Cabletron Systems 7C03 MMAC - Manual

Page 2 - Notice; NOTICE; © Copyright February 1996 by:; MMAC; is a registered trademark of Cabletron Systems, Inc.; Ethernet; is a trademark of Xerox Corp.; CompuServe; is a registered trademark of CompuServe Inc.

Notice i NOTICE Cabletron Systems reserves the right to make changes in specifications and other information contained in this document without prior notice. The reader should in all cases consult Cabletron Systems to determine whether any such changes have been made. The hardware, firmware, or soft...

Page 3 - FCC NOTICE; This equipment has been tested and found to comply with; DOC NOTICE

Notice ii FCC NOTICE This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOT...

Page 4 - VCCI NOTICE; Read the instructions for correct handling.

Notice iii VCCI NOTICE This equipment is in the 1st Class Category (information equipment to be used in commercial and/or industrial areas) and conforms to the standards set by the Voluntary Control Council for Interference (VCCI) by Information Technology Equipment aimed at preventing radio interfe...

Page 5 - DECLARATION OF CONFORMITY

Notice iv DECLARATION OF CONFORMITY Application of Council Directive(s): 89/336/EEC73/23/EEC Manufacturer ’s Name: Cabletron Systems, Inc. Manufacturer ’s Address: 35 Industrial WayPO Box 5005Rochester, NH 03886-5005 European Representative Name: Mr. J. Solari European Representative Address: Cablet...

Page 6 - CONTENTS; CHAPTER 1 INTRODUCTION

v CONTENTS CHAPTER 1 INTRODUCTION 1.1 USING THIS MANUAL ......................................................................... 1-11.2 USING THE SMARTSWITCH MANUAL SET ................................... 1-11.3 7C03 MMAC SMARTSWITCH OVERVIEW ....................................... 1-2 1.3.1 7X00 S...

Page 7 - C03 MMAC SmartSwitch; USING THIS MANUAL; Introduction; USING THE SMARTSWITCH MANUAL SET; E03-24 Ethernet SmartSwitch Interface Module

1-1 CHAPTER 1 INTRODUCTION Welcome to Cabletron Systems 7C03 MMAC SmartSwitch Installation Guide . This manual is a simple installation and reference guide. The 7C03 MMAC SmartSwitch is a unique self-contained module that can be placed into an MMAC series chassis 1 . 1.1 USING THIS MANUAL Chapter 1,...

Page 8 - C03 MMAC SMARTSWITCH OVERVIEW

1-2 Introduction In addition, any local management information that is specific to a particular SmartSwitch interface module is described in a module specific local management appendix. For example, the 7E03-24 Ethernet SmartSwitch Interface Module Local Management Appendix explains information that...

Page 9 - internally

Introduction 1-3 Figure 1-1. 7C03 MMAC SmartSwitch Because the 7C03 MMAC SmartSwitch does not attach to the data channels on the backplane of an MMAC chassis, data can not be transmitted internally from SmartSwitch interface modules to the other modules in the MMAC chassis. However, data can be tran...

Page 10 - 7X00 SmartSwitch Controller Module; ) is used to collect management data of the

1-4 Introduction 1.3.1 7X00 SmartSwitch Controller Module The 7X00 SmartSwitch Controller Module is the only processing and management element in the 7C03 MMAC SmartSwitch. The 7X00 Module has no front panel data ports. All data enters and exits the 7X00 Module via the SmartSwitch Bus on the 7C03 MM...

Page 12 - By CompuServe

1-6 Introduction 1.4 RELATED MANUALS The following manuals supplement the procedures and other technical data provided in this manual. The procedures will be referenced where appropriate, but will not be repeated. Cabletron Systems SmartSwitch Interface Module User’s Guides (module specific). Cablet...

Page 13 - Remove the 7C03 MMAC SmartSwitch from the shipping box.

2-1 CHAPTER 2 INSTALLATION This chapter contains instructions for unpacking and installing the 7C03 MMAC SmartSwitch in an MMAC chassis. The 7C03 MMAC SmartSwitch can be installed in an MMAC-M5FNB or in an MMAC-M8FNB chassis. Note: Because of the modular nature of the power supplies and interface mo...

Page 14 - Installation; INSTALLING THE 7C03 MMAC SMARTSWITCH

2-2 Installation 2.2 INSTALLING THE 7C03 MMAC SMARTSWITCH Prior to installing the 7C03 MMAC SmartSwitch, please read the note that appears on page 2-1. To install the 7C03 MMAC SmartSwitch in an MMAC-M5FNB or MMAC-M8FNB chassis, use the following steps and refer to Figure 2-1. 1. Remove the blank pa...

Page 15 - Figure 2-1. Installing the 7C03 MMAC SmartSwitch in an MMAC-M8FNB; card

Installation 2-3 Figure 2-1. Installing the 7C03 MMAC SmartSwitch in an MMAC-M8FNB card guide plastic rail

Cabletron Systems 7C03 MMAC - Manual

Table of Contents:

Summary

Other Cabletron Systems Models