Cabletron Systems Netlink FRX4000 - Manual
Cabletron Systems Netlink FRX4000 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Statements of Compliance; FCC; About This Manual; Terminology and Conventions; Related Documents
- Page 3 – Overview of Installation and Setup; Site Requirements; Installation and Setup Procedure; Set Up the Device; Figure 1; LAN adapter connectors are shown in Figure 2.; Power Switch
- Page 4 – Figure 3; Cable Type
- Page 5 – Configure the Video Device; Auxiliary Console; Figure 4 through Figure 6 show the cabling configurations.; Follow this procedure to set up the auxiliary console:; ASCII Terminal
- Page 6 – VGA Monitor
- Page 7 – Configure the Token Ring Card; Check for Proper Operation; This procedure requires a video device connected to the node.; Figure 7
- Page 8 – Displaying Boot-up Information; To display the data from the current boot-up, press
,QVWDOODWLRQ
6HWXS
*XLGH
The Complete Networking Solution
TM
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Cabletron Systems reserves the right to make changes in specifications and other information con-tained in this document without prior notice. The reader should in all cases consult Cabletron Systems to determine whether any such changes have been made. The hardware, firmware, and/or software descri...
Overview of Installation and Setup When a Netlink ™ FRX6000 is ordered, the customer and sales representative decide on the required components (cards, cables, etc.). Cards and software are then installed before the node is shipped. This document describes the steps to be taken at the customer site ...
Figure 2 LAN Card Connectors 3. Assuming the node will be mounted in a rack, it can be secured to slides, or set on a fixed or slide-out shelf. The node can also be mounted directly to the cabinet frame, but this makes access difficult. Do not support a rack-mounted node only in the front. It must b...
