Bunn TB3 Series - Manual
Bunn TB3 Series – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – SOLE OPTION AS SPECIFIED HEREIN, TO REPAIR, REPLACEMENT OR REFUND.
- Page 3 – To reduce the risk of electric shock,; INTRODUCTION; CONTENTS; USER NOTICES
- Page 5 – water supply to this equipment.; PLUMBING REQUIREMENTS; water inlet fitting is
- Page 6 – ADJUSTING BREW VOLUMES; are in place, prior to setting or modifying batch sizes.
- Page 8 – Adjusting Brew Volumes on page 5
- Page 9 – AUTO SWEETENER SET-UP
- Page 10 – CAUTION - The funnel contains hot liquids. Remove funnel slowly.
- Page 11 – CLEANING; CAUTION - CLEAN AND SANITIZE YOUR ICED TEA BREWER DAILY; particles or residue. Reassemble the funnel.; AUTO SWEETENER CLEANING; Remove the connector off of the bag in a box.
TB3 Series
Including: TB3; TB3-LP;
TB3Q; TB3Q-LP
STARTING WITH SERIAL NUMBER: TU000200000
INSTALLATION & OPERATING MANUAL
BUNN-O-MATIC CORPORATION
POST OFFICE BOX 3227
SPRINGFIELD, ILLINOIS 62708-3227
PHONE: (217) 529-6601 FAX: (217) 529-6644
To ensure you have the latest revision of the Operating Manual, or to view the Illustrated Parts
Catalog, Programming Manual, or Service Manual, please visit the Bunn-O-Matic website, at
www.bunn.com. This is absolutely FREE, and the quickest way to obtain the latest catalog and
manual updates. For Technical Service, contact Bunn-O-Matic Corporation at 1-800-286-6070.
41465.0000A 08/08 ©2008 Bunn-O-Matic Corporation
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Page 2 BUNN-O-MATIC COMMERCIAL PRODUCT WARRANTY Bunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows: 1) All equipment other than as specified below: 2 years parts and 1 year labor. 2) Electronic circuit and/or control boards: parts and labor for 3 years. 3) Compressors on re...
Page 3 WARNING ! Fill water tank before turning - on - thermostat or connecting appliance to power source. Use only on a properly protected circuit capable of the rated load. Electrically ground the chassis. Follow national/local electrical codes. Do not use near combustibles. FAILURE TO COMPLY RISK...
Page 5 120V MODELS These brewers must be connected to a cold water system with operating pressure between 20 and 90 psi (138 and 620 kPa) from a ½˝ or larger supply line. A shut-off valve should be installed in the line before the brewer. Install a regulator in the line when pressure is greater than...
