Page 2 - DANGER; IMPORTANT SAFETY; WARNINGS; Shut off gas to the appliance at the LP cylinder and burners.; WARNING
1 WE WANT YOU TO ASSEMBLE AND USE YOUR GRILL AS SAFELY AS POSSIBLE. THE PURPOSE OF THIS SAFETY ALERT SYMBOL IS TO ATTRACT YOUR ATTENTION TO POSSIBLE HAZARDS AS YOU ASSEMBLE AND USE YOUR GRILL. WHEN YOU SEE THE SAFETY ALERT SYMBOL PAY CLOSE ATTENTION TO THE INFORMATION WHICH FOLLOWS! READ ALL SAFETY ...
Page 3 - TABLE OF CONTENTS
2 General Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Installation and LP Cylinder Specifications and Safe Use. . . . . . . . . . . . . . 4–6 Connecting LP Cylinder and Hose / Regulator to Grill . . . . . . . . . . . . . . . . 6–7 Leak Testi...
Page 4 - USE CAUTION AND COMMON SENSE WHEN OPERATING YOUR GAS GRILL.; GENERAL WARNINGS
3 WARNING • Never use natural gas in a unit designed for liquid propane gas. • Never use charcoal briquets or lighter fluid in a gas grill. • Leak test all connections before first use, even if grill was purchased fully assembled and aftereach tank refill. • Never check for leaks using a match or op...
Page 5 - LP GAS CYLINDER; DO NOT connect to a propane cylinder exceeding this capacity.; INSTALLATION INFORMATION:
4 WARNING WARNING LP GAS CYLINDER (NOT SUPPLIED WITH THIS GRILL) The LP cylinder is available for purchase at the same location the grill was purchased. The LP (Liquid Propane) gas cylinder specifically designed to be used with this grill must havea 20 lb. (9.1 kg) capacity incorporating a Type 1 cy...
Page 6 - CYLINDER SPECIFICATIONS:
5 The cylinder must also be equipped with: • A shut-off valve terminating in a Type 1 gas cylinder valve outlet. • A Type 1 valve that prevents gas flow until a positive seal is obtained. • An arrangement for vapor withdrawal. • A collar to protect the cylinder shut-off valve. • A safety relief devi...
Page 7 - REGULATOR RESETTING PROCEDURE
FILLING THE LP GAS CYLINDER: • Allow only qualified LP gas dealers to properly fill or repair your LP gas cylinder. • New tanks should be purged prior to filling; inform LP gas dealer if you are using a new tank. • DO NOT allow the cylinder to be filled beyond 80% capacity. Over-filled tanks can cre...
Page 8 - CONNECTING HOSE AND REGULATOR TO AN LP GAS CYLINDER; Ensure the tank valve is; CONNECTING HOSE AND REGULATOR
7 WARNING • Never use your grill without leak testing all gas connections and hoses. See the section on"Leak Testing" in this manual for proper procedures. The pressure regulator and hose assembly supplied with your gas grill must be used. • DO NOT attempt to connect it to any other fuel sup...
Page 9 - WHEN TO PERFORM A LEAK TEST:; Any time your grill has been moved.
LEAK TESTING: To prevent fire or explosion hazard: • DO NOT smoke or permit ignition sources in the area while conducting a leak test. • Perform test OUTDOORS only in a well ventilated area. • Never perform a leak test with a match or open flame. • Never perform a leak test while the grill is in use...
Page 10 - CAUTION
WARNING 9 6. Check each place listed (A – K) for growing bubbles which indicates a leak. 7. Turn off gas supply at cylinder valve. 8. Turn on control knobs to release gas pressure in hose. 9. Turn control knobs to "OFF" position. 10. Tighten any leaking connections. 11. Repeat soapy water te...
Page 11 - LIGHTING INSTRUCTIONS:; Follow the instructions exactly.; LIGHTING THE MAIN BURNERS:; FAR LEFT
LIGHTING INSTRUCTIONS: Follow the instructions exactly. 1. OPEN THE GRILL LID before attempting to light a burner so that fumes do not accumulate inside the grill. An explosion could occur if grill lid is down. 2. Check that all burner control knobs and the cylinder valve are turned to the "OFF&...
Page 12 - DO NOT; TURNING OFF THE GRILL:
LIGHTING THE SIDE BURNER: 1. Open lid before lighting side burner. 2. Make sure control knob is in the "OFF" position. 3. Push and turn side burner control knob to the "HIGH" position. 4. Press the electronic igniter on the main control panel and hold for 3 – 5 seconds to light burne...
Page 13 - DO NOT leave your grill unattended while in use.
12 OPERATING THE GRILL: Never use Charcoal or Lighter Fluid inside your Gas Grill. Read and follow all warnings andinstructions contained in the preceding sections of this manual. BREAKING IN YOUR GRILL: • In manufacturing and preserving the components of your grill, oil residue may be present on th...
Page 14 - In Canada: the Canadian Electrical Code – CSA C22.1; USING OTHER FEATURES OF THE GRILL:; Read instructions on lighting your grill to light the side burner.
ROTISSERIE COOKING: • Your grill was pre-drilled from factory to include mounting holes for a rotisserie (sold separately). Donot use a rotisserie not specifically manufactured for this grill. • Read and follow all instructions provided with the rotisserie. Save instructions for future reference. • ...
Page 15 - GRILL COOKING TIPS; CLEANLINESS; minimum; HELPFUL HINTS; PROPER CARE & MAINTENANCE
14 GRILL COOKING TIPS CLEANLINESS • Always wash hands thoroughly with soap and hot water prior to handling food and after handling rawmeat, uncooked poultry or seafood. • When using a platter to carry raw meat, uncooked poultry or seafood to the grill, make sure to wash theplatter thoroughly with so...
Page 16 - BURNER ASSEMBLY/MAINTENANCE; DO NOT obstruct the flow of combustion and ventilation air.; CLEANING AND MAINTENANCE:; PROPER BURNER OPERATION
BURNER ASSEMBLY/MAINTENANCE • Although your burners are constructed of cast iron, they may rust as a result of the extreme heat andacids from cooking foods. Regularly inspect the burners for cracks, abnormal holes, and other signs ofcorrosion damage. If found, replace the burner. • DO NOT obstruct t...
Page 17 - TRANSPORTING AND STORAGE:; DO NOT extinguish grease fires using water.; BEFORE STORING YOUR GRILL:; COOKING GRILLS
16 TRANSPORTING AND STORAGE: • Never move a grill when it is hot or when objects are on the cooking surfaces. • Make sure that cylinder valve is shut off. After moving the grill check that all gas connectionsare free of leaks. Refer to instructions for Leak Testing. • DO NOT store a spare LP gas cyl...
Page 18 - TROUBLE SHOOTING; Burner will not light
17 TROUBLE SHOOTING Problem: Possible Causes: 1. Check LP cylinder fuel level.2. Bad electrode spark. Check to see if the grill will match light.Electrode or collector may need adjustment. 3. Burner may not be properly seated.4. Burner may be obstructed.5. The cylinder valve may be closed.6. Regulat...
Page 19 - FREQUENTLY ASKED QUESTIONS
18 Your grill's serial number and model number, and the contact information for Brinkmann Customer Service, arelisted on a silver label found on the back of the grill or on the grill body side, under the side shelf. These questions and answers are for your general knowledge, and may not be applicabl...
Page 20 - Cleaning Stainless Steel Cooking Grills:; Cleaning Heat Distribution Plate:
Cleaning Stainless Steel Cooking Grills: Wash grills with a mild detergent and rinse with hot water before initial use and as needed. DO NOT use a commercial oven cleaner. For stubborn food residue, use adegreaser and fiber or brass cleaning brush. Cleaning Porcelain-Finished Cast-Iron Cooking Grill...
Page 21 - PARTS BAG CONTENTS; PARTS LIST
20 2 M8 X 15mm bolts 2 M8 X 15mm shoulder bolts 6 M6 X 12mm bolts 1 AA /1.5V Alkaline battery 2 Large Star Washers 6 Small Star Washers PARTS BAG CONTENTS Make sure you have all items listed under PARTS LIST and PARTS BAG CONTENTS before you begin the installation process. Your Parts Bag will includ...
Page 22 - ASSEMBLY INSTRUCTIONS; READ ALL SAFETY WARNINGS & ASSEMBLY INSTRUCTIONS CAREFULLY; Flathead Screwdriver
ASSEMBLY INSTRUCTIONS READ ALL SAFETY WARNINGS & ASSEMBLY INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING OR OPERATING YOUR GRILL. WE RECOMMEND TWO PEOPLE WORK TOGETHER WHEN ASSEMBLING THIS UNIT. The following provided tools are required to assemble this Brinkmann Pro Series 2210 Grill: • Flathead Scre...
Page 29 - Warning: Never use your grill
28 Step 13 Attach the hose heat shield to theright side of the cart frame usingtwo #8 self-tapping screws. Step 14 Remove two bolts and washersfrom the side burner valve. Insertthe side burner valve assemblythrough the hole in the side burnertable base, then firmly seat thevalve nozzle into the burn...
Page 32 - WARRANTY
140-2210-09/03, 10/04, 4/05 Owner’s Manual for Model 810-2210-0 The Brinkmann Corporation warrants to the original purchaser that the Brinkmann ProSeries™ 2210 is free from defectsdue to workmanship or materials for: Die cast parts - LifetimeElectronic ignition and burners - 1 YearRemaining parts - ...
