Cafe UVW9484SPSS - User Manual

49-2000707 Rev. 0 5 Controls USING THE HOOD: Controls / Chef Connect Chef Connect Operation Bluetooth ® Connection To pair with another device: To start the pairing process on the hood, press and hold the Light button for 3 seconds. The backlight for all the icons will flash until the hood is paired...

49-2000707 Rev. 0 7 Grease Drip Tray To install: Place and seat the drip trays into the designated hood track. Slide them left or right until all trays are side-by- side in place in the track. To remove: Carefully, use the grease tray lip to lift the tray upwards and out. The tray will be free of th...

8 49-2000707 Rev. 0 Lights To change the LED lamps, schedule a service appointment. See Consumer Support page for a list of websites and contact information. Surfaces CARE AND CLEANING: Filters / Surfaces / Lights Stainless Steel Surfaces (on some models) Do not use a steel wool pad; it will scratch...

49-2000707 Rev. 0 9 If you have questions, visit GEAppliances.com , or call GE Appliances at 800.GE.CARES (800.432.2737). Installation Instructions INST ALLA TION INSTRUCTIONS BEFORE YOU BEGIN Read these instructions completely and carefully. • IMPORTANT — Save these instructions for local inspector...

10 49-2000707 Rev. 0 Installation Preparation PRODUCT DIMENSIONS 30” Models Requires a 30” opening. 36” Models Requires a 36” opening. 48” Models Requires a 48” opening. INST ALLA TION PREP ARA TION 18” 21” 30” 12-1/4” 18” 21” 36” 12-1/4” 18” 21” 48” 12-1/4”

49-2000707 Rev. 0 11 Installation Preparation INSTALLATION PREPARATION PLAN THE INSTALLATION CAUTION To reduce risk of fire and to properly exhaust air, be sure to duct the air outside. Do not vent exhaust air into spaces within walls or ceilings or into attics, crawl spaces, or garages. PARTS SUPPL...

12 49-2000707 Rev. 0 INST ALLA TION PREP ARA TION Installation Preparation PARTS PROVIDED Locate the parts packed with the hood. Top Damper 761Dia28 Grease Drip Trays Motor (2 with 48” model) Hood Body Metal Installation Bracket 2 Baffle Filters 3 with 36” models 4 with 48" model HARDWARE PACKAG...

49-2000707 Rev. 0 13 Installation Preparation INSTALLATION PREPARATION INSTALLATION DIMENSIONS The hood duct covers can be adjusted for different ceiling heights depending on the distance between the bottom of the hood and the cooktop (distance X). See Installation Height Table on the next page. DUC...

14 49-2000707 Rev. 0 INST ALLA TION PREP ARA TION Installation Preparation INSTALLATION HEIGHT TABLE CX10DC9SPSS High Ceiling Duct Cover up to 10 ft. Installation over Gas Range Installation over Electric Range Ceiling Height (ft./in.) Recirc Installation Height Vented Installation Height (Recirc ho...

49-2000707 Rev. 0 15 Installation Instructions POWER SUPPLY IMPORTANT – (Please read carefully) WARNING FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED.Remove house fuse or open circuit breaker before beginning installation.Do not use an extension cord or adapter plug with this applian...

16 49-2000707 Rev. 0 Installation Preparation NEW CONSTRUCTION, PRE-PLANNING, OR REMODELING NOTE: For existing instruction, skip to the next section. FOR TOP VENTING ■ For ducted installation through the top, the 8” diameter hole (for 30” or 36” model) or the 10” diameter hole (for 48” model) for th...

49-2000707 Rev. 0 17 INST ALLA TION INSTRUCTIONS Installation Instructions DETERMINE HOOD, DUCTWORK AND WIRING LOCATIONS • This hood can be installed onto the wall or underneath the soffit or cabinet. • For installing the hood to soffit or cabinet, refer to page 19 for alternate mounting method. • A...

18 49-2000707 Rev. 0 INST ALLA TION INSTRUCTIONS Installation Instructions 1 INSTALL HOOD SUPPORT IMPORTANT: Framing must be capable of supporting 100 lbs for 30" and 36" models and 150 lbs for 48" models.• Locate a minimum of 2 vertical studs for the installation bar by tapping drywall ...

49-2000707 Rev. 0 19 3 INSTALL HOOD ONTO WALL • Pull house wiring through knockout at the back or top of the hood. • Lift the hood and place over the hooks on the installation bar. Allow the hood to slide down into position. • Check to be sure the hood is level and centered. • Tighten wall anchor sc...

20 49-2000707 Rev. 0 INST ALLA TION INSTRUCTIONS Installation Instructions 4 (Alternate Mounting Method) INSTALL HOOD TO SOFFIT OR CABINET (Cont.) • Drill two 1/8” pilot holes at a distance of 10” from the back wall in the horizontal wood supports. This is the vertical distance between mounting keyh...

49-2000707 Rev. 0 21 Installation Instructions 5 INSTALL MOTOR I) Align the motor exhaust with the top damper as shown in the Figure A for top venting. In case of back venting, rotate the motor 90° to align with the back damper as shown in Figure B. II) Secure the motor to motor mounting plate using...

22 49-2000707 Rev. 0 INST ALLA TION INSTRUCTIONS Installation Instructions 7 CONNECT DUCTWORK A. Vented Installation • Connect the house ducting to the top damper as shown in Figure A. • For back venting, connect the transition piece to the back damper and the house ducting to the transition as show...

49-2000707 Rev. 0 23 Installation Instructions 8 INSTALL DUCT COVERS • Refer to section “Duct Cover Requirements” on page 13 for duct cover accessory part numbers. • Follow instructions included with the duct cover accessory to install duct covers. 9 INSTALL GREASE TRAYS AND FILTERS • Remove protect...

24 49-2000707 Rev. 0 INST ALLA TION INSTRUCTIONS Installation Instructions MAKE UP AIR TECHNOLOGY This operation must be performed by a qualified technician or installer. Note to Installers and Inspectors: This product comes equipped with a simple installation feature that limits maximum CFM levels ...

49-2000707 Rev. 0 25 Troubleshooting tips ... Before you schedule service Save time and money! Review the chart below first and you may not need to schedule service. TROUBLESHOOTING TIPS Problem Possible Cause What To Do Fan/Light does not operate when button is turned ON A house fuse may be blown o...

26 49-2000707 Rev. 0 Staple your receipt here. Proof of the original purchase date is needed to obtain service under the warranty . GEAppliances.com All warranty service is provided by our Factory Service Centers, or an authorized Customer Care ® technician. To schedule service online, visit us at g...

49-2000707 Rev. 0 27 ACCESSORIES Accessories Parts Baffle Filters Grease Drip Trays Duct Covers Remote Control Back Venting Damper 15” Cabinet Filler Panel Power Cord Kit Charcoal Filters Recirculation Kit Cleaning Supplies CitruShine™ Stainless Steel Wipes Stainless Steel Appliance Cleaner Bar Keep...

28 49-2000707 Rev. 0 CONSUMER SUPPORT Printed in the the United States Consumer Support GE Appliances Website Have a question or need assistance with your appliance? Try the GE Appliances Website 24 hours a day, any day of the year! You can also shop for more great GE Appliances products and take ad...