Braun FMVSS NO. 403 - Manual
Braun FMVSS NO. 403 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Secure Lift; WAR
- Page 3 – Electrical, Hydraulic and Interlock; Pump; Figure K; Chassis; Figure L; Figure N; Power Cable; Figure M
- Page 4 – DOT — Public Use Lift
- Page 5 – Lift Operating Instructions; Lift Operating Instructions; WARNING; • Wheelchair brakes
- Page 6 – Follow all Lift; Cable-Activated Platform Manual Release System; Manual Operating Instructions; platform locks
- Page 7 – Cycles; Maintenance and Lubrication; ed by an; Lubrication Diagram
- Page 8 – Adjustments and Calibration; Adjustment Procedures
Braun Corporation FMVSS No. 403 Quick Reference Installation Sheet 32553 Rev. A
WAR
NIN
G
8182
3
Pus
h T-ha
ndl
e in
fully
and
man
ually
mov
e p
latfo
rm
in
and
out t
o en
gag
e pla
tfo
rm
lock
befor
e d
rivin
g ve
hicle
.
Failu
re
to lo
ck
platf
orm
may
resu
lt in
unin
tend
ed
platf
orm
dep
loym
ent.
Un
inte
nde
d
pla
tfor
m
depl
oym
ent
ma
y
resu
lt in
seri
ous
bod
ily
injur
y
and/
or
pro
pert
y da
mag
e.
Do n
ot re
mov
e!
DOOR
OPE
NING
90
CENTER IN
DOOR OPENING
CENTER
ACROSS
VEHICLE
FRAME
L
C
22-3/8"
22-3/8"
44-3/
4"
1
“DOT — Public Use Lift”
NHTSA Vehicle Physical Requirements
Alternative
fl
oor structures are allowed
providing the installed lift system pass-
es all FMVSS 403 requirements.
Figure A
VEHI
CLE
CHASSIS MEMB
ER
16
”
Maximum
VEHICLE
CHASSI
S MEMB
ER
All-thread
Mounting
Brackets
Mounting Bracket Requirements:
A maximum distance of 16
"
from the
outermost mounting bracket to the
end of the cassette.
All four mounting brackets must be
connected to the framerails.
Vehicle Requirements:
All vehicles with a GVW over 6000 lbs.
and with unmodi
fi
ed OEM framerails.
Clear Door Opening Width
Maximum Floor-to-Ground
B
A
C
Figure B
Door Opening Dimensions
Vehicle lift access door opening
must meet speci
fi
ed dimensions.
Minimum Clear Door
Opening Height
A
B
C
855
NA
43-1/2"
50"
“DOT - Public Use Lift” veri
fi
es this platform lift
meets the “public use lift” requirements of FMVSS
No. 403. This lift may be installed on all vehicles
appropriate for the size and weight of the lift, but
must be installed on buses, school buses, and
multi-purpose passenger vehicles other than
motor homes with a gross vehicle weight rating
(GVWR) that exceeds 4,536 kg (10,000 lb).
All-Thread
Mounting
Brackets
Engage Platform Manual
Release System:
The lift
cable-activated platform
manual release is disengaged
during shipment to prevent
potential drive chain stretch.
Handle the lift with care.
En-
gage manual release before
attempting to
install
(raise, tilt
or move) the
lift
.
WARNING
Engage manual
release before
attempting to install
(raise, tilt or move)
lift
.
Failure to do so
may result in serious
bodily injury and/or
property damage.
Figure C
Locate Lift Mounting Brackets
Locate All-Thread Mounting
Brackets
1. Open both doors to 90°.
2. Locate center of door opening
(between doors). Mark the
center point.
3. Transfer center point to the
vehicle frame. Using a front-
to-rear framing member as a
guide, transfer the center point
across chassis to opposite side
front-to-rear framing member
(must be 90° to door opening).
Lift mounting bracket positions
are based on this center line.
4. Measure 22-3/8" to left and
right of the center line to
achieve the 44-3/4" center-to-
center spacing of all-thread
mounting studs.
5. Clamp the mounting brackets
securely in place (all-thread
studs must be vertical
).
Braun Corporation FMVSS No. 403
Rev: A
Quick Reference Installation Sheet 32253
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Braun Corporation FMVSS No. 403 Quick Reference Installation Sheet 32553 Rev. A VEHICLE BO X FRAME VEHICLE CHASSI S MEMBER 2 Secure Lift Attach Mounting Brackets to Vehicle Frame Mounting bolts must be routed horizontally through the verti-cal face of the “L” brackets and framing members as shown in...
Braun Corporation FMVSS No. 403 Quick Reference Installation Sheet 32553 Rev. A 3 Electrical, Hydraulic and Interlock Pump Mounting Bracket Min. 1-3/4” to Wa ll Pump must face Out Mount Pump Vertical 1/4-20 x 3/8" Hex Screws Lock Washer Reinforcement “L” Bracket Cable-activated Manual Release (f...
Braun Corporation FMVSS No. 403 Quick Reference Installation Sheet 32553 Rev. A JKA Thresho ld Sen sor Mat UN FO LD FO LD DO WN UP 4 Floor Level and Inner Roll Stop Adjustments Achieving proper fl oor level positioning of the platform and inner roll stop requires a combina-tion of Floor Level switch...
