Bunn DV - Manual

Bunn DV

Bunn DV – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
Page: / 25

Table of Contents:

  • Page 3 – CONTENTS
  • Page 4 – TROUBLESHOOTING
  • Page 7 – Faceplate Removal - H5 ELEMENT: After removing; SERVICE; Component Access - H10X
  • Page 8 – Triac Assy
  • Page 11 – PROGRAMMING in the Operating Manual.
  • Page 12 – Limit Thermostat; BLK to Terminal Block
  • Page 13 – Safety Overflow Switch; RED to BLK Wire from; NOTE - The magnets must be at the top of the float and
  • Page 14 – WHI/BLU to Electronic
  • Page 15 – W H I / B L U t o C o n t o l
  • Page 16 – Tank Heater; BLK to Limit
  • Page 18 – Flare nut
  • Page 19 – RELAY; NOTE: no jumper used on any; MAIN; Black Ink; SINGLE PHASE; CORPORATION; SCHEMATIC WIRING DIAGRAM H5E-DV PC; MEMBRANE SWITCH ASSY
  • Page 20 – SCHEMATIC WIRING DIAGRAM H5E-PC
  • Page 21 – SCHEMATIC WIRING DIAGRAM
  • Page 22 – SCHEMATIC WIRING DIAGRAM H10X
  • Page 23 – or; SCHEMATIC WIRING DIAGRAM H5E/H5X
  • Page 25 – DISPLAY
Loading the manual

H10X/H5X

H5E/DV PC

H5 ELEMENT

With Digital Control Board

SERVICE MANUAL

BUNN-O-MATIC CORPORATION

POST OFFICE BOX 3227

SPRINGFIELD, ILLINOIS 62708-3227

PHONE: (217) 529-6601 FAX: (217) 529-6644

To ensure you have the latest revision of the manual or to obtain the illustrated parts catalog, please visit

the Bunn-O-Matic website, at www.bunn.com. This is absolutely FREE, and the quickest way to obtain

the latest catalog and manual updates. Contact Bunn-O-Matic Corporation at 1-800-286-6070 to obtain

a paper copy of the required Illustrated Parts Catalog mailed via U.S. Postal Service.

42311.0000E 09/13 © 2011 BUNN-O-MATIC CORPORATION

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 3 - CONTENTS

3 WARNING - Inspection, testing, and repair of electrical equipment should be performed only by qualified service personnel. Disconnect the dispenser fromthe power source when servicing, except when electrical tests are required and the test procedure specifically states to connect the dispenser to ...

Page 4 - TROUBLESHOOTING

4 TROUBLESHOOTING A troubleshooting guide is provided to suggest probable causes and remedies for the most likely problems encountered. If the problem remains after exhausting the troubleshooting steps, contact the Bunn-O-Matic Technical Service Department. • Inspection, testing, and repair of elect...

Page 7 - Faceplate Removal - H5 ELEMENT: After removing; SERVICE; Component Access - H10X

7 Faceplate Removal - H5 ELEMENT: After removing top cover, remove the two upper screws securing the faceplate. Carefully lift faceplate straight up until the three lower screws clear the key holes. The check valve, electronic control assembly, safety overflow switch, solenoid valve, overflow tube t...

Other Bunn Models

All Bunn Other