Bunn TCD - 1/2 - Manual
Bunn TCD - 1/2 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – SOLE OPTION AS SPECIFIED HEREIN, TO REPAIR, REPLACEMENT OR REFUND.
- Page 3 – INTRODUCTION; must be placed on a sturdy counter or shelf.; PLUMBING REQUIREMENTS; FAUCET UNDER PRESSURE; WARNING; USER NOTICES; PRESSURE REGULATOR ADJUSTMENT; Adjust to 20 psi while faucet
- Page 4 – SET UP AND OPERATING PROCEDURES
- Page 5 – DISPENSER CLEANING AND SANITIZING
- Page 6 – Concentrate Bottle Tube
BUNN-O-MATIC CORPORATION
POST OFFICE BOX 3227
SPRINGFIELD, ILLINOIS 62708-3227
PHONE: (217) 529-6601 FAX: (217) 529-6644
34106.0001S+ 02/12 © 2004 Bunn-O-Matic Corporation
INSTALLATION & OPERATING MANUAL
With ILLUSTRATED PARTS
NOTE: LIFT THE DISPENSER USING THE HANDLES ONLY. DO NOT LIFT THE DISPENSER FROM THE BOTTOM.
TCD-1/2
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 34106.1 092611 BUNN-O-MATIC COMMERCIAL PRODUCT WARRANTY Bunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows: 1) All equipment other than as specified below: 2 years parts and 1 year labor. 2) Electronic circuit and/or control boards: parts and labor for 3 years. 3) Compres...
INTRODUCTION These dispensers are designed to mix liquid tea concentrate with water to produce iced tea by the glass or pitcher. The concentrate can be stored either inside the dispenser, or outside with a hose connection to the dispenser. The dispenser must be placed on a sturdy counter or shelf. 3...
4 1. Remove dispenser from the box and place on a sturdy, level counter. 2. Remove the brass cap and any packing material from the end of the water inlet fitting located on the rear of the dispenser. 3. Attach a 1/4" water line to the inlet fitting. This supply line must have at least 30 psi of ...
