Bunn IC3B - Manual
Bunn IC3B – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – INTRODUCTION; USER NOTICES; WARNING; thermostat or connecting appliance; To reduce the risk of electric shock,; FOR USE ONLY ON AN
- Page 4 – CE REQUIREMENTS; • Appliance shall not be tilted more than 10° for safe operation.; ELECTRICAL REQUIREMENTS
- Page 5 – PLUMBING REQUIREMENTS; water inlet fitting is
- Page 6 – Adjusting Brew Volumes.
- Page 7 – CAUTION - Clean and sanitize your iced coffee brewer daily
- Page 8 – CAUTION - The funnel contains hot liquids. Remove funnel slowly.
- Page 9 – SCHEMATIC WIRING DIAGRAM IC3; SINGLE PHASE; SCHEMATIC WIRING DIAGRAM IC3B
IC3 & IC3B
ON
HA
LF
OFF
FU
LL
STA
RT
RE
AD
Y
ON
HA
LF
OFF
FU
LL
STA
RT
RE
AD
Y
INSTALLATION & OPERATING GUIDE
BUNN-O-MATIC CORPORATION
POST OFFICE BOX 3227
SPRINGFIELD, ILLINOIS 62708-3227
PHONE: (217) 529-6601 FAX: (217) 529-6644
To ensure you have the latest revision of the Operating Manual, or to view the Illustrated Parts
Catalog, Programming Manual, or Service Manual, please visit the Bunn-O-Matic website, at
www.bunn.com. This is absolutely FREE, and the quickest way to obtain the latest catalog and
manual updates. For Technical Service, contact Bunn-O-Matic Corporation at 1-800-286-6070.
10792.0000F 11/12 ©1994 Bunn-O-Matic Corporation
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Page 3 INTRODUCTION This equipment will brew a batch of fresh coffee into an awaiting vessel and dispense at approximately room tempera- ture to conserve ice. The brewer is only for indoor use on a sturdy counter or shelf and requires a minimum of 33 inches of clearance above the counter. USER NOTIC...
Page 4 Electrical Hook-Up CAUTION – Improper electrical installation will damage electronic components. 1. An electrician must provide electrical service as specified. 2. Remove the top lid and rotate the control thermostat knob fully counterclockwise to the “OFF” position and reinstall the top lid....
Page 5 PLUMBING REQUIREMENTS This brewer must be connected to a cold water system with operating pressure between 30 (207 kPa) and 90 psi (620 kPa) from a 1 ⁄ 2 " or larger supply line. A shut-off valve should be installed in the line before the brewer. Install a regulator in the line when press...
