Page 4 - Commercial Snowblower; WARRANTY POLICY; Any labor subject to warranty; must; be authorized by Buhler Manufacturing. The labor rate for; GOVERNMENT LEGISLATION:; This warranty does not apply to rentals
Commercial Snowblower 1 WARRANTY POLICY Buhler Manufacturing products are warranted for a period of twelve (12) months (90 days for commercial application) from original date of purchase, by original purchaser, to be free from defects in material and workmanship under correct, normal agricultural us...
Page 6 - SNOWBLOWERS; Drive
Commercial Snowblower SNOWBLOWERS This manual is for both Commercial Hydraulic Snowblowers and Commercial PTO Drive Snowblowers. The hydraulic models come in 60”, 66”, 74” and 84” widths. The PTO drive model is only available in an 84” width. Hydraulic models come with four different motor series. H...
Page 7 - SAFETY SIGNS; Replace safety signs
Commercial Snowblower SAFETY SIGNS #1 #3 #3 Replace safety signs immediately should they become damaged, torn or illegible. Obtain replacements from your authorized dealer using the part numbers shown. #4 4
Page 8 - OPERATING INSTRUCTIONS; slightly tilted back when resting on the ground.; CAUTION
Commercial Snowblower OPERATING INSTRUCTIONS 1. HYDRAULIC DRIVE: All snowblower hydraulic blocks are set at the factory for a 2800 - 3000 psi system. Refer to the section on the hydraulic control block if your system does not fall into this range. 2. ALL: Depth of the cut can be partially controlled...
Page 10 - HYDRAULIC CONTROL BLOCK; For 2100 psi turn the screw in 3 1⁄2 turns.
Commercial Snowblower 7 HYDRAULIC CONTROL BLOCK NON-STALLING-FAN FEATURE: The Hydraulic Snowblower has a unique modulating element that keeps the blower fan from stalling in an overloaded condition. This is accomplished by starving the hydraulic flow to the front auger motor (which then stops feedin...
Page 12 - ASSEMBLY INSTRUCTIONS
Commercial Snowblower 9 ASSEMBLY INSTRUCTIONS 1. SPOUT ASSEMBLY FOR ALL SNOWBLOWERS: Remove two of the grooved spout rollers to mount the discharge spout. Replace the two rollers to hold spout in place. Install the 2 ½” x 8” cylinder on the spout using the pins supplied. 2. HYDRAULIC DRIVE: (Page 21...
Page 13 - ASSEMBLY INSTRUCTIONS – cont’d.
Commercial Snowblower ASSEMBLY INSTRUCTIONS – cont’d. b) Using tape or a bright colored marking pen, mark on the outer shields the position where the shaft is completely pushed together and the position where you have a 4” overlap. Watch these marks when moving the blower through all possible operat...
Page 14 - PTO SHIELD: All PTO snowblowers are supplied with a PTO shield; CAUTION:; Do not run the snowblower without this shield in place.
Commercial Snowblower ASSEMBLY INSTRUCTIONS – cont’d. 4. PTO SHIELD: All PTO snowblowers are supplied with a PTO shield (#18). To install, remove the two rear bolts at the top of the gearbox (#34). Bolt the PTO shield to the gearbox by the hinges using these same bolts. A utility spring (#68) keeps ...
Page 15 - HYDRAULIC COMMERCIAL SERIES SNOWBLOWER – 22” HOUSING
Commercial Snowblower HYDRAULIC COMMERCIAL SERIES SNOWBLOWER – 22” HOUSING 12
Page 20 - HYDRAULIC COMMERCIAL SERIES SNOWBLOWER – 24” HOUSING
Commercial Snowblower HYDRAULIC COMMERCIAL SERIES SNOWBLOWER – 24” HOUSING 17
Page 22 - Description
Commercial Snowblower 19 Hyd Commercial Series Snowblower - 24'' Housing Item # Part # Description 1 905540 Main Body Weldt - 84'' 905538 Main Body Weldt - 74'' 2 905225 Fan Weldt - 24'' 3 905202 Auger Weldt - 84'' 905206 Auger Weldt - 74'' 4 905550 Spout Weldt 5 965912 40 Tooth Sprocket #60, 1 3/8'...
Page 24 - SNOWBLOWER ASSEMBLY
Page 25 - HYD COMMERCIAL SERIES SNOWBLOWER ASSEMBLY; Wiring Harness - Tractor Half
Commercial Snowblower 22 HYD COMMERCIAL SERIES SNOWBLOWER ASSEMBLY Item # Part # Description 1 907412 Wiring Harness - Tractor Half 2 890082 1 1/16 SWFJIC x 1 1/16 MJIC Elbow 90 3 JDF19M7866 HFL Bolt M8 x 20 (10.9) (pl) 4 905669 Hyd Manifold Assembly 5 905623 Series #1 Motor - 2 Holes (Already Assem...
Page 26 - PTO COMMERCIAL SERIES SNOWBLOWER – 24 “ HOUSING
Commercial Snowblower PTO COMMERCIAL SERIES SNOWBLOWER – 24 “ HOUSING 23
Page 31 - 1⁄2” x 8” CYLINDER ASSEMBLY; Weldment
Commercial Snowblower 2 ½” x 8” CYLINDER ASSEMBLY 2 1/2'' x 8'' CYLINDER ASSEMBLY Item # Part # Description 1 24982 Tube Weldment 2 108655 Shaft 1.25 dia x 15.54 Lg 3 23156 2.50 Dia Headplate 4 13109 2.50 Dia Piston 5 13090 Piston Rod Clevis (Cast) 6 82330 2.50 OD x e Sect O-Ring 7 83330 2.50 OD x o...
Page 32 - PTO DRIVE COMMERCIAL SNOWBLOWER
Commercial Snowblower PTO DRIVE COMMERCIAL SNOWBLOWER PTO DRIVE COMMERCIAL SNOWBLOWER Item # Part # Description BU50505 Gearbox Complete 1 BU50310 Gearbox Casting Only 2 BU500089-3 Pipe Plug 3 BU50457 Gearbox Cover 4 BU500167-1 Relief Valve 5 BU50458 Gearbox Gasket 6 BU50507 Cross Shaft 7 BU50502 Pi...
Page 33 - SPECIFICATIONS; Series II
Commercial Snowblower 30 SPECIFICATIONS MODEL B6022HSB-1 B6022HSB-2 B6022HSB-3 B6622HSB-1 B6622HSB-2 B6622HSB-3 B7422HSB-1 B7422HSB-2 B7422HSB-3 B7422HSB-4 B7424HSB-3 B7424HSB-4 B8424HSB-2 B8424HSB-3 B84SB (PTO Drive) Cutting Width 60" 66” 74" 74" 84" 84" Cutting Height 28” 30” 3...
Page 34 - HYDRAULIC SNOWBLOWER WIRING SCHEMATIC X2572; Category Motor; spout motor
Commercial Snowblower HYDRAULIC SNOWBLOWER WIRING SCHEMATIC X2572 HYDRAULIC SNOWBLOWER MOTOR REQUIREMENT CHART Category Motor GPM Motor HP @ HP @ Shaft Type Eaton Motor Buhler Cu/in/rev RPM 2000 3000 psi Flange Mtg. Part #'s Part # 12 447 12 18 1.25" Straight 1 1/16-12 ORB Group #1 6.2 16 596 16...
Page 35 - TROUBLESHOOTING
Commercial Snowblower 32 TROUBLESHOOTING SYMPTOM PROBABLE CAUSE REMEDY D1 Nothing Works Hydraulic Circuit Not Complete 1. Hydraulic Valve not engaged 1. Engage valve to full detent 2. 1 or more quick couplers not 2. Fully engage all couplers completely engaged. 3. Defective quick coupler 3. Replace ...
Page 38 - NOTES
Page 40 - Buhler Manufacturing; a partnership”
Buhler Manufacturing “ a partnership” 301 Mountain Street S. Morden MB. R6M 1X7 Ph.: (204) 822- 4467 Fax: (204) 822 -6348 www.buhler.com Printed in Canada Farm King Division 301 Mountain Street S. Morden, MB R6M 1X7 Ph.: (204) 822-4467 Fax: (204) 822- 6348 Allied Division 1201 Regent Ave. W. Box 100...