Bunn H5M - Manual
Bunn H5M – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – workmanship for two years from the date of installation.
- Page 4 – ELECTRICAL REQUIREMENTS; CAUTION; PLUMBING REQUIREMENTS; COLD WATER
- Page 5 – when specified in the instructions.; DRAINING THE DISPENSER
- Page 6 – TROUBLESHOOTING; WARNING
- Page 8 – Water boils continuously.; CAUTION –
- Page 9 – SERVICE; This section provides procedures for testing and; Component Access; Disconnect the dispenser from the power; WARNING –; Inspection, testing, and repair of electrical
- Page 12 – Solenoid Valve
- Page 14 – FIG. 10 THERMOSTAT WIRING; BLU/BLK to Limit Thermostat; Thermostat
- Page 15 – Liquid Level Board; wire from terminal 4 of the circuit board.
- Page 17 – Contactor
- Page 18 – RED from Main Harness; FIG.14 CONTACTOR WIRING
- Page 19 – WIRING DIAGRAMS
H5M
10267.0000D 7/00 © 1988 BUNN-O-MATIC CORPORATION
BUNN-O-MATIC CORPORATION
POST OFFICE BOX 3227
SPRINGFIELD, ILLINOIS 62708-3227
PHONE: (217) 529-6601 FAX: (217) 529-6644
BUNN
®
OPERATING & SERVICE MANUAL
WARNING
Very Hot Water
Use With Care!
!
DISCONNECT FROM POWER SOURCE
BEFORE REMOVAL OF ANY PANEL OR
REPLACEMENT OF ANY COMPONENT!
W
AR
NIN
G
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 CONTENTS Introduction ................................................. 2Warranty ...................................................... 2User Notices ................................................ 3Electrical Requirements ............................... 4Plumbing Requirements .....................
4 ELECTRICAL REQUIREMENTS CAUTION - The dispenser must be disconnected from the power source until specified in Initial Set-Up. The H5M dispenser requires 2-wire, grounded service rated 120, 208, or 240 volts ac, 20 amp, single phase.The H5MA, 230V-CE dispenser requires 2-wire, grounded service rate...
5 INITIAL SET-UP CAUTION - The dispenser must be disconnected from the power source throughout the initial set-up, except when specified in the instructions. 1. Remove the upper rear panel and rotate the control thermostatknob fully counterclockwise to the “OFF” position and replacethe panel. 2. Con...