Bunn H5E-DV PC - Manual
Bunn H5E-DV PC – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – INTRODUCTION; The agents, dealers or employees of BUNN
- Page 4 – ELECTRICAL REQUIREMENTS; CAUTION –; Improper electrical installation will damage electronic com-; single phase models; Note: This electrical service
- Page 5 – PLUMBING REQUIREMENTS; This dispenser must be connected to a; COLD WATER; system with operating pressure between 20 and 90 psi; PLUMBING HOOK UP
- Page 6 – DRAINING THE DISPENSER
- Page 7 – OPERATING CONTROLS
- Page 9 – ADJUSTING DISPENSE VOLUMES
- Page 10 – WIRING DIAGRAMS; SCHEMATIC WIRING DIAGRAM; SINGLE PHASE
BUNN-O-MATIC CORPORATION
POST OFFICE BOX 3227
SPRINGFIELD, ILLINOIS 62708-3227
PHONE: (217) 529-6601 FAX: (217) 529-6644
To obtain the Illustrated Parts Catalog, visit the Bunn-O-Matic website, at www.bunn.com. This is absolutely FREE,
and the quickest way to obtain the catalog. Contact Bunn-O-Matic Corproation at 1-800-286-6070 to obtain a paper
copy of the required Illustrated Parts Catalog mailed via U.S. Postal Service.
39338.0000B 11/06 ©2006 BUNN-O-MATIC CORPORATION
www.bunn.com
H5E-DV PC
INSTALLATION & OPERATING MANUAL
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 INTRODUCTION This equipment heats and dispenses water on demand for beverages and cooking purposes. It has a panel above the dispense valve that indicates the status of the dispenser. This equipment is for indoor use, either wall-mounted or on a sturdy counter or shelf. BUNN-O-MATIC COMMERCIAL PRO...
4 ELECTRICAL REQUIREMENTS WARNING - The dispenser must be disconnected from the power source until specifi ed in Initial Set-Up. Refer to Data Plate on the Brewer, and local/national electrical codes to determine circuit requirements. Electrical Hook-Up CAUTION – Improper electrical installation wil...
5 PLUMBING REQUIREMENTS This dispenser must be connected to a COLD WATER system with operating pressure between 20 and 90 psi (138 and 620 kPa) from a 1 ⁄ 2 " or larger supply line. A shut-off valve should be installed in the line before the dis- penser. Install a regulator in the line when pres...
