Page 2 - NOTICE; © Copyright November 1991 by:
NOTICE i NOTICE Cabletron Systems reserves the right to make changes in specifications and other information contained in this document without prior notice. The reader should in all cases consult Cabletron Systems to determine whether any such changes have been made. The hardware, firmware, or soft...
Page 3 - ii; FCC NOTICE; This equipment has been tested and found to comply with the
NOTICE ii FCC NOTICE This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: T...
Page 4 - iii
CONTENTS iii CONTENTS CHAPTER 1 INTRODUCTION 1.1 Using This Manual........................................................................ 1-11.2 The MRXI ...................................................................................... 1-21.3 MRXI/LM ..............................................
Page 5 - CONTENTS; iv
Page 6 - This manual covers both the MRXI and MRXI-2. The two units
INTRODUCTION Page 1-1 CHAPTER 1 INTRODUCTION Welcome to Cabletron Systems MRXI/LM Local Management for the Cabletron Systems MRXI 10BASE-T HUB User's Manual. This manual serves as a simple reference guide for using MRXI/LM™, providing information to help you configure the MRXI™ and MRXI-2 and, if ne...
Page 7 - Define community names and access privileges
INTRODUCTION Page 1-2 1.2 THE MRXI The MRXI 10BASE-T HUB and MRXI-2 10BASE-T HUB are 10BASE-T and 802.3 compliant repeaters that allows expansion of existing 802.3 networks using a variety of media. The two hubs are identical except for the physical connections for ports 1 through 12. The MRXI is eq...
Page 9 - INTRODUCTION
Page 10 - ATTACHING THE CONSOLE; CHAPTER 2; LOCAL MANAGEMENT CONSOLE; Figure 2-1. Management Console Connection
ATTACHING THE CONSOLE Page 2-1 CHAPTER 2 ATTACHING THE CONSOLE This chapter describes information on the characteristics of supported terminals, configuring the management console and connecting the console cabling. 2.1 LOCAL MANAGEMENT CONSOLE MRXI/LM is accessed by attaching a management console a...
Page 13 - Connect the console to the MRXI as follows:
ATTACHING THE CONSOLE Page 2-4 2.2 CONSOLE CABLE CONFIGURATION A single female DB-9 receptacle provides a Console interface to the management terminal. Depending on your specific terminal, one of two cable configurations (9 pin to 25 pin or 9 pin to 9 pin) is used for the connection to the MRXI Cons...
Page 18 - If not already powered on, power on the MRXI.
GETTING STARTED Page 3-3 Figure 3-1. MRXI/LM Screens 3.4 ACCESSING LOCAL MANAGEMENT VIA TERMINAL To use MRXI/LM, the console must be connected as described in Chapter 2, Attaching the Console . To access MRXI/LM: 1. If not already powered on, power on the MRXI. 2. Turn on power to the terminal. Afte...
Page 19 - GETTING STARTED
GETTING STARTED Page 3-4 When you enter the correct password, a MRXI SNMP Local Management Screen is displayed, indicating that MRXI/LM is ready for operation (see Figure 3-3). The menu command MAIN is highlighted. If an incorrect or invalid password is entered, the password prompt remains on the sc...
Page 20 - Figure 3-3. MRXI SNMP Local Management Screen
GETTING STARTED Page 3-5 Figure 3-3. MRXI SNMP Local Management Screen Figure 3-4. Device/Port Information Screen Cabletron Systems Incorporated P.O. Box 5005 Rochester NH 03867-5005 U.S.A. (603) 332-9400 MRXI SNMP LOCAL MANAGEMENT Version X.XX (c) Copyright Cabletron Systems, Inc. 1991 MAIN Device/...
Page 24 - USING THE DEVICE/PORT INFORMATION SCREEN; CHAPTER 4
USING THE DEVICE/PORT INFORMATION SCREEN Page 4-1 CHAPTER 4 USING THE DEVICE/PORT INFORMATION SCREEN This chapter describes local management commands, field entries and statistical information presented on the MRXI/LM Device/Port Information screen. The Device/Port Information screen, shown in Figur...
Page 27 - MODIFIED SCREEN INFORMATION HAS BEEN SAVED!
USING THE DEVICE/PORT INFORMATION SCREEN Page 4-4 NLNK (no link) - indicates that a link has not been established on the currently selected port. N/A (not applicable) - indicates that the currently selected port is not a 10Base-T Twisted Pair or Fiber Optic Link port. Command Menu Selections EXIT - ...
Page 28 - USING COMMUNITY NAMES; CHAPTER 5; Press Return to display the Community Names Screen.
USING COMMUNITY NAMES Page 5-1 CHAPTER 5 USING COMMUNITY NAMES This chapter defines the fields found on the Community Names screen and describes entering and using the community names table. To access the Community Names Screen: 1. Use the arrow keys to highlight COMMUNITY NAMES at the bottom of the...
Page 32 - CHAPTER 6; The number of characters entered exceeds the field length.
MRXI/LM MESSAGES Page 6-1 CHAPTER 6 MRXI/LM MESSAGES This chapter describes messages that can appear at the top of the MRXI/LM terminal display. The following is a list of messages and actions required to resolve the problem: TOO MANY CHARACTERS ENTERED The number of characters entered exceeds the f...
Page 34 - CHANGING THE MRXI/LM PASSWORD; Community Names Screen
CHANGING THE MRXI/LM PASSWORD Use these instructions to change your password or add a new password. Community names defined as Superusers (SU) in the Community Names Table are MRXI/LM passwords. To access the Community Names Table: 1. Use the arrow keys to highlight COMMUNITY NAMES at the bottom of ...