Cabletron Systems DELHE-UA - Manuals

Cabletron Systems DELHE-UA – Manual in PDF format online.

Manuals:

Manual

Manual Cabletron Systems DELHE-UA

Summary

Page 3 - This is a new document.

DIGITAL Fast Ethernet Interface Module DELHE-UA User’s Guide Part Number: 9032765 September 1998 This book describes the DELHE-UA features and how to install and troubleshoot the equipment. Revision/Update Information: This is a new document.

Page 4 - UNITED STATES GOVERNMENT RESTRICTED RIGHTS

Cabletron Systems reserves the right to make changes in specifications and other information contained in this document without prior notice. The reader should in all cases consult Cabletron Systems to determine whether any such changes have been made. The hardware, firmware, or software described i...

Page 8 - DECLARATION OF CONFORMITY

DECLARATION OF CONFORMITY Application of Council Directive(s): 89/336/EEC73/23/EEC Manufacturer’s Name: Cabletron Systems, Inc. Manufacturer’s Address: 35 Industrial WayPO Box 5005Rochester, NH 03867 European Representative Name: Mr. J. Solari European Representative Address: Cabletron Systems Limit...

Page 9 - DELHE-UA User’s Guide; vii; CONTENTS

DELHE-UA User’s Guide vii CONTENTS PREFACEUsing This Guide ..................................................................................... xiStructure of This Guide ........................................................................... xiDocument Conventions .................................

Page 10 - APPENDIX B

Contents viii DELHE-UA User’s Guide A.1 Physical Properties ..................................................................... A-1 A.2 Environmental Requirements ...................................................... A-1 A.3 FEPIM Options .............................................................

Page 11 - FIGURES; Figure

Figures DELHE-UA User ’s Guide ix FIGURES Figure Page 1-1 DELHE-UA ............................................................................... 1-1 2-1 Removing the FEPIM Coverplate ............................................. 2-3 2-2 Installing the FEPIM ...........................................

Page 12 - TABLES; Table

Tables x DELHE-UA User ’s Guide TABLES Table Page 1-1 FEPIM Options .........................................................................1-2 3-1 DELHE-UA LEDs ......................................................................3-2 3-2 10/100 LED Indications When RX LED Is On .....................

Page 13 - PREFACE; USING THIS GUIDE; This guide is organized as follows:

DELHE-UA User ’s Guide xi PREFACE Welcome to the DIGITAL Fast Ethernet Interface Module DELHE-UA User’s Guide. This manual describes the DELHE-UA and provides information concerning features, installation, troubleshooting, information on Local Management, and specifications for the DELHE-UA. The DEL...

Page 14 - Preface; xii; DOCUMENT CONVENTIONS

Preface xii DELHE-UA User ’s Guide DOCUMENT CONVENTIONS Throughout this guide, the following symbols are used to call attention to important information. RELATED DOCUMENTATION The documentation for the host device in which the DELHE-UA is to be installed provides additional information about the set...

Page 15 - CORRESPONDENCE; A description of the failure; Documentation Project Manager

Correspondence DELHE-UA User ’s Guide xiii CORRESPONDENCE Documentation Comments If you have comments or suggestions about this manual, send them to DIGITAL Network Products: World Wide Web To locate product-specific information, refer to the DIGITAL Network products Home Page on the World Wide Web ...

Page 17 - SAFETY; OVERVIEW

DELHE-UA User ’s Guide xv SAFETY OVERVIEW Any warning or caution that appears in this manual is defined as follows: WARNING Warns against an action that could result in equipment damage, personal injury, or death. VORSICHT Warnt den Benutzer vor Aktionen, die das Gerät beschädigen, Personen verletze...

Page 18 - Safety; xvi; SAFETY REQUIREMENTS

Safety xvi DELHE-UA User ’s Guide SAFETY REQUIREMENTS The warnings or cautions that must be observed for the hardware described in this manual are listed below in English, German, French, and Spanish. WARNING Only qualified personnel should install or service this unit. VORSICHT Diese Einheit darf n...

Page 20 - xviii

Safety xviii DELHE-UA User ’s Guide CAUTION The DELVM-UA, FEPIM, and the host module or hub are sensitive to static discharges. Use an antistatic wrist strap and observe all static precautions during this procedure. Failure to do so could result in damage to this equipment ACHTUNG Der DELVM-UA, FEPI...

Page 21 - CAUTION

Safety Requirements DELHE-UA User ’s Guide xix CAUTION Ensure that the FEPIM or DELVM-UA connector aligns with the DELVM-UA, module, or device connector pins to prevent bending the pins. Failure to do so can damage the DELVM-UA, FEPIM, module or device. ACHTUNG Vergewissern Sie sich, daß der FEPIM- ...

Page 22 - xx; ACHTUNG

Safety xx DELHE-UA User ’s Guide ACHTUNG Das Ende an beiden Seiten des Glasfaserkabels darf nicht berührt werden oder mit Staub, Schmutz und anderen Stoffen in Berührung kommen, die zur Verunreinigung führen und Datenübertragungsprobleme verursachen könnten. In einem solchen Fall müssen die Enden mi...

Page 23 - DELHE-UA User ’s Guide; CHAPTER 1

DELHE-UA User ’s Guide 1-1 CHAPTER 1 INTRODUCTION The DELHE-UA has two Fast Ethernet ports in which Fast Ethernet (Port) Interface Modules (FEPIMs) can be installed. Figure 1-1 shows the DELHE-UA. Figure 1-1 DELHE-UA 1.1 OVERVIEW The DELHE-UA extends the functionality of certain DIGITAL interface mo...

Page 24 - Local Management; FEPIM Options; category 5 unshielded twisted pair

Chapter 1: Introduction 1-2 DELHE-UA User ’s Guide 1.1.2 Local Management The DELHE-UA is managed through the host device in which it is installed. For information concerning Local Management for the DELHE-UA, refer to the manual for the host platform. For details on obtaining the host platform manu...

Page 25 - CHAPTER 2; To install the DELHE-UA the following items are required:; UNPACKING THE DELHE-UA; Remove the DELHE-UA from the shipping box.; and

DELHE-UA User ’s Guide 2-1 CHAPTER 2 INSTALLATION To install the DELHE-UA the following items are required: • Antistatic wrist strap • Phillips screwdriver • Fast Ethernet (Port) Interface Modules (FEPIMs) in the appropriate media 2.1 UNPACKING THE DELHE-UA Unpack the DELHE-UA as follows: 1. Remove ...

Page 27 - Removing the FEPIM Coverplate

Installing Fast Ethernet (Port) Interface Modules DELHE-UA User ’s Guide 2-3 Figure 2-1 Removing the FEPIM Coverplate 2. Refer to Figure 2-2. Gently pull the faceplate of the DELHE-UA forward to allow room for the FEPIM to be aligned over the connector. 3. Align the FEPIM connector into the DELHE-UA...

Page 28 - Installing the FEPIM

Chapter 2: Installation 2-4 DELHE-UA User ’s Guide Figure 2-2 Installing the FEPIM 4. Press down firmly on the FEPIM until the pins slide all the way into the DELHE-UA connector. Ensure that the FEPIM seats flush on the standoffs. 5. Secure the FEPIM using the screws enclosed in the FEPIM packaging....

Page 29 - INSTALLING THE DELHE-UA; Only qualified personnel should install or service this unit.

Installing the DELHE-UA DELHE-UA User ’s Guide 2-5 2.3 INSTALLING THE DELHE-UA A DELHE-UA can be installed in any DIGITAL device that supports HSIMs (High Speed Interface Module) technology (e.g., DLE52-MA, DLE28-MA). The following subsections provide generic instructions for installing a DELHE-UA i...

Page 30 - Removing the HSIM Coverplate

Chapter 2: Installation 2-6 DELHE-UA User ’s Guide 5. Remove and save the two faceplate mounting screws securing the HSIM coverplate and remove the coverplate. See Figure 2-3. Figure 2-3 Removing the HSIM Coverplate 6. Refer to Figure 2-4 and place the DELHE-UA behind the module faceplate. Faceplate...

Page 31 - Installing the DELHE-UA

Installing the DELHE-UA DELHE-UA User ’s Guide 2-7 Figure 2-4 Installing the DELHE-UA 7. Align the connector on the DELHE-UA with the connector on the module. 8. Press down firmly on the connector area of the DELHE-UA until the connector slides all the way onto the pins. Ensure that the standoffs on...

Page 32 - Secure the DELHE-UA to the module standoffs using the standoff; screws included in the DELHE-UA shipping materials.; Reinstall the interface module in the chassis.; CONNECTING TO THE NETWORK

Chapter 2: Installation 2-8 DELHE-UA User ’s Guide 9. Secure the DELHE-UA to the module faceplate using the mounting screws saved in Step 5. 10. Secure the DELHE-UA to the module standoffs using the standoff screws included in the DELHE-UA shipping materials. 11. Reinstall the interface module in th...

Page 33 - Connecting a Fiber Optic Segment to the FEPIM

Connecting to the Network DELHE-UA User ’s Guide 2-9 2.4.1 Connecting a Fiber Optic Segment to the FEPIM DIGITAL offers fiber optic cables that use SC style connectors which are keyed to ensure proper crossover of the transmit and receive fibers. 1. Remove the protective covers from the fiber optic ...

Page 34 - b. Verify proper crossover of fiber strands between the port on the

Chapter 2: Installation 2-10 DELHE-UA User ’s Guide 2. Insert one end of the SC connector into the FEPIM. 3. At the other end of the fiber optic cable, attach the SC connector to the other device. 4. Verify that a link exists by checking that the port receive LED is ON (flashing amber, blinking gree...

Page 35 - DELTX-UI Crossover Switch

Connecting to the Network DELHE-UA User ’s Guide 2-11 Figure 2-5 DELTX-UI Crossover Switch A schematic of a straight-through and a crossover cable is shown in Figure 2-6. If the wires do not cross over, use the switch on the DELTX-UI to internally cross over the RJ45 port. Figure 2-5 shows how to pr...

Page 36 - Twisted Pair Cabling; Connect a DELTX-UI to a twisted pair segment as follows:; Straight-Through Cable

Chapter 2: Installation 2-12 DELHE-UA User ’s Guide Figure 2-6 Twisted Pair Cabling Connect a DELTX-UI to a twisted pair segment as follows: 1. Ensure that the device connected to the other end of the segment is powered ON. 2. Connect the twisted pair segment to the module by inserting the RJ45 conn...

Page 37 - d. Make sure that the twisted pair connection meets cable; specifications outlined in Appendix B.

Connecting to the Network DELHE-UA User ’s Guide 2-13 b. Verify that the RJ45 connector on the twisted pair segment has the proper pinouts. c. Check the cable for continuity. d. Make sure that the twisted pair connection meets cable specifications outlined in Appendix B. e. Confirm that the crossove...

Page 39 - CHAPTER 3; DELHE-UA LANVIEW LEDs; Flashing indicates an irregular LED pulse.

DELHE-UA User ’s Guide 3-1 CHAPTER 3 LANVIEW LEDs This chapter describes how to use the LANVIEW LEDs to monitor the DELHE-UA status and diagnose DELHE-UA problems. 3.1 DELHE-UA LEDs Refer to Figure 3-1 for the location of the DELHE-UA LEDs and Table 3-1 for a description of the LED indications. Figu...

Page 40 - LED; Receive

Chapter 3: 3-2 DELHE-UA User ’s Guide 3.2 DELTX-UI LED The optional DELTX-UI has one LED labeled 10/100. The 10/100 LED together with the RX LED allows the user to determine the link status and the operating speed of the Fast Ethernet (Port) Interface Module. The 10/100 LED and the Receive (RX) LED ...

Page 41 - DELHE-UA LOCAL MANAGEMENT; A link exists if the associated port RX LED is on.; No link exists if the associated port RX LED is off.; Off

DELHE-UA Local Management DELHE-UA User ’s Guide 3-3 f 3.3 DELHE-UA LOCAL MANAGEMENT For information concerning Local Management for the DELHE-UA, refer to the host device manual. A link exists if the associated port RX LED is on. Table 3-2 10/100 LED Indications When RX LED Is On LED Color Indicati...

Page 43 - APPENDIX A; PHYSICAL PROPERTIES; Dimensions

DELHE-UA User ’s Guide A-1 APPENDIX A DELHE-UA SPECIFICATIONS This chapter lists the specifications and regulatory requirements for the DELHE-UA. Cabletron Systems reserves the right to change these specifications at any time without notice. A.1 PHYSICAL PROPERTIES A.2 ENVIRONMENTAL REQUIREMENTS A.3...

Page 44 - REGULATORY COMPLIANCE

Appendix A: DELHE-UA Specifications A-2 DELHE-UA User ’s Guide A.4 REGULATORY COMPLIANCE This equipment meets the following safety and electromagnetic compatibility (EMC) requirements: Safety UL 1950, CSA C22.2 No.950, EN 60950, IEC 950, and 73/23/EEC Electromagnetic Compatibility (EMC) FCC Part 15,...

Page 45 - side, the pairs are internally crossed

DELHE-UA User ’s Guide B-1 APPENDIX B FEPIM SPECIFICATIONS This appendix provides specifications for the Fast Ethernet (Port) Interface Modules. Cabletron Systems reserves the right to change these specifications at any time without notice. The DELHE-UA supports the following Fast Ethernet (Port) In...

Page 46 - Transmitter Power

Appendix B: FEPIM Specifications B-2 DELHE-UA User ’s Guide B.2 DELFX-UI The DELFX-UI shown in Figure B-2 uses an SC style connector that supports multimode fiber optic cabling. Specifications for the DELFX-UI are listed in Table B-1, below. Figure B-2 DELFX-UI Table B-1 Transmitter Power Cable Type...