Cadet UC102 - Manual
Cadet UC102 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Installation Instructions; READ ALL
- Page 3 – Part Two; Operation and Maintenance; WARNING
- Page 4 – Warranty; Troubleshooting Chart; Symptom
- Page 5 – GUÍA PARA EL PROPIETARIO; CONSERVE ESTAS INSTRUCCIONES; The Perfectoe; Características y
- Page 6 – PISO; Instrucciones para la instalación; LEA TODAS LAS
- Page 7 – Parte dos; Funcionamiento y mantenimiento; ADVERTENCIA
- Page 8 – Garantía; Tabla de resolución de problemas; Síntoma
OWNER’S GUIDE
The Perfectoe
SAVE THESE INSTRUCTIONS
IMPORTANT INSTRUCTIONS
The Perfectoe
WARNING
Turn the electrical power off at the electrical
panel board (circuit breaker or fuse box) and
l o c k o r t a g t h e p a n e l b o a r d d o o r t o p r e v e n t
someone from turning on power while you are
working on the heater. Failure to do so could
r e s u l t i n s e r i o u s e l e c t r i c a l s h o c k , b u r n s , o r
possible death.
1. Read all instructions before using this heater.
2. Read all information labels.
Verify that the electrical supply
wires are the same voltage as the heater.
3. All electrical work and materials must comply with the
National Electric Code (NEC), the Occupational Safety and
Health Act (OSHA), and all state and local codes.
4. Connect the grounding pigtail (copper wire) provided in the
wall can to the supply ground wire.
5. If you need to install a new circuit or need additional wiring
information, consult a qualified electrician.
6. Protect electrical supply from kinks, sharp objects, oil,
grease, hot surfaces or chemicals.
7.
WARNING
Overheating or fire may occur. DO NOT
install the heater in
a floor, behind doors, or outdoors.
8.
WARNING
Fire or explosion may occur.
Heater has hot and arcing or
sparking parts inside. Do not install heater in any area
where combustible vapors, gases, liquids, or excessive lint
or dust are present.
9.
WARNING
Burn Hazard.
This heater is hot when in use. To avoid burns,
do not let bare skin touch hot surfaces. Use extreme caution
when any heater is used by or near children or invalids and
whenever the heater is left operating unattended.
10.
WARNING
Risk of Electrical Shock.
Keep all foreign objects out of
heater. Do not operate after heater malfunctions or has
been dropped or damaged in any manner.
11.
WARNING
Risk of Fire. Do not block heater.
Heater must be kept clear
of all obstructions: a minimum of 3 feet in front, 6 inches on
both sides. Heaters must be kept clean of excessive lint, dirt
and debris. (See Maintenance Instructions).
12. Use this heater only as described in this manual. Any other
use not recommended by the manufacturer may cause fire,
electrical shock, or injury to persons.
www.cadetco.com Tel: 360-693-2505 P.O. Box 1675 Vancouver, WA 98668-1675
Features & Benefits
•
Thermal Safeguard
•
High temperature manual reset:
turns off heater if normal operating
temperatures are exceeded
•
Rugged steel-finned element
•
Ideal for bathrooms and kitchens
•
Low profile for rooms with limited space
•
Two-year extended warranty
•
Single pole or double pole field mount
thermostat kit available
•
Black or white powder coat paint for
a durable finish
MODELS
The Perfectoe
UC072
UC102
UC101
* For installations above 7000 feet, highest
wattage recommended is 750 watts.
TOOLS REQUIRED:
Phillips Screwdriver
Straight Screwdriver
Wire Strippers
Utility Knife
(2) 1
1
/
2
” Wood Screws
(3) Insulated Wire Connectors
(1) Strain Relief Connector
18”
45.7cm
14½”
36.8cm
3½”
8.9cm
8¼”
21cm
¼”
.6cm
Front
Top
Side
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Part One PLACEMENT: Read IMPORTANT INSTRUCTIONS for important safety requirements. For best results, install heater beneath a cabinet in the toe kick area. Install the Perfectoe (Model UC) horizontally. Do notinstall the UC heater in the floor. Headers and bracing are not necessary. Heater must be i...
UC With inbuilt single pole thermostat Wiring Diagram Part Two Operation and Maintenance How to operate your heater 1. Once installation in complete and power has been restored turn the thermostat knob fullyclockwise. 2. When the room reaches your comfort level, turn the thermostat knob counterclock...
1. Incorrect supply voltage.2. Overloaded circuit. 3. A short circuit exists in the supply or heater wiring. 4. Defective circuit breaker. 1. Insufficient element temperature.2. Incorrect supply voltage.3. Element has failed. 1. Heat loss from room is greater than heater capacity. 2. Defective therm...
