it is desired to fit a mains lighting switch etc next to a keypad, a barrier-...

Incognito A-BUS keypad 9 Safety precautions Care should be taken when choosing the site for a KP10, the keypad must never be installed in aback-box which also contains mains wiring or in areas of high humidity. The KP10 runs on 24 V DC supplied through the connecting cable. As such there is no mains...

Cat5 to KP10 punch down connectors A Cat-5 cable (terminated with an RJ45 jackplug) is used to connect the KP10 to an AH10hub or A-BUS Ready receiver. The KP10 haspunch down connectors for the eightindividual conductors of the Cat-5 cable (use asmall flat-bladed screwdriver). See below forthe EIA/TI...

Incognito A-BUS keypad 11 Line-in/Line-out connections on subwoofer Screened audio cable Preampoutputconnectionson rear ofKP10 Gain adjust The maximum output of the KP10 can be limited by turning these down. Alternatively, if the soundlevel is too quiet, the Gain can be turned up. Mode switch Select...

12 Incognito KP10 The six LEDs indicate the function statusof the KP10. Listed below are each of thefunctions of the corresponding LEDs: Minimum volume / Source select Volume / Source select / Bass adjust / Local Source Selection Mode Volume / Source select / Treble adjust / Local Source Selection M...

14 Incognito KP10 OPERATING INSTRUCTIONS Important! As mentioned previously, the KP10 can be switched between two modes of operation; astandard A-BUS mode for compatibility with other manufacturers A-BUS Ready equipment(Standard A-BUS/Incognito Ready mode), and an Incognito A-BUS hub mode (AH10 mode...

16 Incognito KP10 Note: This feature is only available if the KP10is part of a full Incognito multi-room system withone or two Local Input Modules (LM10) fitted. The local source selection mode will need to beactivated to configure the KP10 correctly. Thismode is only available when the Mode Switch ...

Incognito A-BUS keypad 17 Continuing to hold Volume up and Power buttons will light LED 5, to indicate that Off mode isavailable for selection, and no source will be selected. To select these modes, wait till the corresponding LED is lit and then release Power andVolume up buttons. Note: If no adjus...

18 Incognito KP10 Input impedance 45 k ohms Frequency response 20Hz – 20kHz +/- 1dB THD <0.2% @ 1W, 20Hz – 20 kHz S/N ratio > 80 dB ‘A’ weighted Volume control range - 80 dB, 36 steps Bass control range +/- 16 dB, 2 dB steps Treble control range +/- 16 dB, 2 dB steps Balance control range +/- ...

Incognito A-BUS keypad 19 Cambridge Audio warrants this product to be free from defects in materials and workmanship (subject to the terms set forth below). Cambridge Audio will repair or replace (at Cambridge Audio’s option) this product or any defective parts in this product. Warranty periods may ...