Bunn HC-2 - Manual
Bunn HC-2 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – ELECTRICAL REQUIREMENTS; Refer to the dispenser’s dataplate for exact voltage requirement.)
- Page 4 – PLUMBING REQUIREMENTS; from a
- Page 5 – DISPENSER USE; NOTE - The mixing chamber must drain at the end of each dispense.; CLEANING
BUNN
®
HC-1
HC-2
HC-3
OPERATING & SERVICE MANUAL
BUNN-O-MATIC CORPORATION
POST OFFICE BOX 3227
SPRINGFIELD, ILLINOIS 62708-3227
PHONE: (217) 529-6601 FAX: (217) 529-6644
26530.0000 6/00 ©1995 Bunn-O-Matic Corporation
DISCONTINUED VERSION
The information in this manual
is no longer current.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
3 00656.0000 12368.0001 00831.0000 INITIAL SET-UP 1. Locate the drip tray assembly beneath the dispenser nested in the packing material. 2. Remove the cup locator plate from the drip tray and the drip tray cover and set them aside. 3. Remove the water strainer assembly from the drip tray and set it ...
4 PLUMBING REQUIREMENTS This dispenser must be connected to a COLD WATER system with operating pressure between 20 and 90 psi from a 1 ⁄ 2 " or larger supply line. A shut-off valve should be installed in the line before the dispenser. Install a regulator in the line when pressure is greater than...
5 DISPENSER USE 1. Simply place a cup on the drip tray in front of the desired dispensing button. 2. Press the button to whip and dispense the beverage. 3. Release the button when the cup is approximately 2 / 3 full and allow the mixing chamber to drain. NOTE - The mixing chamber must drain at the e...
